高压沿面放电烟气脱硫技术动态实验研究

本文针对高压沿面放电活化气体的烟气脱硫技术,在静态实验研究的基础上进行了实验室冷态动态的实验研究。设计了便于反应和测量的动态实验装置。实验解释了电子束法脱硫技术中导致氨气泄漏的部分原因,验证了高压沿面放电脱硫技术可以在较低的运行电压下,达到提高脱硫效率,减少氨气泄漏的作用。     

Catalytic air oxidation of ambient temperature hydrocarbons

Catalytic air oxidation of the aliphatic hydrocarbons n-decane, hexanes, gasoline and diesel fuel was conducted at ambient temperature with novel iron catalysts. The concentration of n-decane in water was reduced from 1.42 g in 100 ml to 0.07 g in 100 ml in 5 h at room temperature forming carbon monoxide and water by means of intermediate aldehydes. Results of FT–IR and GC–MS analyses demonstrated formation of aldehydes and unsaturated alcohols. Carbon monoxide was detected on catalyst residues and in the vapor phase. The indicated catalytic reaction mechanisms are discussed.     

在H－ZSM－5沸石上甲醇转化为汽油的初始产物分布

在Ｈ－ＺＳＭ－５沸石上甲醇转化为汽油的初始产物分布姜玄珍（浙江大学化学系，杭州３１００２７）Ｒ．Ｆ．Ｈｏｗｅ（新南威尔士大学物理化学系，澳大利亚）关键词Ｈ－ＺＳＭ－５沸石，甲醇转化汽油，产物分布以氢型ＺＳＭ－５沸石作催化剂转化甲醇为汽油（ＭＴＧ），在...     

微乳液介质—1—（2—吡啶偶氮）—2—萘酚光度法测定汽油中环烷酸铁的含量

本研究了微乳液为介质时，铁与１－（２－吡啶偶氮）－２－萘酚（ＰＡＮ）的显色反应。选择７３０ｎｍ处为测定波长，ε为１．４×１０＾４Ｌ．ｍｏｌ＾－＾１．ｃｍ＾－＾１，铁量在０－５０μｇ／２５ｍｌ范围内符合比耳定律，该法适用于汽油中环烷酸铁的测定。     

Physico-Chemistry of the Limestone Sulphation Process

Aspects of the mechanism of the overall reaction between CaCO₃/CaO and SO₂/SO₃ under oxidizing conditions are discussed. The limestone and lime sulphation processes were carried out in a thermobalance under conditions relevant to atmospheric fluidized bed combustion. Sulphated samples, prepared in the form of cross-section particles, were examined in a scanning electron microscope by energy-dispersive X-ray and back-scattered electron imaging. Photomicrographs are presented. The reaction proceeded from the outer surface of the particles and along the pores. Surface textural changes during the reaction were considered. The layer of products was identified as controlling both the rate and extent of limestone/lime sulphation. In the products, two sulphur-bearing solids (CaSO₄ and CaS) were identified. The presence of CaS, which may cause difficulties in practice, is attributed to CaSO₃ disproportionation. This revised version was published online in August 2006 with corrections to the Cover Date.     

磁化作用对汽油动态挥发性影响的研究

用热重（TG）分析和自行设计的原位动态挥发实验，研究了在不同条件下汽油的挥发性，结果表明，磁化空气或磁化汽油都可提高汽油的挥发性，而汽油和空气共同磁化，可更大幅度地提高汽油的挥发性。     

相转移催化应用于催化裂化汽油氧化脱硫的研究

随着人们环境保护意识的增强及原油硫含量的增大, 生产满足环境保护要求的清洁燃料是全球炼油工业的发展趋势, 燃料油脱硫显得越来越重要. 在众多的脱硫方法中, 选择性氧化脱硫技术以其工艺条件温和, 脱硫效果明显等特点, 受到了炼油行业的极大关注[1~3], 但脱硫率偏低(30％), 其关键是水相氧化剂与含硫化合物的有效混合. 本文将相转移催化应用于催化裂化(FCC)汽油的氧化脱硫中, 并对脱硫的工艺和机理进行了研究.     

High resolution capillary gas chromatographic hydrocarbon-type analysis of naphtha and gasoline

A slightly modified, commercially available high resolution capillary gas chromatograph and a PC-based data processing system running proprietary software (“PONA”) have been employed in the development of a system for petroleum type analysis which would be equivalent or superior to the FIA (fluorescent indicator adsorption) method in terms of ease of use and the speed, variety, and accuracy of the analytical data produced. The system is capable of performing identification and quantitation of most of the individual components in a complex gasoline sample consisting of more than 230 components and can report weight percentage and/or volume percentage for each component as well as types by carbon number (e.g., isoparaffins, normal paraffins, olefins, naphthenes, aromatic compounds) within a ca. 70 minute analysis cycle. Precolumn sulfonation to trap olefins and aromatic compounds has been used as an complementary technique to the basic mass spectrometric identification of components of interest. The estimation of correction factors for weight percentage (or volume percentage) calculation are also discussed. Comparisons are made between this system and others, and the results indicate that the proposed method supersedes the conventional method employing FIA.     

Determination of the sulfur components of gasoline streams by capillary column gas chromatography with sulfur chemiluminescence detection

A method using a sulfur chemiluminescence detector (SCD) has been developed for the qualitative and quantitative determination of sulfur components in stabilized gasoline-range process streams, including blended gasolines containing between 1 and > 4000 ppm total sulfur. The detection limit per sulfur component was approximately 50 ppb. On-column injection was employed for optimum precision and accuracy. A new probe material was found which did not soften under FID operating conditions. A new method, using a hydrogen sulfide permeation tube, was developed for rapid alignment of the probe in the FID.     

Use of cetyltrimethylammonium bromide as surfactant for the determination of copper and chromium in gasoline emulsions by electrothermal atomic absorption spectrometry

In this work, the use of cetyltrimethylammonium bromide as surfactant for the preparation of oil-in-water emulsions for the determination of Cu and Cr in gasoline by electrothermal atomic absorption spectrometry (ET AAS) was evaluated. The surfactant amount was tested in the range of 25 to 300 mg, added to 2 ml of gasoline, and completed to 10 mL with 0.1% (v/v) nitric acid solution. 150 mg of surfactant was found optimum, and a sonication time of 10 min sufficient to form an oil-in-water emulsion that was stable for several hours. The ET AAS temperature program was established based on pyrolysis and atomization curves. The pyrolysis temperatures were set at 700 and 1300 °C for Cu and Cr, respectively and the selected atomization temperatures were 2400 and 2500 °C. The time and temperature of the drying stage and the atomization time were experimentally tested to provide optimum conditions. The limits of detection were found to be 5 μg L^− 1 and 1.5 μg L^− 1 for Cu and Cr, respectively in the original gasoline samples. The relative standard deviation (RSD) ranged from 4 to 9% in oil-in-water emulsions spiked with 5 μg L^− 1 and 15 μg L^− 1 of each metal, respectively. Recoveries varied from 90 to 98%. The accuracy of the proposed method was tested by an alternate procedure using complete evaporation of the gasoline sample. The method was adequate for the determination of Cu and Cr in gasoline samples collected from different gas stations in Salvador, BA, Brazil.