铁分子Fe2的自旋极化效应

采用密度泛函方法(B3P86)对 Fe_2分子结构进行了优化.计算结果中未观察到自旋污染,基态波函数与高态波函数并未混杂,结果表明,Fe_2中有8个未配对电子,这些电子空间分布不同和自旋平行产生的自旋极化效应,使 Fe_2能量最低.计算结果表明,Fe_2分子的基态是~9∑_g~ ,并非~7Δ_u,进而表明 Fe_2的自旋平行效应比电子自旋配对效应要强.计算得到该分子基态的二阶、三阶和四阶力常数分别为1.4115×10~(-2)aJ/nm~2、-37.1751×10~3aJ/nm~3和 98.7596×10~4aJ/nm~4；光谱数据ω_eχ_e、B_e、α_e分别为0.3522、0.0345、 0.4963×10~(-4)cm~(-1)；离解能为3.5522eV,平衡键长为0.2137nm,振动频率为292.914cm~(-1)；并得到了 Murrel-Sorbie 函数.     

(111)择优取向的Pb(Zr0.52Ti0.48)O3铁电薄膜的制备及研究

选用不同浓度的Pb(Zr_0.52Ti_0.48)O₃溶胶，用Sol-gel法在Pt/Ti/SiO₂/Si基片上沉积一层厚度不同的Pb(Zr_0.52Ti_0.48)O₃ (PZT52)过渡层，经400℃烘烤、550℃退火等程序后，再用Sol-gel法在PZT52过渡层上沉积Pb(Zr_0.52Ti_0.48)O _{关键词： PZT铁电薄膜 择优取向 过渡层 剩余极化强度}     

Electrical conduction and dielectric properties of vanadium phosphate glasses doped with lithium

AC conductivity and dielectric studies on vanadium phosphate glasses doped with lithium have been carried out in the frequency range 0.2-100 kHz and temperature range 290-493 K. The frequency dependence of the conductivity at higher frequencies in glasses obeys a power relationship, σ_ac=Aω^s. The obtained values of the power s lie in the range 0.5≤s≤1 for both undoped and doped with low lithium content which confirms the electron hopping between V⁴⁺ and V⁵⁺ ions. For doped glasses with high lithium content, the values of s≤0.5 which confirm the domination of ionic conductivity. The study of frequency dependence of both dielectric constant and dielectric loss showed a decrease with increasing frequency while they increase with increasing temperature. The results have been explained on the basis of frequency assistance of electron hopping besides the ionic polarization of the glasses. The bulk conductivity increases with increasing temperature whereas decreases with increasing lithium content which means a reduction of the V⁵⁺.     

Frequency dependence of ionic conductivity and dielectric relaxation studies in Na3H(SO4)2 single crystal

Electrical impedance measurements of Na₃H(SO₄)₂ were performed as a function of both temperature and frequency. The electrical conductivity and dielectric relaxation have been evaluated. The temperature dependence of electrical conductivity reveals that the sample crystals transformed to the fast ionic state in the high temperature phase. The dynamical disordering of hydrogen and sodium atoms and the orientation of SO₄ tetrahedra results in fast ionic conductivity. In addition to the proton conduction, the possibility of a Na⁺ contribution to the conductivity in the high temperature phase is proposed. The frequency dependence of AC conductivity is proportional to ω^s. The value of the exponent, s, lies between 0.85 and 0.46 in the room temperature phase, whereas it remains almost constant, 0.6, in the high-temperature phase. The dielectric dispersion is examined using the modulus formalism. An Arrhenius-type behavior is observed when the crystal undergoes the structural phase transition.     

Dielectric properties of a hydrated sulfonated poly(styrene-ethylene/butylenes-styrene) triblock copolymer

