Efficient microwave induced direct α-halogenation of carbonyl compounds

A novel and direct method for the synthesis of α-halocarbonyl compounds using sequential treatment of carbonyl compounds with [hydroxy(tosyloxy)iodo]benzene followed by magnesium halides under solvent-free microwave irradiation conditions is described.     

Ionic liquids as reagents and solvents in conjunction with microwave heating: rapid synthesis of alkyl halides from alcohols and nitriles from aryl halides

We show that using ionic liquids as reagents in conjunction with microwave heating it is possible to prepare primary alkyl halides from the corresponding alcohols rapidly. Using ionic liquids as solvents in conjunction with microwave heating it is possible to prepare aryl nitriles from the corresponding aryl bromides or iodides. The scope and limitations of using microwave-promotion as a tool in these reactions is discussed.     

Application of polymer-supported triphenyl phosphine in the palladium-catalyzed cyanation reaction under microwave conditions

A variety of aryl nitriles were prepared in excellent yields from the palladium acetate catalyzed coupling of aryl halides with Zn(CN)₂ using polymer-supported triphenyl phosphine as the ligand and dimethylformamide as solvent under microwave irradiation conditions.     

New isothermal equation of state of solids applied to high pressures

In the present paper, a new two-parameter inverted equation of state (EOS) is developed which is found to be working very well in the high-pressure region. To check its success and validity, this EOS has been applied in a number of solids. The computed volume compression is found to be in very good agreement with the experimental data in the whole range of pressure in all the solids. The minimum and the maximum pressure range used in the present study is 0–320 kbar and 0–3000 kbar, respectively.     

Imidazol(in)ium carboxylates as N-heterocyclic carbene ligand precursors for Suzuki-Miyaura reactions

Simple catalysts formed in situ from palladium acetate and a variety of imidazolium and imidazolinium carboxylates and dithiocarboxylates have been screened in the coupling of aryl halides with trans-2-phenylvinylboronic acid. Imidazol(in)ium carboxylates show an excellent activity, which compares to that displayed by the parent imidazol(in)ium chlorides, whereas imidazol(in)ium dithiocarboxylates are poorly efficient. Interestingly, the base employed exerts a profound influence on the trans/cis stereochemistry of the coupling product.     

Interconnection between the Structures and Sorption Characteristics of Mesophase Materials of MCM-41 Type Containing Alkylpyridines

Under the conditions studied for the synthesis of mesophase materials with alkylpyridinium halides an increase in the density of packing of these molecules in the encapsulated micelles was observed with an increase in the length of the alkyl radicals. The difference in the density of packing of these surface active reagents (SAR) depended to a considerable extent on the perfection of the hexagonal structure and the characteristic absorption properties of the mesophase materials of MCM-41 type.     

Early-stage flocculation kinetics of polystyrene latex particles with polyelectrolytes studied in the standardized mixing: Contrast of excess and moderate polyelectrolyte dosage

Standardized mixing procedure was applied to the analysis of flocculation of polystyrene latex (PSL) particles with polyelectrolytes. After confirming the initial enhancement of flocculation rate in the very beginning followed by abrupt stop with excess dosage, attention was shifted to the system of moderate dosage. In the former, effects of ionic strength were further analyzed to find the consistency with adsorption isotherm. In the latter, flocculation started slowly in the beginning, sometime slower than salt-induced rapid coagulation, however, the rate gradually increases in the middle stage. Often, the increased rate exceeds that of salt-induced rapid coagulation. This behavior emerged more clearly in the case of lower ionic strength. This is the indication that the rate of relaxation of polymer on the colloidal surface is a function of surface coverage and ionic strength. The ultimate degree of flocculation is usually higher than that observed for excess dosage. The size distribution of flocs was also examined, however, no clear difference between different experimental conditions was confirmed for the same degree of flocculation.     

Solubility and Ionic Processes in the Cu X 2? MX ?H2O ( X ?=Cl?, Br?; M +=Li+, Na+, K+, NH4+, Cs+) Systems

Summary.  Solubility isotherms in the CuBr₂−MBr−H₂O (M ⁺ = Li⁺, Na⁺, Cs⁺) systems at 298.15 K were measured. The results together with other available literature data for copper chloride and bromide systems were treated by hydration analysis, and comparative discussion of ionic processes taking place in the respective saturated solutions was performed. Corresponding author. E-mail: jitka@prfdec.natur.cuni.cz Received August 6, 2002; accepted (revised) November 29, 2002 Published online April 3, 2003     

On the stereochemistry of the Horner—Emmons reaction between 3-functionally substituted 2-methyl-2-propenylphosphonates and aliphatic aldehydes

The reaction of diethyl 3-ethoxycarbonyl-2-methyl-2-propenylphosphonate (1a) with 3-methylbutanal (2) in heterogeneous MOH (solid)-benzene systems in the presence of 5–10 mol.% of benzyltriethylammonium chloride (BTEAC) gives the reaction product (3) with a higher, for M=K, or lower, for M=Li, ratio of 2E,4E and 2Z,4E-stereoisomers than that observed in the absence of BTEAC. Tetrabutylammonium bromide (TBAB) as a catalyst of the reaction1a + 2 3 in the system KOH (solid)-wet benzene leads to a higher [2E,4E-3][2Z,4E-3] ratio than BTEAC; this ratio grows from 4456 without TBAB to 8020 at 100 mol.% of TBAB. In the latter case the stereochemical outcome of the reaction is similar to that obtained when tetrabutylammonium hydroxide in dry benzene is used as the deprotonating agent. The corresponding diisopropyl phosphonate (1b) and 3,7-dimethyloctanal (4a) interact in the system KOH (solid)-wet benzene-TBAB to give hydroprene (5) containing 88 % of the 2E,4E-isomer (5a) while in the case of 1 equiv. of [(n-Bu₄)N]OH in dry benzene the content of5a is 92 %. Diisopropyl 3-isopropoxycarbonyl-2-methyl-2-propenylphosphonate (1c) and 7-methoxy-3,7-dimethyloctanal (4b) under either of these conditions afford methoprene (6) containing 93 % of the 2E,4E-isomer.Part 6, see ref. 1.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 6, pp. 1094–1098, June, 1993.     

Pulse radiolysis study of I− oxidation with radical anions Cl2 ⋅− in an aqueous solution

Radiation-chemical transformations of chloride solutions in the presence of iodide additives were studied by pulse radiolysis. Radical anion Cl₂ ^⋅− oxidize I⁻ ion, while in the secondary reactions Cl₂ reacts with I⁻ to form a mixed trihalide ion ICl₂ ⁻. A reaction model that satisfactorily describes the experimental data was proposed. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 6, pp. 1336–1340, June, 2005.