1,1'-(六甲基三硅撑)双环戊二烯基二(对氯苯氧基)钛的合成及晶体结构

以1,3-二氯六甲基三硅烷相继与环戊二烯基钠、正丁基锂和四氯化钛作用合成了1,1'-(六甲基三硅撑)双环戊二烯基二氯化钛(1),1在氨基钠的存在下与对氯苯酚作用制得题目化合物(2)。通过元素分析、^1HNMR和MS鉴定了1与2的结构,并对2进行X射线结构分析确证了其结构。2的晶体属单斜晶系的P21/c空间群。晶胞参数:a=1.0746(3),b=2.4865(7),c=1.2568(2)nm; β=113.42(2)°;V=3.08137nm^3;Z=4,D0=1.305g·cm^-3。化合物中三个硅原子的桥链发生明显扭曲。通过氧原子中心原钛与苯环发生共轭,使整个分子形成共轭体系。     

1,3-手性转移反应的研究 (4R)-和(4S)-4-甲基(E)-2-辛烯醇的合成

以手性辛烯二醇双酯与甲基锂铜反应, 经1,3手性转移, 分别生成立体选择性高的(4R)和(4S)-4-甲基-辛烯醇酯。     

掺杂Y^3+的锂锰尖晶石的合成及其电化学性能研究

采用流变相反应法合成了掺杂稀土钇离子的锂锰尖晶石LiYxMn2-xO4，并对其 结构和电化学性能进行了初步研究。结果表明，当掺入的Y^3+的含量较低（x≤0. 02)时，得到的产物能保持完整的尖晶石结构，并表现出极佳的电化学性能。Y^3+ 的掺入使材料的循环稳定性能大幅度提高，而这种提高是源于Y^3+对尖晶石结构的 稳定作用。电极材料LiY0.02Mn1.98O4显示了最优的电化学性能，在0.2℃放电速率 下，其初始放电容量为118mA·h·g^-1，100次循环后仍能保持初始容量的98％。     

PVC DISULFIDE AS CATHODE MATERIALS FOR SECONDARY LITHIUM BATTERIES

PVC disulfide (2SPVC) was synthesized by solution crosslink and its molecular structure was confirmed by infrared spectrum. 2SPVC's specific area is 36.1 m2·g-1 tested by stand BET method, and granularity experiment gives out the particle size of d0.5= 11.3μm. With SEM (Scanning Electron Microscope) experiment the surface morphology and particle shape of 2SPVC were observed. Cyclic voltammetry (scan rate: 0.5 mV·s-1) shows that 2SPVC experience an obvious S-S redox reaction in charge-discharge process. When 2SPVC was used as cathode material for secondary lithium battery in a 1 mol·L-1 solution of lithium bis(trifluoromethylsulfonyl) imide (Li(CF3SO2)2N) in a 5:45:50 volume ratio mixture of o-xylene (oxy), diglyme (DG) and dimethoxymethane (DME) at 30℃, the first discharge capacity of 2SPVC is about 400.3 mAh·g-1 which is very close to its theoretical value (410.5 mAh·g-1) at a constant discharge current of 15 mA·g-1. It can retain at about 346.1 mAh·g-1 of discharge capacity after 30 charge-discharge cycles. So 2SPVC is a very promising cathode candidate for rechargeable lithium batteries.     

吲哚并喹嗪衍生物的立体选择性合成

用锂铝氢四还原卟啉得到卟啉醇,它与甲乙酮反应得相应的羟甲基氨基酮,在相转移条件下,它能被转化成光学纯吲哚并喹嗪衍生物.列出了环化机理的反应流程.     