The present study showed that sulfonated poly(styrene-ethylene/butylenes-styrene) (S-SEBS) triblock copolymer ionomers can be made to exhibit dielectric constants on the order of a hundreds thousand. Although they are too lossy at this point to use as dielectric materials in capacitors or as electrostrictive Maxwell effect transducer materials because of their high hydrogen ion conductivity, the results of these initial dielectric studies as a function of ion content were used to try to understand the effects of a polar plasticizer, water, on dielectric properties of the acid form of this ionomer. This was done before moving on to more tightly bound ions (rather than the hydrogen ions of the sulfonic acid groups used here) and to other polar, less mobile plasticizers (which also interact strongly with the ionic dipoles). The discovery of such high dielectric constants suggested the possibility that low dielectric loss versions of this type of polymer, as well as other members of the class known as ionomers, might find future applications as extremely high dielectric constant materials in capacitors or transducers. Experimental results for films with degrees of sulfonation on the order of 10% or more showed dielectric constants on the order of ?′ ∼ 100,000 but dielectric loss tangents near D = tan δ ∼ 0.3, when the materials were exposed to high humidity conditions. Experiments to determine the effects of water content on the material's dielectric response showed that water can easily move into and out of the films studied and that this transport behavior is strongly correlated to the relative humidity of the environment and to the degree of sulfonation. Water content, in this case, was thus the primary consideration when attempting to understand the observed high dielectric constants in films with degree of sulfonation greater than 5.5%. However, vacuum-dried films were, also, examined and observed to exhibit a dielectric constant on the order of 2 until the degree of sulfonation was greater than 11%. Above this value, the dielectric constant increased by approximately 100% to a value on the order of 4.     

On additives, morphological evolution and dielectric breakdown in low density polyethylene

A series of low density polyethylene systems has been studied with respect to structural evolution and short-term dielectric breakdown behaviour. All materials were based upon a single polymer, that is commonly used in high voltage applications, but with different additives. In all three of these systems, multiple melting transitions were observed, as a result of molecular fractionation effects during crystallization. In the virgin polymer, a space-filling banded spherulitic morphology was found to develop at low temperatures (102 °C and below) whereas, at higher temperatures, only a few isolated axialites were observed. Inclusion of the antioxidant resulted in greatly increased nucleation densities, such that, at low temperatures, no evidence of spherulitic organisation remained. At higher temperatures, sheaf-like lamellar aggregates developed, which were much smaller and much more numerous than in the case of the virgin polymer. Further addition of dicumyl peroxide (DCP) resulted in the rapid formation of a crosslinked network at 200 °C. Some crosslinking also occurred at 150 °C, but over a much longer timescale. Where extensive crosslinking occurred prior to crystallization, the resulting gel inhibited structural development, such that only a few small, isolated sheaves were able to form at 102 °C. In view of the principal application area of this material, the breakdown strength of each of the above systems was then measured and the whole data set was analysed statistically. When structural factors were considered alongside the statistics, no clear trends emerged to indicate that either the compositional or morphological variations were reflected in the short-term electrical failure processes.     

Compulsorily Phase Locked Interferometer Using Orthogonally Polarized Light Source of a Modulated LD with High Extinction Ratio

This paper describes a compulsorily phase locked differential interferometer using an orthogonally polarized light source of a modulated LD with high extinction ratio to reduce non-linearity of the interferometer caused by polarization cross-talk. The current modulated LD is used as a light source to make the interferometer compact and for the scanning phase of the interferometer. The interferometer is operated compulsorily at the maximum inclination point of the fringe intensity curve by fringe scanning and an electric system. A Wollaston prism of high extinction ratio (50 dB) is used to combine the polarizing beams and to make the polarization cross-talk very small. In one light source the polarized output beams are on the same propagation axis; in the other they have a small crossing angle (2.5 mrad ∼ 10 mrad) to completely exclude non-linearity of the interferometer causded by polarization cross-talk. Using jets of a gas mixture of nitrogen and ethylene, this interferometer was demonstrated to be useful in detecting the photothermal effect of a photothermal velocimeter under phase fluctuation in a turbulent flow.     

New FIR laser lines and frequency measurements for optically pumped CD3OH

Twenty new cw FIR laser lines in CD₃OH, optically pumped by a CO₂ laser, are reported. The frequencies of 39 of the stronger laser lines were measured relative to stabilized CO₂ lasers with a fractional uncertainty, as determined by the reproducibility of the FIR frequency itself, of 2 parts in 10⁷.Contribution of the U.S. Government, not subject to copyright.     

Dielectric investigations of associate formation process in thin nitrobenzene interlayers formed between metal substrates

Studies of thickness and temperature dependencies of the dielectric susceptibility of nitrobenzene interlayers formed on conductive substrates were carried out. The obtained data were processed under the assumption of the existence of dimers (with opposite directions of molecular dipole moments) in orientationally ordered wall-adjacent layers. The results were treated on the basis of Lifshits theory.