Surface morphologies of anthracene single crystals grown from vapor phase

The morphologies and lattice structures of anthracene single crystals grown from the vapor phase were investigated using optical microscopy, phase contrast microscopy, atomic force microscopy (AFM), and X-ray diffraction analysis. Common morphologies with hexagonal large planes were observed irrespective of crystal size. The observation of certain surface morphologies with a phase contrast microscopy revealed that the spiral steps originated from screw dislocations present on the (0 0 1) planes. Moreover, the center and edge of the (0 0 1) planes had large curvatures, similar to hills. Resultantly, quarter-monolayer (ML) steps were observed on the large and flat planes between both hills.     

小角X射线散射表征AOT/水层状溶致液晶的有序性

用小角X射线散射研究了AOT/水层状溶致液晶的有序性. 通过对散射曲线的解析, 讨论了表面活性剂浓度、温度和助表面活性剂等三个方面对溶致液晶层状相结构有序性的影响. 在一定的范围内, 提高温度, 改变表面活性剂浓度和加入少量助表面活性剂可使碳氢链排列由稀疏转变为密实, 层状相也相应地由“柔性双层”过渡到更加有序化的“平面双层”. 基于形状因子和体系内分子间作用力, 提出了层状相形成与有序化的机理, 同时采用分子模拟的方法展现了不同浓度下的液晶结构.     

Magnetic resonance study on lamellar phases of ammonium perfluorooctanoate

The aggregation properties of ammonium perfluorooctanoate (NH₄-PFO) in concentrated aqueous phases have been investigated by magnetic resonance techniques and have been compared with the aggregation properties in dilute solutions. Magnetic resonance methods indicated that NH₄-PFO—water systems with surfactant concentrations below 45% (w/w) behaved as isotropic purely micellar solutions in the temperature range 285–340 K. For higher concentrations the system exhibited a rather complex structure, having both isotropic and anisotropic components. The nematic nature of the anisotropic fraction was demonstrated by ¹⁹F NMR studies. The ¹⁹F NMR and EPR of nitroxides (TempTMA⁺, 5- and 16-DXSA) inserted as paramagnetic probes into the concentrated NH₄-PFO—water systems allowed us to establish that the lamellar phase could be mechanically oriented between quartz slides. The EPR investigation also gave details concerning the dynamics of both the oriented and non-oriented structures.     

溶致液晶中金属纳米粒子的掺杂及其作用机制研究

在用琥珀酸二异辛酯磺酸钠(AOT)构建的具有长程有序结构的层状溶致液晶内, 用不同方式导入预制的亲油或亲水贵金属纳米粒子, 可得到纳米粒子分布在不同介观空间内的无机/有机杂合体. 依据小角X射线散射和偏光显微镜结果, 通过分析掺杂纳米粒子与液晶模板的相互作用, 对掺杂前后体系结构的变化及制得杂合体的稳定性进行了表征. 结果表明, 除考虑掺杂粒子与层状模板空间的匹配外, 体系中静电斥力、范德华引力和Helfrich涨落力之间的平衡是维持液晶结构稳定的基本条件.     

直链醇链长对层状液晶结构与稳定性的影响

作为助表面活性剂,直链醇在层状溶致液晶的制备中是非常重要的。本文以层状液晶的相行为和小角度X射线衍射测量,研究了直链醇链长对层状液晶结构与稳定的影响。     

Equations describing lamellar structure parameters and melting points of polyethylene-<Emphasis Type="Italic">co</Emphasis>-(butene/octene)s

Time- and temperature-dependent SAXS-experiments were used to determine the effect of octene and butene co-units on the lamellar structure and the melting properties of polyethylene. As expected, melting points decrease with increasing co-unit content, but crystal thicknesses are not affected and depend on the crystallization temperature only. Results can be cast into some simple equations which describe the dependence:

Small angle X-ray scattering from lamellar phase for β-3,7-dimethyloctylglucoside/water system: comparison with β-n-alkylglucosides

