Effect of high pressure processing on the preservation of frozen and re-thawed sliced cod (Gadus morhua) and salmon (Salmo salar) fillets

Cod and salmon are both widely found in the seafood market, but those products are easily spoiled. This work reports on the investigation of the effects of three moderate pressure values (150, 300 and 450?MPa) applied for 5?min at 20°C on crude sliced cod and salmon fillets. It was found that high pressure processing (HPP) significantly reduced the microbial load during refrigerated storage for up to 14 days. As expected, the most effective treatment was 450?MPa because it inhibited microbial growth. This process affected the hardness, lightness, lipid oxidation, protein denaturation and oxidation. The fish muscle composition (lipid amount and protein profile) played a main role in the changes promoted by pressure. HPP permits the shelf life of the raw product at 4°C to be increased with minimal changes in the organoleptic characteristics and to enable crude consumption.     

Molecularly-Imprinted Materials for Potentiometric Transduction: Application to the Antibiotic Enrofloxacin

Enrofloxacin (ENR) is an antimicrobial used both in humans and in food producing species. Its control is required in farmed species and their surroundings in order to reduce the prevalence of antibiotic resistant bacteria. Thus, a new biomimetic sensor enrofloxacin is presented. An artificial host was imprinted in specific polymers. These were dispersed in 2-nitrophenyloctyl ether and entrapped in a poly(vinyl chloride) matrix. The potentiometric sensors exhibited a near-Nernstian response. Slopes expressing mV/Δlog([ENR]/M) varied within 48–63. The detection limits ranged from 0.28 to 1.01 µg mL^?1. Sensors were independent from the pH of test solutions within 4–7. Good selectivity was observed toward potassium, calcium, barium, magnesium, glycine, ascorbic acid, creatinine, norfloxacin, ciprofloxacin, and tetracycline. In flowing media, the biomimetic sensors presented good reproducibility (RSD of ± 0.7%), fast response, good sensitivity (47 mV/Δlog([ENR]/M), wide linear range (1.0 × 10^?5–1.0 × 10^?3 M), low detection limit (0.9 µg mL^?1), and a stable baseline for a 5 × 10^?2 M acetate buffer (pH 4.7) carrier. The sensors were used to analyze fish samples. The method offered the advantages of simplicity, accuracy, and automation feasibility. The sensing membrane may contribute to the development of small devices allowing in vivo measurements of enrofloxacin or parent-drugs.     

固相萃取-气相色谱-质谱法测定辐照鱼油中2-烷基环丁酮

提出了固相萃取-气相色谱-质谱法测定辐照鱼油中2-烷基环丁酮(2-十二烷基环丁酮和2-十四烷基环丁酮)含量的方法。0.300g辐照鱼油样品用正己烷溶解,ProElut Silica固相萃取柱净化。在气相色谱分离中用HP-5MS色谱柱为固定相,在质谱分析中采用选择离子监测模式。2种2-烷基环丁酮的质量浓度均在0.01~1.0mg·L-1范围内与其峰面积呈线性关系,方法的测定下限(10S/N)为10μg·kg-1。加标回收率在91.2%~96.0%之间,测定值的相对标准偏差(n=6)在3.7%~5.9%之间。     

Determination of polybrominated diphenyl ethers in fish tissues by matrix solid-phase dispersion and gas chromatography coupled to triple quadrupole mass spectrometry: Case study on European eel (Anguilla anguilla) from Mediterranean coastal lagoons

This paper describes the development and validation of an analytical methodology to determine 28 polybrominated diphenyl ethers (PBDEs) in European eel (Anguilla anguilla) tissues using matrix solid-phase dispersion (MSPD) and gas chromatography coupled to triple quadrupole mass spectrometry (GC-QQQ-MS/MS). A total of 28 PBDEs were targeted, including tri- to deca-brominated congeners.The robustness and effectiveness of the proposed sample preparation procedure was demonstrated in lipid-rich eel tissues. The use of batch MSPD with activated silica gel and H₂SO₄-impregnated silica gel, followed by H₂SO₄ digestion and multilayer cartridge clean-up allowed for complete lipid removal and eliminated matrix effects during GC-QQQ-MS/MS analysis. The average PBDE recoveries from eel muscle samples spiked with PBDEs at two levels were in the range 56.2-119.0%. Precision was satisfactory since relative standard deviations were lower than 19.6%, regardless of spike level, and method quantification limits ranged between 1 and 170 pg g⁻¹ (wet weight).The method demonstrated its successful application for the analysis of eel samples from two coastal lagoons located on the western French Mediterranean coast. All samples tested positive, but for tri- to hexa-brominated congeners only and total PBDE levels observed in this study were in the range 0.08-1.80 ng g⁻¹ wet weight.     

