煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

非晶调制多层膜Nb/Si中的互扩散研究

利用原位Ｘ射线衍射技术得到非晶调制多层膜Ｎｂ／Ｓｉ中的互扩散系数与退火温度的关系，调制周期Ｌ＝３.２ｎｍ的非晶调制多层膜是用粒子溅射方法制备的．温度范围为４２３—５２３Ｋ的有效互扩散系数通过原位测量多层膜的一级调制峰强度与退火温度之间的关系而得到．利用缺陷陷阱延迟扩散机制解释了所得到的扩散系数与退火温度的关系．建立了可以解释较小前置系数的模型 关键词：     

基于液晶光阀的全息照相控光仪

设计了通过液晶光阀自动调整全息照相物光和参考光辐照比至最佳状态,同时能实现曝光时间自动控制的控光仪.该仪器巧妙运用液晶光阀和硅光电池器件,使测量、调整、自控一体化,从而提高拍摄优质全息图的工作效率.     

微振动光电检测与数据采集系统的设计

提出了一种新的光学非接触式测量方法测量了物体的微振动振幅。用激光作为光源,以四象限硅光电池[1]作为光电探测器,借助三角测量原理,投射在振动源表面的激光反射光束在光电探测器上产生平面位移,将位移信号放大,通过A/D模块采集电压数值,并通过串口通信机制在PC终端实时显示。实验结果表明,该方法原理正确,灵敏度高,便于实现连续、快速、自动化检测,在工业在线检测方面具有良好的应用前景。     

Structural and Electrical Characteristics of Pb（Zr0.53,Ti0.47）O3 Thin Films Deposited on Si （100） Substrates

Pb(Zr0.53, Ti0.47)O3 (PZT) films were directly deposited on Si substrates without a buffer layer by pulsed laser deposition. Only(110)-oriented PZT peaks (other than Si substrate peaks) were observed from the XRD data. The electrical properties of the PZT/Si capacitor were characterized in terms of both the capacitance versus voltage (C-V) and current versus voltage (I-V) measurements. The clockwise trace of the C-V curve shows ferroelectric polarization switching, as is expected. From the I-V curves, the Schottky emission and spacecharge-limited-current behaviour are found to be the mainly leakage current mechanism in a certain electric field range in the negative and positive bias, respectively.     

Fabrication of Dendrimer－like PAMAM Based on Silica Nanoparticles

A G 4.0 dendrimer-like poly (amido amine) (PAMAM) based on silica nanoparticles was fabricated via a divergent approach.It was built from γ-aminopropyi silica nanoparfides (APSN) core via repetitive addition of acrylate (MA) and hexylenediamine (HDA). FT-IR and EA were used to monitor the progress of dendrimer during each step. The amino group content of the resulting product increased from 0.49 to 3.72 mmol/g after the 4th generation. In addition, the percentage of grafting increased with increasing generation and reached to 65.9% after 4th generation. It was found that the resulting silica nanoparticles could be dispersed in methanol with a mean hydrodynamic particle diameter of 152.7 nm although the silica nanoparticles had agglomerated during the storage period.     

Deposition of Hydrogen-Free Silicon Nitride Thin Films by Microwave ECR plasma Enhanced Magnetron Sputtering at Room Temperature

Hydrogen-free silicon nitride （SiNx） films were deposited at room temperature by microwave electron cyclotron resonance （MW-ECR） plasma enhanced unbalance magnetron sputtering system. Both Fourier-transform infrared spectroscopy and x-ray photoelectron spectroscopy are used to study the bonding type and the change of bonding structures of the silicon nitride films. The results indicate that the chemical structure and composition of SiNx films deposited by this technique depend strongly on the N2 flow rates, the stoichiometric SiNx film, which has the highest hardness of 22.9 GPa, could be obtained at lower N2 flow rate of 4 sccm.     

电致发光色纯性增强的硅基有机微腔

报道了硅基有机微腔的电致发光（EL）.该微腔由上半透明金属膜、中心有源多层膜和多孔硅分布Bragg反射镜（PS DBR）组成.半透明金属膜由Ag（２０nm）构成，充当发光器件的负电极和微腔的上反射镜.有源多层膜由Al (1 nm) / LiF(05 nm) /Alq3/Alq3:DCJTB/NPB/CuPc/ITO/SiO2组成，其中的Al/LiF为电子注入层，ITO为正电极，SiO2为使正、负电极电隔离的介质层.该PS DBR是采用设备简单、成本低廉且非常省时的电化学腐蚀法用单晶Si来制备的；该PS 关键词： 电化学腐蚀 电致发光 窄峰发射 硅基有机微腔     

步进扫描时间分辨光谱及其在太阳电池光电导上的应用

建立傅里叶变换步进扫描时间分辨光电导光谱，并研究太阳电池中与转换效率密切相关的少数载流子寿命.实验选取三种典型的硅太阳电池(单晶硅样品1、多晶硅样品2和多晶硅样品3 )，发现其瞬态光电导的上升和衰退曲线可以分别用两个简单的指数函数描述.由于有复合中心的参与，复合过程中少数载流子的寿命比产生过程中的寿命短.为验证实验结果的可靠性，采用了提取样品少数载流子的体寿命和计算其有效扩散长度两种方法.通过与太阳电池暗伏安特性和负载特性研究相结合，进一步分析和讨论了少数载流子寿命与短路电流、开路电压和转换效率的关系.同时探讨了步进扫描时间分辨光谱实验的其他用途. 关键词： 步进扫描 时间分辨 硅太阳电池 瞬态光电导     

硅光电二极管激光损伤阈值随激光脉宽的变化

 对飞秒激光辐照下硅光电二极管损伤阈值进行了实验测量，对从1s到60fs不同脉宽激光辐照下硅光电二极管损伤阈值进行了讨论。实验数据表明，在1s到10ns脉宽范围内损伤所需能量密度近似而非严格地与脉宽的平方根成正比。信号分析表明硅光电二极管的损伤主要由热效应造成，而60fs激光辐照下的损伤阈值为0.1J/cm2，明显偏离普通温度分布预言的趋势。