Effects of enzyme treatment and skin extraction on varietal volatiles in Spanish wines made from Chardonnay, Muscat, Airén, and Macabeo grapes

Varietal compounds have been analyzed in wines prepared in the laboratory from four grape varieties grown in Spain. The possibilities for enhancing their aroma afforded by addition of glycosidase enzymes and steeping with the skin were studied. Both treatments increased substances responsible for varietal aroma in all wines, the effect being particularly significant for benzyl alcohol.     

Determination of Aroma Compounds in Blackberry by GC/MS Analysis

The aromatic composition of five blackberry cultivars (Bursa 2, Navaho, Nessy, Chester Thornless, and Jumbo) was studied. The Im-SPME (Immersion Solid Phase Micro Extraction) extraction technique was applied and the samples were analyzed by GC/MS. Furfural and its derivatives were found to be the major aromatic compounds and 5-hydroxymethylfurfural was the most abundant compound in all the blackberry varieties.     

Simultaneous determination of hydride (Se) and non-hydride-forming (Ca,Mg, K,P, S and Zn) elements in various beverages (beer,coffee, and milk), with minimum sample preparation,by ICP–AES and use of a dual-mode sample-introduction system

A method has been developed enabling direct analysis (i.e. after dilution only) of beer, instant coffee, milk, and milk powder by ICP–AES. Analysis of the beverages after dilution with a low concentration of HNO₃ was used for accurate determination of essential minor and trace elements (Ca, Mg, K, P, S, and Zn). Selenium, introduced as the hydride, was determined simultaneously with the other non-hydride-forming elements using the commercial multi-mode sample-introduction system (MSIS). To obtain accurate results, however, some simple pre-treatment was needed. Analysis was also performed after microwave-assisted decomposition of the samples. Three different modes of sample-preparation, i.e. dilution only, partial decomposition (aqua regia treatment), and complete decomposition were compared. The results obtained by use of the three different sample-preparation methods were in very good agreement. Results from analysis of certified reference material (SRM 1459 non-fat milk powder) also verified the accuracy of the methods. The limit of detection obtained for Se using dual-mode sample introduction was 0.5 ng mL^–1, which corresponds to approximately 2 ng g^–1 in beer and approximately 4 ng g^–1 in coffee and milk when using the recommended procedure.     

Analysis of acrylamide in coffee and dietary exposure to acrylamide from coffee

An analytical method for analysing acrylamide in coffee was validated. The analysis of prepared coffee includes a comprehensive clean-up using multimode solid-phase extraction (SPE) by automatic SPE equipment and detection by liquid chromatography tandem mass spectrometry using electrospray in the positive mode. The recoveries of acrylamide in ready-to-drink coffee spiked with 5 and 10 μg l⁻¹ were 96±14% and 100±8%, respectively. Within laboratory reproducibility for the same spiking levels were 14% and 9%, respectively. Coffee samples (n = 25) prepared twice by coffee machines and twice by a French Press Cafetière coffee maker contained 8±3 μg l⁻¹ and 9±3 μg l⁻¹ acrylamide. Five ready-to-drink instant coffee prepared twice contained 8±2 μg l⁻¹. Hence, the results do not show significant differences in the acrylamide contents in ready-to-drink coffee prepared by coffee machine, French Press or from instant coffee. Medium roasted coffee contained more acrylamide (10 μg l⁻¹) than dark roasted coffee (5 μg l⁻¹). Males aged 35–45 years, drinking on average 1.1 l coffee per day are exposed to the highest doses of acrylamide from coffee. The dietary intake of acrylamide from coffee comprises, on an average, 10 μg day⁻¹ for males and 9 μg day⁻¹ for females aged 35–45 years. Probabilistic modelling of the exposure of Danish consumers (all adults) to acrylamide from coffee shows a mean exposure of 6.5 μg day⁻¹ and a 95 percentile of 18 μg day⁻¹.     

Sound absorption properties of polyurethane foams derived from crude glycerol and liquefied coffee grounds polyol

The main objective of this study was to evaluate the sound absorption properties of rigid polyurethane foams (PUFs) produced from crude glycerol (CG) and/or liquefied coffee grounds derived polyol (POL). The lignin content of POL proved to have a major influence on the structure and mechanical properties of the foams. Indeed, the POL content increased the cell size of the foams and their stiffness, which subsequently influenced the sound absorption coefficients. The POL derived foam has slightly higher sound absorption coefficient values at lower frequencies, while the CG foam has higher sound absorption coefficient values at higher frequencies. In turn, the foam prepared using a 50/50 mixture of polyols presents slightly higher sound absorption coefficient values in the medium frequencies range due to a balance between the cell structure and the mechanical properties. The results obtained seem to suggest that the mechanisms involved in sound wave absorption depend on the formulation used to prepare the foams. Additionally higher POL contents improved the thermal stability of PUFs as well as their mechanical properties. From this work the suitability of CG and/or POL derived PUFs as sound absorbing materials has been proven.     

