超导氧化物La1.85Sr0.15CuO4/超高分子量聚乙烯复合材料的输运性质

采用热压法获得了具有不同混合比例的超导氧化物La1.85Sr0.15CuO4/超高分子量聚乙烯导电复合材料,并利用x射线衍射、扫描电子显微镜和标准四引线方法对复合材料的结构和低温电输运性质进行测量.实验结果显示,超导氧化物La1.85Sr0.15CuO4颗粒随机分布在聚合物本体中,相互间没有连接构成网络结构.在正常态下,复合材料的电阻-温度变化曲线给出类半导体行为.但对应于超导氧化物La1.85Sr0.15CuO4的超导转变温度Tc处,复合材料的电阻-温度变化曲线出现了极小值.室温下电阻率ρ随外加电场强度E的变化曲线测量结果表明,ρ-E曲线为一线形关系,随着电场强度E增加,电阻率ρ下降.文中对可能存在的导电机制进行分析,结果表明隧道贯穿模型可以很好地解释复合材料的导电机制.另外,外加电场强度E对复合材料的电输运特性有明显的影响.     

Thermal behaviour and firing characteristics of Zr/KClO4 primer mixture containing CuO

The effect of CuO on the thermal behaviour of Zr/KClO₄ primer mixtures was studied by thermoanalytical techniques, and the Bruceton method and its related calculation. It was found that the CuO catalytically promoted the decomposition of Zr/KClO₄ primer mixtures and shifted the exothermic peak of DSC curves to lower temperatures. In addition, the Zr/KClO₄ primer mixture containing CuO had a significant effect on the firing characteristics of electro-explosive devices.     

纳米氧化铜的制备及常温脱硫效能研究

采用硝酸铜为原料、氢氧化钠溶液为沉淀剂、使用体积比为1∶1的乙醇-水溶液为分散剂的直接沉淀法制备，通过改变工艺条件得到了三种纳米氧化铜产品，平均粒径分别为25.63，10.74和7.57 nm。采用TG-DTA、FIR、XRD和TEM等对纳米氧化铜进行表征。对产品的常温脱硫活性进行了穿透试验，并与已开发的其他常温精脱硫产品进行了比较，结果表明纳米氧化铜应用于H₂S脱硫，可在常温条件下具有优异的脱硫活性，对H₂S的脱除精度可以达到0.05 mg·m^-3以下。经过优选，产品在3 000 h^-1空速下穿透硫容达到25.3%，高于同类型的其他脱硫剂产品。     

共沉淀CuO-ZrO2复合氧化物分散态结构研究

用XRD、EXAFS、XPS表征了共沉淀法制备的CuO-ZrO2复合氧化物的分散态结构. 500 ℃焙烧的样品在一定组成范围内形成大体均匀的无定形态固溶体. CuO含量超过其在ZrO2中溶解度时，多余的CuO以CuO晶体形式存在；当ZrO2含量超过其在CuO中溶解度时，多余的ZrO2以四方相ZrO2晶体形式存在.焙烧温度达到800 ℃时，样品由单斜相ZrO2和CuO晶体组成.     

CuO/Al2O3催化剂高温固相反应的原位XRD和Raman研究

采用原位XRD和激光Raman光谱等技术对CuO/Al2O3系列催化剂高温下的表面组成和体相结构的变化进行研究.结果表明,随着焙烧温度升高,CuO首先与载体Al2O3发生固相反应生成CuAl2O4.CuAl2O4层能阻止外层CuO进一步向载体Al2O3扩散,从而使部分CuO稳定在CuO/Al2O3催化剂的表层.     

