超导氧化物La1.85Sr0.15CuO4/超高分子量聚乙烯复合材料的输运性质

采用热压法获得了具有不同混合比例的超导氧化物La1.85Sr0.15CuO4/超高分子量聚乙烯导电复合材料,并利用x射线衍射、扫描电子显微镜和标准四引线方法对复合材料的结构和低温电输运性质进行测量.实验结果显示,超导氧化物La1.85Sr0.15CuO4颗粒随机分布在聚合物本体中,相互间没有连接构成网络结构.在正常态下,复合材料的电阻-温度变化曲线给出类半导体行为.但对应于超导氧化物La1.85Sr0.15CuO4的超导转变温度Tc处,复合材料的电阻-温度变化曲线出现了极小值.室温下电阻率ρ随外加电场强度E的变化曲线测量结果表明,ρ-E曲线为一线形关系,随着电场强度E增加,电阻率ρ下降.文中对可能存在的导电机制进行分析,结果表明隧道贯穿模型可以很好地解释复合材料的导电机制.另外,外加电场强度E对复合材料的电输运特性有明显的影响.     

Thermal behaviour and firing characteristics of Zr/KClO4 primer mixture containing CuO

The effect of CuO on the thermal behaviour of Zr/KClO₄ primer mixtures was studied by thermoanalytical techniques, and the Bruceton method and its related calculation. It was found that the CuO catalytically promoted the decomposition of Zr/KClO₄ primer mixtures and shifted the exothermic peak of DSC curves to lower temperatures. In addition, the Zr/KClO₄ primer mixture containing CuO had a significant effect on the firing characteristics of electro-explosive devices.     

纳米氧化铜的制备及常温脱硫效能研究

采用硝酸铜为原料、氢氧化钠溶液为沉淀剂、使用体积比为1∶1的乙醇-水溶液为分散剂的直接沉淀法制备，通过改变工艺条件得到了三种纳米氧化铜产品，平均粒径分别为25.63，10.74和7.57 nm。采用TG-DTA、FIR、XRD和TEM等对纳米氧化铜进行表征。对产品的常温脱硫活性进行了穿透试验，并与已开发的其他常温精脱硫产品进行了比较，结果表明纳米氧化铜应用于H₂S脱硫，可在常温条件下具有优异的脱硫活性，对H₂S的脱除精度可以达到0.05 mg·m^-3以下。经过优选，产品在3 000 h^-1空速下穿透硫容达到25.3%，高于同类型的其他脱硫剂产品。     

共沉淀CuO-ZrO2复合氧化物分散态结构研究

用XRD、EXAFS、XPS表征了共沉淀法制备的CuO-ZrO2复合氧化物的分散态结构. 500 ℃焙烧的样品在一定组成范围内形成大体均匀的无定形态固溶体. CuO含量超过其在ZrO2中溶解度时，多余的CuO以CuO晶体形式存在；当ZrO2含量超过其在CuO中溶解度时，多余的ZrO2以四方相ZrO2晶体形式存在.焙烧温度达到800 ℃时，样品由单斜相ZrO2和CuO晶体组成.     

CuO/Al2O3催化剂高温固相反应的原位XRD和Raman研究

采用原位XRD和激光Raman光谱等技术对CuO/Al2O3系列催化剂高温下的表面组成和体相结构的变化进行研究.结果表明,随着焙烧温度升高,CuO首先与载体Al2O3发生固相反应生成CuAl2O4.CuAl2O4层能阻止外层CuO进一步向载体Al2O3扩散,从而使部分CuO稳定在CuO/Al2O3催化剂的表层.     

