Derivatisation in gas chromatographic determination of acidic herbicides in aqueous environmental samples

This paper reviews derivatisation processes applied in chromatographic determination of acidic herbicides (with carboxyl and phenol groups), mainly in aqueous environmental samples. The discussion focuses on the basic derivatisation reactions used to convert herbicides to derivatives to make them analysable by gas chromatography, and possibly to reduce detection limits and/or increase extraction recovery from aqueous samples. The reactions are transesterification, esterification, silylation, alkylation, and extractive and pyrolytic alkylation. The reagents used to conduct the reactions are numerous. Diazomethane is a very efficient methylation reagent but explosive and toxic. Methyl iodide also ensures rapid and efficient methylation. Benzyl bromide can be used directly in water but derivatisation yield is low and reproducibility is poor. Butyl chloroformate and dimethyl sulfite can also be used for derivatisation in water, and acetic anhydride can be used for in-situ derivatisation of phenolic herbicides. For increasing selectivity of GC detection pentafluorobenzyl bromide (for ECD) and (2-cyanethyl)dimethyl(diethylamino)silane (for NPD) have been applied. Very characteristic ions are produced in mass spectra if silyl groups are introduced, e.g. by using bis(trimethylsilyl)trifluoroacetamide. Tetramethylammonium, trimethylphenylammonium, tetraalkylammonium, and trimethylsulfonium hydroxides and salts can by used for derivatisation at elevated temperature in the GC injection port. Extractive alkylation is relatively efficient if tetraalkylammonium salts with long chain alkyl groups are used.     

Amino acid analysis by using comprehensive two-dimensional gas chromatography

The separation characteristics of alkylchloroformate-derivatised amino acids (AAs) by using comprehensive two-dimensional gas chromatography (GC×GC) is reported. The use of a low-polarity/polar column set did not provide as good a separation performance as that achieved with a polar/non-polar column set, where the latter appeared to provide less correlation over the separation space. The degree of component correlation in each column set was estimated by using the correlation coefficient (r²; for ¹t_R and ²t_R data) with the low-polarity/polar and polar/low-polarity sets returning correlation coefficients of 0.86, and 0.00 respectively, under the respective conditions employed for the experiments. The 1.5-m non-polar ²D column (0.1-mm ID; 0.1-m film thickness) gave peak halfwidths of the order of 50–80 ms. Linearity of detection was good, over a three order of magnitude concentration range, with typical lower detection limit of ca. 0.01 mg L^–1, compared with 0.5 mg L^–1 for normal GC operation with splitless injection. The method was demonstrated for analysis of AAs in a range of food and beverage products, including wine, beer and honey. The major AA in these samples was proline. The Heineken beer sample had a relatively more complex and more abundant AA content compared with the other beer sample. The wine and honey samples also gave a range of AA compounds. Repetition of the sample preparation/analysis procedure for the honey sample gave acceptable reproducibility for individual AAs.     

The determination and characterisation of 2-naphthyloxycarbonyl chloride derivatised biogenic amines in pet foods

The need to monitor biogenic amines levels is essential for many areas of the food industry for two main reasons: the caustic nature and potential toxicity of these amines, and the potential to use amine levels as markers for freshness and quality in foodstuffs. Optimised analysis conditions used for the determination of biogenic amines derivatised with 2-napthyloxycarbonyl chloride has been applied to different pet food samples to assess the effectiveness of this method for complex sample matrices. Further to this, the use of high-resolution mass spectrometry has enabled the previously unconfirmed derivatised form of seven biogenic amines to be established. The derivatised forms identified include as mono substituted (tryptamine and histamine), bisubstituted (putrescine, cadaverine and tyramine), trisubstituted (spermidine) and tetrasubstituted (spermine). The methodology of biogenic amine determination was performed successfully to a range of pet food products highlighting the applicability to a variety of complex sample matrices.     

Capillary electrochromatography of 1-phenyl-3-methyl-5-pyrazolone derivatives of some mono-and disaccharides

Summary A packing procedure was adopted for capillary electrochromatography (CEC) that produces capillary columns with high separation efficiencies. The columns were fully packed, 50 cm long, with UV detection being performed through the packed section 30 cm from the inlet end. The CEC experiments were run at ambient pressure, with no additional pressure applied to the ends of the column. The stationary phase (octadecyl silica (ODS), 5 μm) promoted a high velocity electroosmotic flow (EOF), enabling rapid and efficient separation of a hydrocarbon test mixture. Some 1-phenyl-3-methyl-5-pyrazolone (PMP) derivatives of mono- and disaccharides were baseline separated, using a 5 mM NaH₂PO₄ in 80% acetonitrile and 20% water (v/v) buffer solution. CEC shows promise for future applications in carbohydrate analysis. Presented at Balaton Symposium on High Performance Separation Methods, Siófok, Hungary, September 1–3, 1999     

In situ ethylation of organolead,organotin and organomercury species by bromomagnesium tetraethylborate prior to GC‐ICP‐MS analysis

An analytical method for simultaneous in situ ethylation, of organolead, organotin and organomercury compounds in aqueous samples was developed using a new derivatisation agent, bromomagnesium tetraethylborate (BrMgEt₄B). The determination of lead, tin and mercury compounds was done by species‐specific isotope dilution, derivatisation and GC–inductively coupled plasma MS (GC‐ICP‐MS) or by GC‐MS. The recovery and accuracy of the derivatisation were evaluated. The effect of pH and the relative quantity of derivatisation agent were studied.     

