Solid sampling Fourier transform infrared determination of Mancozeb in pesticide formulations

A series of approaches have been assayed for FTIR determination of Mancozeb in several solid commercial fungicides using different calibration strategies. The simplest procedure was based on the use of the ratio between the absorbance of a characteristic band of Mancozeb and that of a KSCN internal standard measured in the FTIR spectra obtained from KBr pellets. It was employed the quotient between peak height absorbance values at 1525 cm⁻¹ for Mancozeb and 2070 cm⁻¹ for KSCN. In these conditions a precision as relative standard deviation (RSD) of 0.6% and a relative accuracy error of 0.8% (w/w) were found. For complex formulations, containing other compounds with characteristic absorption bands at different wavenumbers than Mancozeb, one of them was used as internal reference being employed the standard addition approach. In this case, the Mancozeb bands at 1525 cm⁻¹ or at 1289 cm⁻¹ were employed, being used the ferrocyanide band at 2075 cm⁻¹ as internal reference. RSD values between 0.7-1.4% and a relative accuracy error of 3% (w/w) were found. A third strategy was based on the use of partial least squares (PLS) calibration. A reference set was prepared mixing Mancozeb, Kaolin, Cymoxanil and KBr, being predicted the Mancozeb concentration in pesticide formulations by using the quotient between absorbance bands of Mancozeb and those of Cymoxanil. In these conditions a relative accuracy error of 0.6% (w/w) and a relative standard deviation of 1.3% were found.     

Zur direkten ma?analytischen Bestimmung von Carbamaten als sehr schwache S?uren

Zusammenfassung Eine direkte maßanalytische Methode zur Bestimmung diverser Carbamate wird beschrieben. Die potentiometrische Titration mit käuflicher Tetra-n-butylammoniumhydroxid-Lösung, verdünnt mit Propanol-(2), ist bequem durchzuführen, und die erhaltenen Titrationskurven gestatten eine korrekte Auswertung.

---

Direct volumetric determination of carbamates as very weak acids

Summary A volumetric procedure for the determination of some carbamates is described. The potentiometric titration with commercial tetra-n-butylammonium hydroxide solution diluted with propanol-(2) is convenient and the obtained titration curves permit a correct calculation.

     

环境水中甲基对硫磷、对硫磷和辛硫磷农药残留的SPE-HPLC分析

采用离线固相萃取 (SPE)富集 -高效液相色谱(HPLC)分离和紫外分光光度法检测 ,对环境水中甲基对硫磷、对硫磷和辛硫磷3种有机磷农药进行分析;固相萃取用C18 萃取柱 ,用甲醇洗脱 ,高效液相色谱分离以Shim_PackCLCODS柱(150mm×4.6mmid,5μm)为分离柱 ,流动相为甲醇 -水(体积比70∶30) ,紫外检测波长为280nm;该法稳定可靠 ,回收率高     

GC-MS法测定粮谷及油料中55种有机磷农药残留量

采用ASE-300快速溶剂萃取仪提取样品中农药残留量,提取液经二氯甲烷液-液分配、凝胶色谱柱（GPC）净化,固相萃取柱（活性炭）再净化,浓缩定容后,用气相色谱-质谱仪（GC-MS）测定,外标法定量.采用选择离子检测进行阳性确证.选择玉米、糙米、大豆、花生为实验样品、敌敌畏等55种农药添加水平在0.5～2.00 mg/kg时,该方法回收率为68%～117%;精密度为4.04%～11.76%;方法测定低限为0.005～0.100 mg/kg,各项指标均满足有关要求.     

串联质谱法在农药残留分析中的应用

农药残留问题已经成为全球关注的热点问题,尤其是农产品和食品中的农药残留更受到各国政府和公众的普遍关注。快速、准确、灵敏的农药残留分析和检测技术已经成为保障食品安全的有效手段,是当前农药残留分析研究和发展的方向。1983年,McLafferty等发明了串联质谱技术(MS-MS),目前已发展成为一种成熟的技术,在许多研究领域发挥了巨大作用。同样,在农药残留分析领域,串联质谱技术也越来越体现出其定性准确、排除干扰能力强以及灵敏度高的特点。     

Automated at-line solid-phase extraction-gas chromatographic analysis of micropollutants in water using the PrepStation