Degradative analysis of aquatic fulvic acid: CuO oxidation versus pyrolysis after tetramethylammonium hydroxide treatments in air and helium atmospheres

The structural composition of Nordic aquatic reference fulvic acid was investigated using chemical and thermal degradation methods: alkaline CuO oxidation and analytical pyrolysis after tetramethylammonium hydroxide (TMAH) pretreatment. Off-line procedures of the TMAH treatments were carried out under both air and helium atmospheres, with the aim of clarifying the effect of oxygen. Irrespective of the fact that the chemical and thermal degradation methods gave qualitatively quite similar basic products (mainly phenols and phenolic acids together with aromatic and aliphatic carboxylic acids), they also revealed their unique selectivity and efficiency for releasing different kinds of structural constituents. The results verify the formation of additional carboxyl functionality in the CuO oxidation. However, some similar oxidative reactions also appeared to take place during the pretreatment procedures of strongly basic TMAH, especially under an air atmosphere. The use of inert and protective atmosphere during the TMAH pretreatment is therefore recommended for producing more relevant structural information about the complex composition of humic substances.     

CexTi1-xO2复合氧化物的结构及负载CuO对NO还原性能研究

采用共沉淀法制备了不同摩尔比(x=0,0.1,0.2～0.9,1.0)的CexTi1-xO2复合氧化物,考察了CuO/CexTi1-xO2对NO+CO反应的活性,并用BET,TPR和XRD等技术对各试样进行了表征。结果表明,试样的结构和还原特性随焙烧温度变化而变化。XRD检测表明,x值从0.1增加到0.5时,650℃焙烧的试样已形成了CeTi2O6物相,且主要以无定形状态存在;试样经800℃焙烧后晶化完全;x>0.6时,一些TiO2已经进入了CeO2晶格,形成了Ce Ti固溶体。催化剂活性评价表明CuO/CexTi1-xO2(650℃)对NO+CO反应具有较好的活性,其活性随x值变化而变化。TPR及XRD结果表明CuO与CeTi2O6之间存在很强的相互作用,CeTi2O6物相的形成使CuO的还原峰温由380℃提前到200℃,而CuO的存在又促进CeTi2O6的还原峰温从600℃提前至200～300℃。     

Copper Promoted Au/ZnO-CuO Catalysts for Low Temperature Water-gas Shift Reaction

IntroductionThe water-gas shift(WGS)reaction is an impor-tant step in many important chemical processes[1].Re-cently,the renewed interest in the removal of CO bythe WGS reaction has grown significantly because of theincreasing attention to pure hydrogen p…     

CuO/Ce-Zr-La-O催化剂的表征及CO氧化活性

采用柠檬酸溶胶-凝胶法制备的Ce-Zr-La-O固溶体为载体，制备CuO／Ce-Zr-La-O催化剂，用XRD，Raman，TPR等实验技术对Ce-Zr-La-O固溶体及CuO／Ce-Zr-La-O的物相、Redox性能进行了表征。实验结果表明，Ce0.7Cr0.3-yLayO固溶体的还原性能与La含量有关，适量的La能促进固溶体的氧化还原。CuO的负载量为6％时，CuO／Ce0．7Zr0.15La0.15O的活性最高，高分散且与载体相互作用的CuO是CO氧化活性相。     

Dispersion state of CuO on CeO2

XRD and XPS are used to study the dispersion state of CuO on ceria surface. The dispersion capacity values of CuO measured by the two methods are consistent, which are of 1.20 mmol CuO/100 m² CeO₂. In addition, the results reveal that highly dispersed Cu²⁺ ions are formed at low CuO loadings and that increasing the CuO content to a value higher than its dispersion capacity produces crystalline CuO after the surface vacant sites on CeO₂ are filled. The atomic composition of the outermost layer of the CuO/CeO₂ samples has been probed by using static secondary ion mass spectroscopy (SSIMS), and the ratim of Cu/Ce are found to be 0.93 and 0.46 for the 1.22 and 0.61 mmol CuO/CeO₂ samples respectively. Temperature-programmed reduction (TPR) profile with two reduction peaks at 156 and 165°C suggests that the reduction of highly dispersed Cu²⁺ ions consists of two steps and is easier than that of CuO crystallites, in which the TPR profile has only one reduction peak at about 249°C. The above experimental results are in good agreement with the prediction of the incorporation model. Project supported by the National Natural Science Foundation of China.