On-line determination of aliphatic amines in water using in-tube solid-phase microextraction-assisted derivatisation in in-valve mode for processing large sample volumes in LC

This paper describes a cost-effective procedure for the analysis of short-chain aliphatic amines in water samples using a solid-phase microextraction device. Analyte preconcentration and derivatisation were effected into a capillary column coated with 95% polydimethylsiloxane–5% polydiphenylsiloxane, which was used as the injection loop of a Rheodyne injection valve. The coating was previously loaded with the derivatisation reagent, 9-fluorenylmethyl chloroformate. A volume of 1 mL of samples was then drawn into the capillary column, and the extracted analytes were left to react on the capillary coating for 5 min. Next, the capillary column was cleaned by passing water. Finally, the injection valve was rotated, and the derivatives formed were dynamically desorbed and transferred to the analytical column into the mobile phase. Methylamine, ethylamine, propylamine, n-butylamine and n-pentylamine were selected as model compounds. Excellent sensitivity was achieved, being the limits of detection of 15–200 μg/L when using UV detection and of 0.1–0.4 μg/L by fluorescence.     

Analysis of chemical warfare agents. I. Use of aliphatic thiols in the trace level determination of Lewisite compounds in complex matrices

A series of normal aliphatic thiols have been used to derivatise the chemical warfare agents Lewisites I and II (LI and LII) in hydrocarbon matrices. Varying the chain length of the thiol allowed adjustment of derivative tR by 5.9 min for Lewisite I and 5.3 min for Lewisite II. Linear regression analysis of the chain length of the thiol derivatives of the Lewisite species, and that of a series of normal alkanes against tR, allowed regression models to be developed for each set of compounds. Application of the models allowed thiol reagents to be chosen to give derivatives of Lewisites I and II that eluted before and after the major hydrocarbon contaminant. Limits of detection were comparable for all thiol derivatives analysed by GC-MS in the selection ion monitoring mode (all below 1 microg ml(-1)). The robustness of this approach was illustrated by successful identification of Lewisite I in samples from the Sixth Proficiency Test (organised by the Organisation for the Prohibition of Chemical Weapons, OPCW) in a matrix of 1 mg ml(-1) diesel oil.     

Analytical characterisation of glutardialdehyde cross-linking products in gelatine-gum arabic complex coacervates

Encapsulates having shells of cross-linked mixtures of proteins and polysaccharides are widely used in the food and pharmaceutical industry for controlled release of actives and flavour compounds. In order to be able to predict the behaviour and the release characteristics of the microcapsules, a better understanding of the nature and extent of the cross-linking reaction is needed. Several analytical techniques were applied for the characterisation of glutardialdehyde (GDA) cross-linked encapsulates made of gelatine and gum arabic. To allow the use of sensitive, high-resolution methods such as chromatography and mass spectrometry, the sample first had to be hydrolysed. In this way, a mixture of amino acids, small peptides and the cross-link moieties was obtained. High-resolution liquid chromatography coupled to high-resolution mass spectrometry (HPLC-MS) was applied to detect possible cross-link markers through a comparison of HPLC-MS mass-chromatograms obtained for cross-linked and non-cross-linked coacervates. HPLC-MS/MS was used to identify the species responsible for the differences. Cross-linking occurred between GDA molecules and lysine and hydroxylysine epsilon-amino groups, and up to eight cross-link products of different nature could be identified. They included pyridinium ions and Schiff bases, and also unreacted GDA condensation products. Next, based on the insight gained in the possible chemical structures present in the cross-link markers, methods for selective labelling of these functionalities were employed to allow easier detection of related reaction products. Both liquid chromatography (LC) and gas chromatography (GC) were used in these experiments. Unfortunately, these approaches failed to detect new cross-link markers, most likely as a result of the low levels at which these are present.     

Determination of trace levels of ethylenethiourea by HPLC following derivatisation with phenacyl halides

Summary The HPLC determination of ethylenethiourea (ETU, imidazolidine-2-thione) has been carried out by derivatisation with phenacyl halides to give imidazole-[2,1-b]thiazoles, which were separated on a polystyrenedivinylbenzene (PS-DVB) column. A number of different phenacyl halides including p-phenyl-, and naphthyl, were studied and the p-nitro reagent was selected as the most suitable for residue analysis. The analysis was more sensitive than direct HPLC analysis and had a limit of detection of 0.04 ng ETU. Presented at the 15th International Symposium on Chromatography, Nürnberg, October 1984     

Multi-residue method for the determination of thyreostats in urine samples using liquid chromatography coupled to tandem mass spectrometry after derivatisation with 3-iodobenzylbromide

Thyreostats are banned compounds in Europe since 1981 (directive 81/602/EC) because of their carcinogenic and teratogenic properties. The control of their illegal use in breeding animals is amongst the most difficult because of their low molecular weight, high polarity and the existence of tautomeric forms. The analytical procedure described in this paper involves, after a derivatisation step with 3-iodobenzylbromide, the detection and identification at low level (microg/L) by LC-ESI(-)-MS/MS of eight thyreostats in various biological matrices (urine, muscle, liver, thyroid, animal feed, faeces and hair). The urine method has been validated according to the EU criteria (2002/657/EC decision): CCalpha and CCbeta were found in the range (0.1-5.2 microg/L) and (2.6-23.2 microg/L), respectively. The performances fulfil the requirements of the EU regarding the provisional minimum required performance limit (MRPL) fixed at 100 microg/L in urine.