溶胶-凝胶制备技术与新型催化材料Ⅲ.溶胶粒子表面修饰方法制备催化膜

提出用溶胶粒子表面修饰方法，结合溶胶凝胶技术制备无机催化膜．该方法的基本原理是利用合适的金属配合物在胶粒表面的吸附作用，经溶胶凝胶过程，将活性组分结合到无机膜中．实验测定结果表明：（ＮｉＥＤＴＡ）２－，ＶＯ－３，ＭｏＯ２－４，（Ｐｄ（ＮＨ３）４）２＋，ＰｄＣｌ２－４，ＰｔＣｌ２－６和ＲｈＣｌ３－６可用来修饰ＡｌＯＯＨ溶胶．以Ｐｄ／γＡｌ２Ｏ３催化膜的制备为例，经三次溶胶凝胶过程，可制得无裂缺的厚度为９μｍ的Ｐｄ／γＡｌ２Ｏ３催化膜，膜材料的平均孔直径为６ｎｍ，Ｐｄ被均匀地分布在膜的顶层，其平均粒径为２３ｎｍ．     

坩埚下降法生长的LiNbO3,Fe:LiNbO3,Zn:Fe:LiNbO3单晶的吸收光谱特性

用紫外可见光谱(UV／Visible Spectra)测试并研究了坩埚下降法生长的LiNbO3、Fe：LiNbO3，以及Zn：Fe：LiNbO3晶体的吸收特性。分析了产生这些吸收特性的原因以及与工艺生长方法的内在联系。研究结果表明：LiNbO3单晶沿晶体生长方向，其紫外吸收边向长波方向移动，且在350—450nm波段的吸收也逐渐增大，这是由于Li的分凝与挥发，逐渐产生缺锂所造成的；在Fe：LiNbO3单晶中观察到Fe^2 离子在480nm附近的特征吸收峰，并发现沿生长方向，Fe^2 离子的浓度逐渐增加，这与提拉法生长得到的晶体不同；在Fe：LiNbO3单晶中掺入质量分数为1．7％ZnO后，吸收边位置发生蓝移，而掺杂质量分数达到3．4％时，观察到有红移现象。Fe^2 离子在Zn：Fe：LiNbO3单晶中的浓度与ZnO掺杂量有密切关系。在掺杂质量分数1．7％ZnO的Fe：LiNbO3单晶中，Fe^2 离子从底部到顶部的浓度变化比在掺杂质量分数3．4％ZnO晶体中大，这是由于Zn^2 抑制Fe^2 离子进入Li位的能力随掺杂量的增加而逐渐减弱造成的。就该下降法工艺技术对Fe^2 离子在晶体中的浓度分布的影响作了分析。     

类锂体系(Z=21-30)基态1s22s电离能和相对论项能的理论计算

使用全实加关联方法和里兹(Ritz)变分方法计算了类锂体系(Z=21-30)基态1s22s的非相对论能量和波函数;包括动能修正、电子-电子接触项、轨道-轨道相互作用项以及Darwin项的相对论修正和质量极化项由全实加关联波函数的一阶微扰给出,量子电动力学修正QED(quantum electronic dynamic)由有效核电荷方法和类氢公式计算;给出了中等核电荷的高电离类锂体系基态的电离能、相对论效应的项能(term energy),并将计算结果与实验数据进行了比较,表明FCPC方法对于较高核电荷类锂体系结构的理论计算仍然十分有效.     

High-Average-Power Nanosecond Quasi-Phase-Matched Single-Pass Optical Parametric Generator in Periodically Poled Lithium Niobate

A pulsed nanosecond optical parametric generator (OPG) in periodically poled lithium niobate (PPLN) crysal is presented. The pump laser is an acousto-optically Q-switched Nd:YVO4 laser with the maximum average power of 6.58 W. When the repetition rate is 50kHz and the pulse width of the pump source is 80ns, the maximum average total output power of the single-pass PPLN OPG is about 1.9 W, which includes 1.322 W of 1.536μm signal radiation. The length of the PPLN crystal is only 38.7mm (at room temperature) with a grating period of 28.93μm (at room temperature). The 1.502-1.536μm signal radiation and 3.652-3.465μm idler radiation are obtained by adjusting the PPLN crystal temperature from 155℃ to 250℃.     

氘氚化锂分解残渣中微量氚的回收

氘作同位素交换气对除氚后的新鲜氘氚化锂残渣[主要成分是硅锂化合物和二氧化硅，渣中含氚约为0．9443mg／g(渣)]中的微量氚进行氚的计量与回收，为氘氚化锂残渣中氚的回收提供技术支持。     

Microwave-assisted Regioselective 1-O-Deacylation of Peracylated Glycopyranoses on Alumina

A facile, rapid and regioselective method for the 1-O-deacylation of peracylated glycopyranoses is described which occurs under mild conditions by absorption onto alumina using microwave irradiation.     

Morphology of Platinum Nanowire Array Electrodepostied Within Anodic Aluminium Oxide Template Characterized by Atomic Force Microscopy

Unifrom platinum nanowires were synthesized by electrodepositing the platinum under a very low altering current frequency(20Hz) and increasing voltage(5-15V）in the proes of anodic aluminium oxide(AAO) template. Atomic force microscopy observation indicates that the template membranes we obtained have hexagonally clse-packed nanochannels.The platinum nanowires have highly ordered arrays after partially dissolving the aluminium oxide membrane.With the increasing dissolvoing time,the platinum nanowire array collapsed.A concave topography of the aluminium substrate was observed after the aluminium oxide membrane was dissolved completely and the platinum nanowires were released from the template.Platinum nanowires were also characterized by transmission electron microscopy and the phase structure of the Al/AAO/Pt composite was proven by x-ray diffraction.     

类锂硅离子软X射线激光研究

在激光等离子体典型参数条件下，利用碰撞－辐模型计算了类锂硅离子５ｆ－３ｄ和４ｆ－３ｄ跃的粒子数反转比率和激光增益系数。讨论了不同热带条件和不同冷却速度下，激光增益系统数的变化。计算结果表明，高功率，短脉冲激光生产的高温等离子体在快速冷却条件下能产生软Ｘ射的线激光增益。