Rapid measurement of fish freshness indices by an amperometric flow-injection system with a 16-way switching valve and immobilized enzyme reactors

A novel flow-injection system is proposed for the rapid measurement of the fish freshness indices K₁ and K₂: K₁=[([HxR+[Hx])×100/([IMP]+[HxR]+[Hx])] and K₂=[[Hx]×100/([HxR]+[Hx])], where [IMP], [HxR] and [Hx] are inosine-5′-monophosphate, inosine and hypoxanthine concentrations, respectively. For the estimation of index K₁, 5′-nucleotidase immobilized reactor and nucleoside phosphorylase (NP)/xanthine oxidase (XO) coimmobilized reactor were incorporated in series in the flow-injection line made up by a 16-way switching valve with two sample loops. For the estimation of index K₂, NP and XO immobilized reactors were also incorporated in the similar flow-line. Two sample portions passed through the flow-line with different residence times so that two peaks were obtained. The first and second peaks obtained in the K₁-determining system corresponded to the total of HxR and Hx and the total of Hx, HxR and IMP, respectively. Similarly, the first and second peaks obtained in the K₂-determining system corresponded to Hx and the total of Hx and HxR, respectively. Therefore, the indices K₁ and K₂ can be estimated by

where i₁ and i₂ present the peak current of the first and second peaks, respectively, and f the ratio of the peak currents of the first and second peaks for a Hx standard solution. A sea bream was selected as a model fish and it was stored at 4 °C after death. A good correlation was found between the index K₁ and the storage time over a period of 400 h, with a correlation coefficient of 0.992, but no correlation between the index K₂ and the storage time. The measurements could be performed at a rate of 22 samples per hour with satisfactory precision (0.6–1.2% R.S.D.), without calibration for each species, accurate weighing of fish meat and any interferences in fish meat.     

Mediated amperometric biosensor for hypoxanthine based on a hydroxymethylferrocene-modified carbon paste electrode

An amperometric enzyme electrode for the determination of hypoxanthine in fish meat is described. The hypoxanthine sensor was prepared from xanthine oxidase immobilized by covalent binding to cellulose triacetate and a carbon paste electrode containing hydroxymethylferrocene. The xanthine oxidase membrane was retained behind a dialysis membrane at a carbon paste electrode. The sensor showed a current response to hypoxanthine due to the bioelectrocatalytic oxidation of hypoxanthine, in which hydroxymethyiferrocene served as an electron-transfer mediator. The limit of detection is 6 × 10^?7 M, the relative standard deviation is 2.8% (n=28) and the response is linear up to 7 × 10^?4 M. The sensor responded rapidly to a low hypoxanthine concentration (7 × 10^?4 M), the steady-state current response being achieved in less than 1 min, and was stable for more than 30 days at 5 ° C. Results for tuna samples showed good agreement with the value determined by the conventional method.     

A new multiresponse optimization approach in combination with a D-Optimal experimental design for the determination of biogenic amines in fish by HPLC-FLD

A new strategy to approach multiresponse optimization in conjunction to a D-optimal design for simultaneously optimizing a large number of experimental factors is proposed. The procedure is applied to the determination of biogenic amines (histamine, putrescine, cadaverine, tyramine, tryptamine, 2-phenylethylamine, spermine and spermidine) in swordfish by HPLC-FLD after extraction with an acid and subsequent derivatization with dansyl chloride. Firstly, the extraction from a solid matrix and the derivatization of the extract are optimized. Ten experimental factors involved in both stages are studied, seven of them at two levels and the remaining at three levels; the use of a D-optimal design leads to optimize the ten experimental variables, significantly reducing by a factor of 67 the experimental effort needed but guaranteeing the quality of the estimates. A model with 19 coefficients, which includes those corresponding to the main effects and two possible interactions, is fitted to the peak area of each amine. Then, the validated models are used to predict the response (peak area) of the 3456 experiments of the complete factorial design. The variability among peak areas ranges from 13.5 for 2-phenylethylamine to 122.5 for spermine, which shows, to a certain extent, the high and different effect of the pretreatment on the responses. Then the percentiles are calculated from the peak areas of each amine. As the experimental conditions are in conflict, the optimal solution for the multiresponse optimization is chosen from among those which have all the responses greater than a certain percentile for all the amines. The developed procedure reaches decision limits down to 2.5 μg L⁻¹ for cadaverine or 497 μg L⁻¹ for histamine in solvent and 0.07 mg kg⁻¹ and 14.81 mg kg⁻¹ in fish (probability of false positive equal to 0.05), respectively.     

Simultaneous Determination of Selected Veterinary Antibiotics and their Main Metabolites in Fish and Mussel Samples by High-Performance Liquid Chromatography with Diode Array-Fluorescence (HPLC-DAD-FLD) Detection

A reversed-phase high-performance liquid chromatography (RP-HPLC) method for the quantitative determination of 11 antibiotics (drugs) and the main metabolites of five of them in fish tissue and mussel samples were developed, optimized, and validated. The analytes belong to four different classes of antibiotics (sulfonamides, tetracyclines, penicillin, and amphenicols). The analyzed compounds were sulfadiazine and its N⁴-acetylsulfadiazine metabolite; sulfamethazine and its N⁴-acetylsulfamethazine; sulfamerazine and its N⁴-acetylsulfamerazine; sulfamethoxazole; trimetroprim; amoxicillin and its main metabolite amoxicilloic acid; ampicillin and its main metabolite ampicilloic acid; chloramphenicol; thiamphenicol; oxytetracycline; and chlortetracycline. For HPLC analysis, diode array and fluorescence detectors were used. The separation of the analyzed compounds was conducted by means of a C₁₈ (150 mm × 4.6 mm I.D., particle size 5 µm) analytical column with LiChrospher® C₁₈ (4 mm × 4 mm, particle size 5 µm) guard-column. Analyzed drugs were determined within 35 minutes using formic acid 0.1% in water and acetonitrile in gradient elution mode as the mobile phase. The method was applied to the determination of the analytes in tissue of hake (Merluccius merluccius), anchovy (Engraulis encrasicolus), mussel (Mytltus sp.), and wedge sole (Solea solea). The proposed method was also evaluated by a laboratory assay consisting of the determination of the targeted analytes in samples of Cyprinus carpio that were previously administered controlled doses of the antibiotics.