Highly diastereoselective multicomponent synthesis of polysubstituted 2-hydroxy-2-trifluoromethylpiperidineswith four and five stereogenic centers

The Michael–Mannich cascade cyclization of cyano olefins, ethyl 4,4,4-trifluoro-3-oxobutanoate, aromatic aldehydes and ammonium acetate provides convenient stereoselective formation of ethyl 5,5-dicyano-4,6-diaryl-2-hydroxy-2-(trifluoromethyl)piperidine-3-carboxylates with fourstereogenic centers and dialkyl 4,6-diaryl-5-cyano-2-hydroxy-2-(trifluoromethyl)piperidine-3,5-dicarboxylates with five stereogenic centers. Ammonium acetate plays dual role, acting as a base and as a nitrogen source.     

基于吸收系数的生脉注射液中聚山梨酯80含量测定新方法

聚山梨酯80又名吐温80，为一种亲水型非离子表面活性剂，是食品、保健品和药品中常用的辅料，作为增溶剂和澄清剂广泛用于中药注射剂。近年来，不良反应的发生使得聚山梨酯80的质量和应用愈加受到重视，有研究认为其加入可能引起注射剂不良反应增加。为避免超量使用，有必要对该辅料的投料加以严格控制。中药注射剂中聚山梨酯80的含量测定是当下研究的热点和难点，可以通过分光光度法、分子排阻-蒸发光散射检测法(SEC-ELSD)、液质联用法(LC-MS)直接测定，也可以水解后法经液相色谱-紫外检测法(HPLC-UV)或气相色谱法(GC)间接测定。但由于聚山梨酯80为聚氧乙烯聚合数目不同的混合物、不同厂家生产的聚山梨酯80化学组分及比例存在较大差异，难以采用统一的转换公式或对照品准确定量。此外，中药注射剂的复杂基质造成的假阳性干扰也对定量提出了挑战。为解决以上问题，以生脉注射液为例，提出基于吸收系数的中药注射剂中聚山梨酯80含量测定新方法。优化检测波长、显色剂种类、液液萃取过程振荡和静置时间，在6个不同品牌仪器上测得聚山梨酯80-硫氰酸钴配合物的吸收系数(E1%_{1 cm})为104.23，相对标准偏差(RSD)为2.08%。生脉注射液稀释10倍后，精密量取供试品溶液1.0 mL，精密加入硫氰酸钴溶液10 mL，二氯甲烷20 mL，涡旋振荡3 min。将混合液移至分液漏斗中，静置30 min，取下层二氯甲烷液，将前1 mL弃去，接收约15 mL，在320 nm处测定吸光度，再根据Lambert-Beer定律，利用获得的吸收系数计算得到聚山梨酯80的含量。方法阴性无干扰，精密度和重复性相对标准偏差均低于3%，平均回收率为98.42%。为进一步验证方法的准确性，分别采用吸收系数法和标准曲线法测定了2个厂家的10批生脉注射液，并与实际投料量比较。配对t检验结果表明，当置信度为95%时，两种方法无显著性差异，吸收系数法测得结果与企业生产中聚山梨酯的实际投料量也无显著性差异。研究采用前人未采用的、灵敏度更高的320 nm为检测波长，显著降低了基质干扰，克服了中药注射剂中聚山梨酯80测定结果与实际投料量难以吻合的问题。吸收系数法无需使用对照品，亦不用制备标准曲线，可为中药注射剂中聚山梨酯80的检查标准提供切实可行的解决方案。所建方法灵敏、准确、快速、简便，为含聚山梨酯80制剂的质量控制提供了关键常数及新的思路。     

负载型CO3[Fe（CN）6]2及CN^—加氢反应的研究

双金属催化剂是一类重要的多相催化剂。其中d电子在催化活性方面起着重要的作用.本文在Co_3[Fe(CN)_6]_2的工作基础上,进一步研究了该配合物在硅胶、氧化铝、以及氧化镁上的热性质,同时考察了CN~-在Co-Fe体系双端基配位的活化加氢,探讨了载体的影响.     

