基于MOF (Cu)@biochar气凝胶的制备及其在缓释氮肥上的应用

以羧甲基纤维素(CMC)、明胶和MOF(Cu)@biochar为原料,采用简单有效的冷冻干燥方法制备了(CMC/Gelatin/MOF(Cu)@biochar)杂化气凝胶,并用傅里叶变换红外光谱(FT-IR)、热重分析(TG)、X射线粉末衍射(XRD)、扫描电镜(SEM)和X射线光电子能谱(XPS)技术对其进行了表征;研究了MOF(Cu)@biochar含量、pH和不同的盐水溶液对杂化气凝胶溶胀行为的影响;以该气凝胶负载氯化铵,制备了一种新型缓释肥料(SRF),并研究了含2%(wt)SRF的沙性土壤的保水能力;SRF在土壤中第30天的累积释放率为79.4%;肥料在土壤中释放符合非Fickian扩散和阳离子交换的协同作用机理。     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

溶胶-凝胶制备技术与新型催化材料Ⅲ.溶胶粒子表面修饰方法制备催化膜

提出用溶胶粒子表面修饰方法，结合溶胶凝胶技术制备无机催化膜．该方法的基本原理是利用合适的金属配合物在胶粒表面的吸附作用，经溶胶凝胶过程，将活性组分结合到无机膜中．实验测定结果表明：（ＮｉＥＤＴＡ）２－，ＶＯ－３，ＭｏＯ２－４，（Ｐｄ（ＮＨ３）４）２＋，ＰｄＣｌ２－４，ＰｔＣｌ２－６和ＲｈＣｌ３－６可用来修饰ＡｌＯＯＨ溶胶．以Ｐｄ／γＡｌ２Ｏ３催化膜的制备为例，经三次溶胶凝胶过程，可制得无裂缺的厚度为９μｍ的Ｐｄ／γＡｌ２Ｏ３催化膜，膜材料的平均孔直径为６ｎｍ，Ｐｄ被均匀地分布在膜的顶层，其平均粒径为２３ｎｍ．     

非晶调制多层膜Nb/Si中的互扩散研究

利用原位Ｘ射线衍射技术得到非晶调制多层膜Ｎｂ／Ｓｉ中的互扩散系数与退火温度的关系，调制周期Ｌ＝３.２ｎｍ的非晶调制多层膜是用粒子溅射方法制备的．温度范围为４２３—５２３Ｋ的有效互扩散系数通过原位测量多层膜的一级调制峰强度与退火温度之间的关系而得到．利用缺陷陷阱延迟扩散机制解释了所得到的扩散系数与退火温度的关系．建立了可以解释较小前置系数的模型 关键词：     

基于液晶光阀的全息照相控光仪

设计了通过液晶光阀自动调整全息照相物光和参考光辐照比至最佳状态,同时能实现曝光时间自动控制的控光仪.该仪器巧妙运用液晶光阀和硅光电池器件,使测量、调整、自控一体化,从而提高拍摄优质全息图的工作效率.     

微振动光电检测与数据采集系统的设计

提出了一种新的光学非接触式测量方法测量了物体的微振动振幅。用激光作为光源,以四象限硅光电池[1]作为光电探测器,借助三角测量原理,投射在振动源表面的激光反射光束在光电探测器上产生平面位移,将位移信号放大,通过A/D模块采集电压数值,并通过串口通信机制在PC终端实时显示。实验结果表明,该方法原理正确,灵敏度高,便于实现连续、快速、自动化检测,在工业在线检测方面具有良好的应用前景。     

Structural and Electrical Characteristics of Pb（Zr0.53,Ti0.47）O3 Thin Films Deposited on Si （100） Substrates

Pb(Zr0.53, Ti0.47)O3 (PZT) films were directly deposited on Si substrates without a buffer layer by pulsed laser deposition. Only(110)-oriented PZT peaks (other than Si substrate peaks) were observed from the XRD data. The electrical properties of the PZT/Si capacitor were characterized in terms of both the capacitance versus voltage (C-V) and current versus voltage (I-V) measurements. The clockwise trace of the C-V curve shows ferroelectric polarization switching, as is expected. From the I-V curves, the Schottky emission and spacecharge-limited-current behaviour are found to be the mainly leakage current mechanism in a certain electric field range in the negative and positive bias, respectively.     

Fabrication of Dendrimer－like PAMAM Based on Silica Nanoparticles

A G 4.0 dendrimer-like poly (amido amine) (PAMAM) based on silica nanoparticles was fabricated via a divergent approach.It was built from γ-aminopropyi silica nanoparfides (APSN) core via repetitive addition of acrylate (MA) and hexylenediamine (HDA). FT-IR and EA were used to monitor the progress of dendrimer during each step. The amino group content of the resulting product increased from 0.49 to 3.72 mmol/g after the 4th generation. In addition, the percentage of grafting increased with increasing generation and reached to 65.9% after 4th generation. It was found that the resulting silica nanoparticles could be dispersed in methanol with a mean hydrodynamic particle diameter of 152.7 nm although the silica nanoparticles had agglomerated during the storage period.     

Deposition of Hydrogen-Free Silicon Nitride Thin Films by Microwave ECR plasma Enhanced Magnetron Sputtering at Room Temperature

Hydrogen-free silicon nitride （SiNx） films were deposited at room temperature by microwave electron cyclotron resonance （MW-ECR） plasma enhanced unbalance magnetron sputtering system. Both Fourier-transform infrared spectroscopy and x-ray photoelectron spectroscopy are used to study the bonding type and the change of bonding structures of the silicon nitride films. The results indicate that the chemical structure and composition of SiNx films deposited by this technique depend strongly on the N2 flow rates, the stoichiometric SiNx film, which has the highest hardness of 22.9 GPa, could be obtained at lower N2 flow rate of 4 sccm.     

铁铝催化体系催化丙烯酸丁酯聚合

研究了Fe(acac)3-Al(i-Bu)3-8-羟基喹啉(acac=乙酰丙酮)催化体系催化丙烯酸丁酯(BA)聚合，考察了聚合规律，用凝胶渗透色谱研究了聚合物分子量和分子量分布．动力学研究表明聚合反应对单体浓度呈一级关系，表观活化能为13．9kJ／mol．