Screening of key odorants and anthocyanin compounds of cv. Okuzgozu (Vitis vinifera L.) red wines with a free run and pressed pomace using GC‐MS‐Olfactometry and LC‐MS‐MS

The principal purpose of the present work is to characterize the aroma, aroma‐active, and anthocyanin profiles of Okuzgozu wines and to observe the effect of the pomace pressing technique on these parameters. A total of 58 and 59 volatile compounds were identified and quantified in free‐run juice wine (FRW) and pressed pomace wine (PW). Alcohols were found as the most dominant group among aroma compounds followed by esters and acids. However, among all these compounds, only 11 and 13 of them could be considered as key odorants in aromatic extracts of FRW and PW, respectively. According to GC‐MS‐O analysis, ethyl octanoate (fruity), phenyl ethyl acetate (fruity), and 2‐phenyl ethanol (flowery) were found as the main contributors to the overall scent of both wines. Beyond the aroma profiles, anthocyanin contents of both types of wines were also investigated, and total 14 and 15 anthocyanins were identified and quantified in FRW and PW. Malvidin‐3‐glycoside and its acetyl and coumaroyl forms were identified as the dominant anthocyanins in both wines. It is worth noting the pressing application (2.0 atm) led to an increase of some unpleasant notes in the aroma providing chemical, pharmacy, and fermented aromas in wine. On the other hand, the wines produced with pressed pomace presented higher amounts of anthocyanins.     

New Straightforward Synthesis of β‐Damascenone and β‐Damascone Derivatives from β‐Ionone via Retro‐α‐ionol

β‐Damascenone and β‐damascone derivatives, important fragrant compounds, were directly obtained from β‐ionone by a new way via retro‐α‐ionol.     

Comparison of direct mass spectrometry methods for the on‐line analysis of volatile compounds in foods

For the on‐line monitoring of flavour compound release, atmospheric pressure chemical ionization (APCI) and proton transfer reaction (PTR) combined to mass spectrometry (MS) are the most often used ionization technologies. APCI‐MS was questioned for the quantification of volatiles in complex mixtures, but direct comparisons of APCI and PTR techniques applied on the same samples remain scarce. The aim of this work was to compare the potentialities of both techniques for the study of in vitro and in vivo flavour release. Aroma release from flavoured aqueous solutions (in vitro measurements in Teflon bags and glass vials) or flavoured candies (in vivo measurements on six panellists) was studied using APCI‐ and PTR‐MS. Very similar results were obtained with both techniques. Their sensitivities, expressed as limit of detection of 2,5‐dimethylpyrazine, were found equivalent at 12 ng/l air. Analyses of Teflon bag headspace revealed a poor repeatability and important ionization competitions with both APCI‐ and PTR‐MS, particularly between an ester and a secondary alcohol. These phenomena were attributed to dependency on moisture content, gas/liquid volume ratio, proton affinities and product ion distribution, together with inherent drawbacks of Teflon bags (adsorption, condensation of water and polar molecules). Concerning the analyses of vial headspace and in vivo analyses, similar results were obtained with both techniques, revealing no competition phenomena. This study highlighted the equivalent performances of APCI‐MS and PTR‐MS for in vitro and in vivo flavour release investigations and provided useful data on the problematic use of sample bags for headspace analyses. Copyright © 2013 John Wiley & Sons, Ltd.     

On‐line process monitoring of coffee roasting by resonant laser ionisation time‐of‐flight mass spectrometry: bridging the gap from industrial batch roasting to flavour formation inside an individual coffee bean

Resonance‐enhanced multiphoton ionisation time‐of‐flight mass spectrometry (REMPI‐TOFMS) enables the fast and sensitive on‐line monitoring of volatile organic compounds (VOC) formed during coffee roasting. On the one hand, REMPI‐TOFMS was applied to monitor roasting gases of an industrial roaster (1500 kg/h capacity), with the aim of determining the roast degree in real‐time from the transient chemical signature of VOCs. On the other hand, a previously developed μ‐probe sampling device was used to analyse roasting gases from individual coffee beans. The aim was to explore fundamental processes at the individual bean level and link these to phenomena at the batch level. The pioneering single‐bean experiments were conducted in two configurations: (1) VOCs formed inside a bean were sampled in situ, i.e. via a drilled μ‐hole, from the interior, using a μ‐probe (inside). (2) VOCs were sampled on‐line in close vicinity of a single coffee bean's surface (outside). The focus was on VOCs originating from hydrolysis and pyrolytic degradation of chlorogenic acids, like feruloyl quinic acid and caffeoyl quinic acid. The single bean experiments revealed interesting phenomena. First, differences in time–intensity profiles between inside versus outside (time shift of maximum) were observed and tentatively linked to the permeability of the bean's cell walls material. Second, sharp bursts of some VOCs were observed, while others did exhibit smooth release curves. It is believed that these reflect a direct observation of bean popping during roasting. Finally, discrimination between Coffea arabica and Coffea canephora was demonstrated based on high‐mass volatile markers, exclusively present in spectra of Coffea arabica. Copyright © 2013 John Wiley & Sons, Ltd.