Kinetic study of the crosslinking reaction of 1,2‐polybutadiene with dicumyl peroxide in the absence and presence of vinyl acetate

The crosslinking reaction of 1,2-polybutadiene (1,2-PB) with dicumyl peroxide (DCPO) in dioxane was kinetically studied by means of Fourier transform near-infrared spectroscopy (FTNIR). The crosslinking reaction was followed in situ by the monitoring of the disappearance of the pendant vinyl group of 1,2-PB with FTNIR. The initial disappearance rate (R₀) of the vinyl group was expressed by R₀ = k[DCPO]^0.8[vinyl group]^−0.2 (120 °C). The overall activation energy of the reaction was estimated to be 38.3 kcal/mol. The unusual rate equation was explained in terms of the polymerization of the pendant vinyl group as an allyl monomer involving degradative chain transfer to the monomer. The reaction mixture involved electron spin resonance (ESR)-observable polymer radicals, of which the concentration rapidly increased with time owing to a progress of crosslinking after an induction period of 200 min. The crosslinking reaction of 1,2-PB with DCPO was also examined in the presence of vinyl acetate (VAc), which was regarded as a copolymerization of the vinyl group with VAc. The vinyl group of 1,2-PB was found to show a reactivity much higher than 1-octene and 3-methyl-1-hexene as model compounds in the copolymerization with VAc. This unexpectedly high reactivity of the vinyl group suggested that an intramolecular polymerization process proceeds between the pendant vinyl groups located on the same polymer chain, possibly leading to the formation of block-like polymer. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4437–4447, 2004     

Electrospinning of ultrafine cellulose acetate fibers: Studies of a new solvent system and deacetylation of ultrafine cellulose acetate fibers

Electrospinning of cellulose acetate (CA) in a new solvent system and the deacetylation of the resulting ultrafine CA fibers were investigated. Ultrafine CA fibers (∼2.3 μm) were successfully prepared via electrospinning of CA in a mixed solvent of acetone/water at water contents of 10–15 wt %, and more ultrafine CA fibers (0.46 μm) were produced under basic pH conditions. Ultrafine cellulose fibers were regenerated from the homogeneous deacetylation of ultrafine CA fibers in KOH/ethanol. It was very rapid and completed within 20 min. The crystal structure, thermal properties, and morphology of ultrafine CA fibers were changed according to the degree of deacetylation, finally to those of pure cellulose, but the nonwoven fibrous mat structure was maintained. The activation energy for the deacetylation of ultrafine CA fibers was 10.3 kcal/mol. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 5–11, 2004     

Effect of oxygen exposure on the magnetic properties of ultrathin Co/Ge(1 1 1) films

Influences of oxygen exposure on the magnetic properties of Co/Ge(1 1 1) ultrathin films have been investigated by surface magneto-optic Kerr effect technique. As the oxygen exposure increases on Co/Ge(1 1 1) films, their magnetic properties could be modified. As an example for 15 ML Co/Ge(1 1 1) films, the coercivity increases from 730 to 920 Oe and the remanence Kerr intensity is reduced for 500 Langmuir (L) of oxygen exposure. Corresponding compositions analyzed by Auger electron spectroscopy measurement shows that the amount of oxygen on the surface layers increases with increasing the oxygen exposure time. Oxygen distributes on the topmost layers of the film. The adsorbed oxygen influences the electronic density of states of Co and results in the changes of the magnetic properties. Besides, the appearance of O/Co/Ge interface could modify the stress anisotropy, and as a result the coercivity of ultrathin Co/Ge(1 1 1) film is enhanced.     

光泽精化学发光体系的研究与应用

对光泽精化学发光体系的动力学性质、荧光光谱、化学发光光谱及化学发光机理进行研究和探讨。详细研究了光泽精 - H2 O2 - Co( )流动注射化学发光体系的最佳分析条件。结果表明 ,当光泽精 (L c)为 2 .5×10 - 5mol/L、H2 O2 为 0 .5 mol/L、Na OH为 0 .4 mol/L、CTMAB为 2 .0× 10 - 5mol/L时 ,测定 Co( )的校准曲线线性范围为 0 .0 5— 2 0 0μg/m L ,检出限为 0 .0 1μg/m L。对 10μg/m L Co( )连续测定 7次 ,相对标准偏差为 1.7%。     

二阶导数光谱-峰面积积分法同时测定芦荟中痕量铁(Ⅱ)和钴(Ⅱ)

在 1,10 -邻菲罗啉显色体系中 ,引入二阶导数光谱 -峰面积积分技术 ,建立了同时测定痕量铁 ( )和钴 ( )的新方法。该法可有效消除共存离子的干扰 ,提高了准确度和灵敏度。对铁和钴的表观摩尔吸光系数分别为 εFe5 .4 5× 10 6 L·mol-1·cm-1,εCo 1.1× 10 4 L· mol-1· cm-1;铁含量在 0 .0— 8.5 μg·m L-1,钴含量在 0 .0— 7.3μg· m L-1范围内遵守比耳定律。可用于芦荟中铁和钴的同时测定 ,结果令人满意