Small angle X-ray scattering (SAXS) is measured for the lamellar phase in aqueous systems of 1-o-β-3,7-dimethyoctyl-D-glucopyranoside (β-Glc(Ger)), which has recently been prepared by us, 1-o-β-decyl-D-glucopyranoside (β-GlcC₁₀), and 1-o-β-octyl-D-glucopyranoside (β-GlcC₈). The repeat distance d obtained from the position of the diffraction peak does not follow the swelling law d = 2δ_hc/_hc, where δ_hc and _hc are the thickness and the volume fraction of the hydrophobic layer, respectively. This may result from the fact that δ_hc increases and, equivalently, the surface area per surfactant molecule (a_s) decreases with increasing concentration. So we calculate δ_hc and a_s from the observed d value at each concentration using the above swelling law. The half-thickness δ_hc increases in the order β-GlcC₈ < β-Glc(Ger) < β-GlcC₁₀ at a fixed concentration. On the other hand, the data on a_s for β-GlcC₁₀ and β-GlcC₈ lie on the same line and the data for β-Glc(Ger) lies above this line. These results suggest that the cross-sectional area of the geranyl chain is larger than that of the glucose headgroup. Existence of water filled defects in bilayer sheets is also discussed based on the SAXS pattern and the concentration dependence of d.     

SDS/苯甲醇/H2O体系的相行为与结构

SDS／苯甲醇／H2O体系能生成胶束、微乳液、层状液晶、六角状液晶等分子有序组合作，它们之间转换关系可以从凝聚能理论得到解释．来甲酸在O／W微乳液中的分配系数K＝168，表明绝大多数苯甲醇被增溶于SDS胶束相内．随重量比本甲醇／SDS增加，层状液晶中的do值几乎不变，溶剂渗透率略有增加，六角状液晶中圆柱缔合体的半径r值几乎不变，溶剂渗透率增加．     

DRDF analysis of wide-angle x-ray scattering of natural rubber

A differential radial distribution function (DRDF) of molten natural rubber (NR) was derived from its wide-angle x-ray scattering (WAXS) data. Three peaks with Bragg spacings 4.85, 2.31, and 1.23 Å corresponding, respectively, to interchain, C₁-C₃ and C₁ -C₂ distances are present in the corrected WAXS curve. The derived DRDF, which is shown to be greatly improved than the ones published so far, contains six peaks located at 1.51, 2.48, 3.98, 5.68, 10.65, and 15.25 Å. Maximum contributions of intramolecular atomic distances to the radial distribution peaks were estimated and compared with the experimental results. The comparison shows that the first three peaks are intramolecular in origin and the remaining peaks are predominantly due to intermolecular regularities. A periodicity of an approximately constant interval of 5.26 Å is found between the intermolecular peaks and is attributable to the organizations of more or less parallel chain segments in the material. This finding provided additional evidence for the presence of local lateral ordering to the extent of about 30 Å in molten-state natural rubber.     

Exploration of silver decoration concentration to enhance photocatalytic efficiency of titanium dioxide photocatalysts

Ag decoration on TiO₂ is favorable to absorption of visible light and wider absorption range. Ag nanoparticles playing the role of electron receivers on TiO₂ surface enhance photodegradation. However, excess Ag nanoparticles caused reduced specific surface area of photocatalysts and increased probability of charge recombination, resulting in lower photocatalytic efficiency. In this study, the influence of various Ag decoration concentrations on photocatalytic activity was investigated. Surface treatment by nitric acid after Ag decoration was performed to avoid excessive Ag deposition. The extent of Ag elimination and its impacts on photocatalytic activity were also explored. An optimum Ag content in the photocatalyst was achieved and photocatalytic efficiency was obviously improved. It was found that the number of calcination times affected the crystallinity and stability of photocatalysts. Better photocatalytic efficiency could be obtained after twice calcinations.