导电高分子膜包覆YBa2Cu3O7超导体抗环境作用的研究

通过电化学途径和化学途径在ＹＢａ＿２Ｃｕ＿３Ｏ＿７超导体表面制备了导电高分子聚吡咯膜，用以保护超导体不受环境作用的影响，实验结果发现电化学过程能破坏ＹＢａ＿２Ｃｕ＿Ｏ＿７的超导性，而采用化学法制备的聚吡咯和聚氯乙烯混和材料包覆在ＹＢａ＿２Ｃｕ＿３Ｏ＿７表面后，超导体不仅保持原有超导性，而且有很好的保护超导体免遭环境中酸和水作用的能力。     

CuO／CeO2和CuO／Al2O3催化剂的催化性能

本文以ＣＯ氧化为模式反应考察了ＣｅＯ２和Ａｌ２Ｏ３负载氧化铜催化剂的氧化活性，运用ＸＲＤ和ＴＰＲ技术研究了催化剂的还原性能和物相结构，结果表明：载体性质对负载ＣｕＯ催化剂的ＣＯ氧化活性有很大影响，ＣｕＯ／ＣｅＯ２催化剂活性明显高于ＣｕＯ／Ａｌ２Ｏ３催化剂．催化剂的还原特性随载体不同而不同．同时发现，热处理对催化剂铜物种的存在形式，晶粒大小、还原特性及其催化活性有明显影响，ＣｕＯ／Ａｌ２Ｏ３催化剂活性下降的主要因素是生成了活性较低的ＣｕＡｌ２Ｏ４相，而ＣｕＯ／ＣｅＯ２催化剂活性下降是由于ＣｕＯ和ＣｅＯ２发生烧结，晶粒变大     

Effect of Addition of Base on Ceria and Reactivity of CuO/CeO2 Catalysts for Low-Temperature CO Oxidation

In this work, we have reported the influence of the addition of base (KOH) on the physicochemical property of ceria synthesized by alcohothermal process, and the alcohothermal mechanism was also put forward. Furthermore, the prepared CeO2 was used as the support to prepare CuO/CeO2 catalysts via the wet impregnation method. The samples were characterized by N2 adsorption-desorption, X-ray powder diffraction (XRD), high resolution transmission electron microscopy (HRTEM), and temperature-programmed reduction by H2 (H2-TPR). The catalytic properties of the CuO/CeO2 catalysts for low-temperature CO oxidation were studied using a microreactor-GC system. The crystal size of CeO2-A was much smaller than that of CeO2-B, and the corresponding copper oxide catalysts exhibited higher catalytic activity than that of the CeO2-B-supported catalysts under the same reaction conditions. The alcohothermal mechanism indicated that KOH plays a key role in determining the physicochemical and catalytic properties of ceria-based materials.     

CuO/γ-Al2O3单分散催化剂的XAFS研究

采用XAFS方法研究浸渍法制备并于低温焙烧的CuO/γ-Al2O3催化剂的局域结构.对于CuO负载量小于单层分散阈值的CuO/γ-Al2O3(0.4 mmol/100 m2),结果表明,CuO物种是以层状分散的孤立原子簇存在于γ-Al2O3载体表面,其第一近邻Cu－O配位环境的结构与晶态CuO的相似,键长和配位数分别为0.195 nm和4.对于CuO负载量等于单层分散阈值的CuO/γ-Al2O3(0.8 mmol/100 m2),已有少量的CuO纳米颗粒生成.对于CuO负载量大于单层分散阈值的CuO/γ-Al2O3(1.2 mmol/100 m2),其结构与多晶CuO的相近.基于CuO在γ-Al2O3载体上的三种不同分散状态的结构特点,我们提出了CuO/γ-Al2O3催化剂的结构模型.     

Degradative analysis of aquatic fulvic acid: CuO oxidation versus pyrolysis after tetramethylammonium hydroxide treatments in air and helium atmospheres

The structural composition of Nordic aquatic reference fulvic acid was investigated using chemical and thermal degradation methods: alkaline CuO oxidation and analytical pyrolysis after tetramethylammonium hydroxide (TMAH) pretreatment. Off-line procedures of the TMAH treatments were carried out under both air and helium atmospheres, with the aim of clarifying the effect of oxygen. Irrespective of the fact that the chemical and thermal degradation methods gave qualitatively quite similar basic products (mainly phenols and phenolic acids together with aromatic and aliphatic carboxylic acids), they also revealed their unique selectivity and efficiency for releasing different kinds of structural constituents. The results verify the formation of additional carboxyl functionality in the CuO oxidation. However, some similar oxidative reactions also appeared to take place during the pretreatment procedures of strongly basic TMAH, especially under an air atmosphere. The use of inert and protective atmosphere during the TMAH pretreatment is therefore recommended for producing more relevant structural information about the complex composition of humic substances.