铸造工艺仿真设计前处理及过程处理应用技术

以应用ProCAST和MAGMAsoft 2款软件为例，针对铸造工艺仿真设计前处理和过程处理每个环节的主要内容与使用方法进行了较为详细地归纳、分析和总结。提出了处理过程的技术路线，并系统地介绍了每项应用内容的操作平台与使用步骤，从而为高效地应用铸造工艺仿真设计提供理论和技术支持。     

医药洁净室的计算流体动力学模拟及实测对比

采用计算流体动力学(CFD)模拟,研究3个医药洁净室的气流流型及颗粒物浓度.采用标准k-ε双方程模型,通过模拟颗粒物在洁净室的分布,分析合理的污染物散发位置及散发比例.对比参考发尘量下的结果与实测数据的差异,根据实测数据确定污染散发量,通过试验不同的单位容积发尘量,计算对应的洁净度,得到与实测数据吻合最好的单位容积发尘量.在单位容积发尘量为1 000pc·(m3·min)-1计算条件下,各房间的模拟结果与实测数据数值比较吻合,且经CFD预测的3个房间的洁净度变化趋势与实测一致.     

通辽地区医疗防保单位消毒质量现状与分析

为了解通辽地区医疗防保单位的消毒状况，1999－2001年对32家医疗防保单位的消毒与灭菌情况进行了调查。各年度监测合格率分别为55.76%、78.93%、90.54%。并对医疗防保单位消毒工作提出了建议。     

Characterization of low molecular weight hydrocarbon oligomers by laser desorption/ionization time-of-flight mass spectrometry using a solvent-free sample preparation method.

A new solvent-free sample preparation method using silver trifluoroacetate (AgTFA) was developed for the analysis of low molecular weight paraffins and microcrystalline waxes by laser desorption/ionization time-of-flight mass spectrometry (LDI-TOFMS). Experiments show that spectral quality can be enhanced by dispersing AgTFA directly in liquid paraffins without the use of additional solvents. This preparation mixture is applied directly to the MALDI probe. Solid waxes could be examined by melting prior to analysis. The method also provides sufficiently reproducible spectra that peak area ratios between mono- and bicyclic alkane peaks indicated variations in the cycloalkane content of paraffin samples. Dehydrogenation of hydrocarbons observed during the desorption/ionization process was studied by analysis of alkane standards.     

Design of neutral, mono- or di-cationic water-soluble trihydrazidophosphoradamantanes

The versatile behavior of a trihydrazidophosphoradamantane allowing the synthesis of a variety of neutral, mono- or di-cationic water-soluble molecules of potential interest for biphasic catalysis is reported.     

HgCl2/I2复合催化剂协同催化合成异丙醇钇的研究

以金属钇和异丙醇为原料，以HgCl2/I2为复合催化剂，通过对金属钇的机械加工以增加其比表面，并将异丙醇脱水使其含水量降低至0．05％，体系在82℃回流5h，经过滤、减压蒸馏，得到了白色海绵状异丙醇钇，其产率高达83％，合成时间比文献报道的缩短了19h，产率提高了8％。文章确定了催化剂的最佳用量为20gY加入60mg HgCl2/I2，研究了合成产率与HgCl2/I2催化剂和HgCl2催化剂的依赖关系及异丙醇中含水量对合成产率的影响，并对HgCl2/I2的催化作用机理进行了初步探讨。     

On the geometry of infinite cyclic subgroups

In this paper we construct an example of a word metric on an infinite cyclic subgroup. This example shows that subexponential distortion does not obstruct non-trivial growth of connected radii. This answers a question of Gromov [6]. The constructed metric has other pathological properies. Specifically, its asymptotic cone depends on the choice of ultrafilter and scaling sequence. The work has been partially supported by the Swiss National Science Foundation.     

IFS attractors and Cantor sets

We build a metric space which is homeomorphic to a Cantor set but cannot be realized as the attractor of an iterated function system. We give also an example of a Cantor set K in R³ such that every homeomorphism f of R³ which preserves K coincides with the identity on K.