A fully automated at-line solid-phase extraction-gas chromatography procedure has been developed for the analysis of aqueous samples using the PrepStation. The sample extract is transferred from the sample preparation module to the gas chromatograph via an autosampler vial. With flame-ionization detection, limits of determination (S/N=10) of 0.05–0.13 μg/l were obtained for the analysis of HPLC-grade water when modifying the PrepStation by: (i) increasing the sample volume to 50 ml, (ii) increasing the injection volume up to 50 μl, and (iii) decreasing the desorption volume to 300 μl. The HP autosampler had to be modified to enable the automated “at-once” on-column injection of up to 50 μl of sample extract. The amount of packing material in the original cartridge had to be reduced to effect the decrease of the desorption volume. The total set-up did not require any further optimization after having set up the method once. The analytical characteristics of the organonitrogen and organophosphorus test analytes, i.e. recoveries (typically 75–105%), repeatability (2–8%) and linearity (0.09–3.0 μg/l) were satisfactory. The potential of the system was demonstrated by determining triazines and organophosphorus pesticides in river Rhine water at the 0.6 μg/l level using flame-ionization and mass-selective detection. No practical problems were observed during the analysis of more than 100 river water samples.     

Quality control of Metamitron in agrochemicals using Fourier transform infrared spectroscopy in the middle and near range

Two vibrational spectrometry-based methodologies were developed for Metamitron determination in pesticide formulations. Fourier transform-middle infrared (FT-MIR) procedure was based on the extraction of Metamitron by CHCl₃ and latter determination by peak area measurement between 1556 and 1533 cm⁻¹, corrected with a two points baseline established from 1572 to 1514 cm⁻¹. Fourier transform-near infrared (FT-NIR) determination was made after the extraction of Metamitron in acetonitrile and measuring the peak area between 6434 and 6394 cm⁻¹ corrected using a two points baseline defined between 6555 and 6228 cm⁻¹. Repeatability, as relative standard deviation, of 5 independent measurements at mg g⁻¹ concentration level, of 0.16% and 0.07% for MIR and NIR and a limit of detection of 0.03 and 0.004 mg g⁻¹ were obtained for MIR and NIR, respectively.NIR determination provides a sample frequency of 120 h⁻¹, higher than that found by MIR and liquid chromatographic methods (60 and 15 h⁻¹, respectively). On the other hand, the NIR method reduces the solvent consumption and waste generation, to only 1 ml acetonitrile per sample as compared with 3.4 ml chloroform required for the MIR determination and 60 ml acetonitrile used in the chromatographic reference procedure. So, vibrational procedures can be considered serious alternatives to long and time consuming chromatographic methods usually recommended for quality control of commercially available pesticide formulations.     

光学活性甲苄菊酯的合成及其结构与活性关系的研究

本文改进了Goffinet方法,完成了(±)-trans菊酸的拆分;改进了Campbel?方法,只用一种拆分剂(奎宁)完成了对(±)-cis菊酸的拆分。用IR、~1HNMR、旋光度测定等方法确定了各甲苄菊酯光学异构体的结构。生物试验表明结构与活性有如下关系:1,各异构体中以1R-酯的杀虫活性为高,尤其(-)-(1R,3R)-trans甲苄菊酯对全部测试昆虫均显示较高的杀虫活性;2,昆虫不同,各异构体的活性次序也略有差异。     

Coadsorption of carbofuran and lead at the water/silica interface. Possible impact on environment

Despite its extremely weak adsorption at the water/silica interface, carbofuran can, however, induce the coadsorption of metallic salts, like, for example, lead nitrate, and thus enhance its adsorption. We quantitatively studied this phenomenon with a depletion method and under concentration conditions close to the environmental ones. Heavy metal salt was found to positively adsorb, whereas carbofuran relative adsorption is generally slightly negative. This study provides evidence that considering these facts is of paramount importance in environmental prospects. To cite this article: G. Elmanfe et al., C. R. Chimie 9 (2006).     

Analysis of selected pesticides and alkylphenols in human cord blood by gas chromatograph-mass spectrometer

A total of seven pesticides and eight alkylphenols were monitored using this method for the determination of their trace levels in human cord blood. The pesticides are lindane, diazinon, α-endosulfan, β-endosulfan, endosulfan sulfate, chlorpyrifos and endrin; while the alkylphenols are 4-n-butylphenol, 4-n-pentylphenol, 4-n-hexylphenol, 4-t-octylphenol, 4-n-heptylphenol, nonylphenol, 4-n-octylphenol and bisphenol A. The pesticides and alkylphenols in the cord blood samples were extracted with solid phase extraction IST C18 cartridges and analyzed by selected ion monitoring mode using quadrapole detector in Shimadzu QP-5000 gas chromatograph-mass spectrometer. Trace levels of pesticide and alkylphenols in the range of non-detectable to 15.17 ng ml⁻¹, were detected in the human cord blood samples. This technique of monitoring the levels of endocrine-disruptors in blood samples is consistent, reliable and cost effective while reducing wastage of time and solvents.