Al-pillared clays supported rare earths and palladium catalysts for deep oxidation of low concentration of benzene

Al-pillared clays supported rare earths (RE/Al-PILC) are prepared and used as supports of palladium catalysts for deep oxidation of low concentrations of benzene (130-160 ppm). The supports and catalysts are characterized by X-ray powder diffraction (XRD), FT-IR, BET, transmission electron microscopy (TEM) and temperature-programmed reduction (H₂-TPR). The results show that Al-pillaring results in a strong increase in the basal spacing (d_0 0 1) from about 1.2 to 1.8 nm, and an increase in the BET surface area from 63.6 (±3.2) to 238.8 (±11.9) m²/g. Activity tests of deep oxidation of low concentration benzene show catalysts supported on Al-PILC and RE/Al-PILC are obviously more active than that on raw clay. Pd/6% Ce/Al-PILC, in particular, can catalyze the complete oxidation of low concentration benzene at a temperature as low as about 290 °C.     

Excess molar enthalpies of binary mixtures of 1-hexene with some cyclic and aromatic hydrocarbons at 298.15 K

Microcalorimetric measurements of excess molar enthalpies, at 298.15 K, are reported for the four binary systems formed by mixing 1-hexene with the cycloalkanes: cyclohexane and methylcyclohexane, and with the aromatic hydrocarcons: benzene and toluene. Smooth Redlich-Kister representations of the results are presented. It was found that the Liebermann-Fried model also provided good representations of the results.     

Pervaporation of benzene/cyclohexane mixtures using ion-exchange membrane containing copper ions

The sorption, diffusion, and pervaporation (PV) properties of benzene/cyclohexane (Bz/Cx) mixtures on cation-exchange membranes containing copper ions (Cu(II)) were investigated. The equilibrium sorption isotherms of pure vapors in the membranes and the partial solubility of binary solutions in the membranes were described using the UNIQUAC model. The τ_iM and τ_Mi values were 0.978 and 0.591 for Bz, and 0.922 and 0.475 for Cx. The transient regimes of vapor sorption were employed to calculate the concentration-dependent diffusion coefficients. Long’s model sufficiently explained the diffusivity of Bz and Cx in the membranes. The pre-exponential factors were 3×10⁻¹³ m²/s and the plasticization factors were 3.0 and 3.6 for Bz and Cx, respectively. Excellent agreement was found with the experimental results applying the solubility and diffusivity data to simulate the pervaporation performance (flux and selectivity) using the modified Maxwell–Stefan equation. The membrane containing Cu(II) demonstrates better facilitating capability for Bz transport than that with Na(I), mainly due to its preferential sorption property toward Bz. Replacing Na(I) with Cu(II) into a Neosepta membrane resulted in better separation efficiency and higher Bz flux throughout the entire Bz concentration range.     

Construction of solid-liquid phase diagrams in ternary systems by titration calorimetry

Titration calorimetry was used to construct the solid-liquid equilibrium line in ternary systems containing the solute and an aqueous mixed solvent by measuring the heat of dissolution of the solid solute during successive additions of the liquid solvent. The plot of cumulated heats versus the mole ratio, n_solvent/n_solute, yields two (almost) linear increases of different slopes. These two lines represent successively the enthalpy of dissolution then the enthalpy of dilution of the medium; their intersection gives the solubility and the enthalpy of dissolution of the solute. Phase diagrams have been established over the whole concentration range for o-anisaldehyde, 1,3,5-trimethoxybenzene and vanillin, in water + methanol, +ethanol, or +n-propanol at 303, 313 and 318 K.     

铜离子交换改性的沸石催化剂上甲烷的非氧芳构化

已有研究表明，ＭｏＯ３／ＨＺＳＭ５是甲烷非氧芳构化的优良催化剂，在９７３Ｋ下甲烷转化率达６％～８％，苯选择性高于８０％，这为非氧气氛下甲烷的芳构化反应展示了非常诱人的前景［１～１２］．但是，该催化剂的活性和稳定性尚有待进一步提高，目前已有使用Ｐｔ，...     

The benzene ring as a dipolarophile: Reactions of monosubstituted benzenes with tetracyanoethylene oxide

Summary The reaction of tetracyanoethylene oxide on one hand and toluene, chlorobenzene, fluorobenzene, anisole, and nitrobenzene, on the other, has been studied. Toluene and the halogenobenzenes yield mixtures of monoadducts, anisole yieldp-methoxyphenylmalononitrile and its dimer and nitrobenzene does not react. These results are discussed with the help of a qualitative orbital model.¹H-NMR analysis of some monoadducts has been carried out.

---

Der Benzolring als Dipolarophil: Reaktionen monosubstituierter Benzole mit Tetracyanoethylenoxid

Zusammenfassung Es wurden die Reaktionen von Tetracyanoethylenoxid mit Toluol, Chlorbenzol, Fluorbenzol, Anisol und Nitrobenzol untersucht. Toluol und die Halogenbenzole ergaben Mischungen von Monoaddukten, Anisol ergabp-Methoxyphenylmalononitril und sein Dimer, Nitrobenzol zeigte keine Reaktion. Diese Resultate werden mit Hilfe eines qualitativen Orbitalmodells diskutiert. Die Analyse einiger Monoaddukte erfolgte mittels¹H-NMR-Analyse.

     

Determination of the micelle-solute association constants of some benzene and naphthalene derivatives by micellar high performance liquid chromatograph

Summary The interaction of some benzene and naphthalene derivatives with sodium dodecyl sulphate, hexadecyltrimethylmmonium bromide and polyoxyethylene [23] dodecanol micelles has been evaluated by high operformance liquid chromatography using micellar mobile phases. The micelle-solute association constants have been obtained for the compounds investigated. Good correlation between free energy of transfer for water-micelles and for octanol-water has been observed.     

Synthese von Clathratverbindungen des Typs Cd(mea) m [Pd(CN)4] ·nG

The preparation, identification and some properties of three new clathrate compounds Cd(mea)[Pd(CN)₄] · 2C₆H₆, Cd(mea)₂[Pd(CN)₄] · C₄H₄S and Cd(mea)₂[Pd(CN)₄] · C₄H₄NH (mea = HO-CH₂-CH₂-NH₂) are described.

     

介孔分子筛的制备与苯加氢反应的催化性能

1992年美国Mobil公司的研究人员首次报道合成出具有规则孔结构的M41S系列介孔分子筛材料.由于介孔材料独特的性质,引起了人们极大的兴趣,在其合成与性能等方面进行了大量的研究,合成出了多种系列不同性能的介孔分子筛,并研究了介孔分子筛作为催化剂或催化剂载体在各类催化反应中的催化性能.     

苯在Pluronic F127和P123胶束水溶液中的增溶动力学

发展了不分离胶束的增溶动力学数据分析模型,以此考察苯在F127和P123胶束水溶液中的增溶动力学行为.实验发现,这二种胶束增溶苯的速度较快,温度升高进一步促进了增溶.