LiF-KF熔盐溶液局部结构的计算机模拟研究

本文用Monte Carlo法对同离子系LiF-KF熔盐溶液的局部结构进行了计算机模拟,介绍了计算方法和模型。计算了LiF, KF及Lif-KF混合前后正-正离子, 正-负离子, 负-负离子间位能变化, 各类离子的近邻离子排布规律, 以及各种形式离子团的组成比例。本文还讨论了在熔盐瞬时结构中存在的静电场的微区涨落。     

用氟钽酸根指示电位滴定钽的新方法

A new potentiometric titration method for the determination of tantalum in sulfuric acid and hydrofluoric acid media is described. EMF's were monitored with a double-junction reference electrode and a flurortantalate ion selective indicator electrode made in this laboratory previously. Five titrants have been evaluated for the precipitation titration. CPC, BDTAC and TPA yield the highest precision and largest potentiometric breaks, then rank CETAB and Hyamine 1622 in turn. CPC is considered to be the most satisfactory owing to the most sharp end-point break yielded when 10^-^4M of Ta is titrated with it. The concentration of H2SO4 suitable for the titration is 0.18 to 1.8M and that of HF is 0.23 to 1.7M. The method is suitable for Ta content in the range of 0.5 to 150 mg with a coefficient of variation of 0.15% (9 results) for 20 mg of Ta. HCl, H3PO4, tartaric acid and (NH4)2C2O4 as wellas a large amount of Fe^3^+, Ni^2^+, Cr^3^+, WO2^-^4, Zr^4^+, La^3^+, Al^3^+, MoO2^-^4 and Nb^5^+ do not interfere, while ClO^-^4, H2O2 and BF^-^4 must be avoided. The method has been found to be very useful for the determination of Ta in steels and crystalline lithium tantalate. The results obtained are in good agreement with those of comparable methods. This method is very simple and provides a fast determination process.     

High performance nanocomposite polymer electrolytes

Solid lithium-conducting nanocomposite polymer electrolytes based on poly(oxyethylene) (POE) were prepared using high aspect ratio cellulosic whiskers and lithium imide salt, LiTFSI. The cellulosic whiskers were extracted from tunicate — a sea animal — and consisted of slender parallelepiped rods that have an average length around 1 μm and a width close to 15 nm. High performance nanocomposite electrolytes were obtained. The filler provided a high reinforcing effect, despite the favorable cellulose/POE interactions that were expected to decrease the possibility of inter-whisker connection and formation of a percolating cellulosic network, while a high level of ionic conductivity was retained with respect to unfilled polymer electrolytes. Cross-linking and plasticizing of the matrix as well as preparation of the composites from an organic medium were also investigated.     

烯烃配位的过渡金属卡宾配合物的研究XVI:四氟苯并双环[2,2,2]辛三烯三羰基铁的新奇开环反应-新型螯合双烯丙基三羰基铁配合物的合成和结构

四氟苯并双环[2,2,2]辛三烯三羰基铁(C12H6F4)-Fe(CO)3(1)与芳基锂试剂ArLi(Ar=C6H5、o-, m-, p-CH3C6H4、p-CH3OC6H4、p-CiC6H4), 在低温下反应, 生成的酰羰基锂盐中间体用三乙基氧 -四氟硼酸盐(Et3OBF4)在水溶液中于0℃进行烷基化时, 双环烯烃配体开环, 生成组成为(C12H6F4)(CO)2FeC(OC2H5)Ar的螯合双烯丙基二羰基铁配合物(2-7), 配合物5的晶体属单斜晶系, 晶胞参数为;a=16.870(4), b=13.707(4), c=19.361(4)A, β=107.92(2)°.V=4259(1)A^3, Z=8, 空间群为C^62h-C2/c, 最后的偏离因子R=0.0409, Rw=0.0391。     

三元体系MCl-SbCl~3-HOAc (M=Li,Na; 25℃)的研究

测定了三元体系MCl-SbCl~3-HOAc(M=Li,Na;25℃)的溶度数据和饱和溶液的折光指数,并绘制了相应的溶度图及其折光指数曲线。M=Li时,体系的溶度曲线和折光指数曲线均由三支组成,分别与LiCl.0.5HOAc,LiCl,SbCl~3相对应。M=Na时,体系属于简单共饱型,无任何新相形成。研究结果表明,当M分别是Li,Na或K,NH~4,Rb,Cs时,体系的物理化学行为有着极为显著的不同,说明MCl-SbCl~3-HOAc(M=Li,Na,K,NH~4,Rb,Cs)体系可以作为区分碱金属系列阳离子性质差别的典型体系。