Auto-deposition of 210Bi and 210Po on nickel discs and their application in the analysis of natural waters

Journal of Radioanalytical and Nuclear Chemistry - This study presents a time-efficient method of analysing 210Pb, 210Bi, and 210Po in natural waters. The optimum pH (1.00), temperature...     

高低温环境航天机构力矩特性测试平台研制

为了测试在太空环境下航天机构中弹性机构的性能指标,研制了高低温环境下测量角度-力矩特性的测试平台.分析测试平台测试原理后,设计了平台的机械结构、设计电气系统结构并搭建软件系统.机械结构考虑对被测对象的保护,针对高低温测试带有高低温箱,可以为被测对象提供-100℃～100℃的温度环境,具有热变形偏差测量与补偿设计,减少温度变化对测量精度的影响.软件系统具备收集、处理、存储数据和图形化显示能力.分析平台不确定度的组成,对传感器进行测试校准并对航天弹性机构进行测试,测试结果验证了:该测试平台的力矩检测范围为0～50 N·m,力矩检测精度≤0.5％FS,角度测量扩展不确定度为U=35.6″,得到了被测对象的角度-力矩特性曲线图.     

超强筋小麦粉面包烘焙技术研究

为了烘焙出能充分表现超强筋小麦济麦229面粉品质特性的优良面包,设置了4种醒发时间处理、5种酵母和糖用量处理、4种配粉处理,对超强筋小麦面粉的面包品质进行了评价分析。结果表明,在4个醒发时间处理中,当面团醒发时间为30min和面包胚醒发时间为50min时,烘焙的面包品质最好。在5种酵母和糖用量的处理中,利用吐司面包程序时,干酵母和糖的用量分别为6g和24g时烘焙的面包品质最好；利用法式面包程序时,干酵母和糖的用量分别为3g和18g时烘焙的面包品质最好。在4个配粉处理中,200g超强筋小麦济麦229面粉中添加100g普通小麦济麦22面粉的混粉烘焙得到的面包品质最好。因此,适当调整超强筋小麦粉面包的面团、面包胚醒发时间及物料配比,可以烘焙出品质优良的面包。     

氧化还原介体催化强化污染物厌氧降解研究进展

 由于厌氧生物处理技术具有产生剩余污泥少、可回收能源等优点而被广泛用于处理各种有机污染物，尤其在有毒、有害、难降解污染物的去除方面取得了良好的效果。然而，厌氧生物法的处理速率通常比较低，而氧化还原介体可通过自身不断的氧化和还原来传递电子，提高电子在氧化还原反应过程中的传递速率，从而促进污染物高效厌氧降解。醌类物质和腐殖酸是应用较多的氧化还原介体，在催化难降解污染物降解方面取得了一定效果。讨论了氧化还原介体的特点、作用机制，并总结了其对偶氮染料厌氧脱色、反硝化和多氯联苯厌氧降解的强化作用，提出了氧化还原介体未来的研究方向。     

Strategies for synthesizing non-bioaccumulable alternatives to PFOA and PFOS

This minireview describes the strategies for synthesis of fiuorinated surfactants potentially nonbioaccumulable.Various strategies have been focused on(Ⅰ) reducing the length of the perfluorocarbon chain,(Ⅱ) introducing hetero atoms into the fluorocarbon chain,(Ⅲ) introducing branch(herein and after branch means the fluoro-carbon chain section is not straight).In most cases,the surface tensions versus the surfactant concentrations have been assessed.These above strategies led to various highly fiuorinated(perfluorinated or not perfluorinated) surfactants whose chemical changes enabled to obtain novel alternatives to perfluorooctanoic acid(PFOA) and perfluorooctane sulphonate(PFOS).     

Dynamical analysis of boundary behaviors of current-controlled DC–DC buck converter

Nonlinear Dynamics - In this paper, the current-controlled DC–DC buck converter from a new perspective are studied through the switching theory of flow, and the analytical conditions of the...     

化学法改性煤沥青脱除苯并芘的研究

在管式反应器中采用苯甲酸、聚乙二醇、固体古马隆树脂（S）、液体古马隆树脂（L）为添加剂来降低煤沥青中有害物质苯并芘的含量，以期使得煤沥青可绿色化应用。采用紫外-可见分光光度计分析煤沥青中苯并芘含量。考察了反应温度、反应时间、添加剂添加量、催化剂等工艺条件对添加剂脱除煤沥青中苯并芘的影响。结果表明，不同工艺条件能降低煤沥青中苯并芘的含量。在优化条件下，不同添加剂对苯并芘脱除率由高到低依次为：液体古马隆树脂、聚乙二醇、苯甲酸和固体古马隆树脂。分析其反应机理，这与催化剂的酸性相关，发生亲电取代反应。结果表明，液体古马隆树脂（L）在催化剂存在下对煤沥青中苯并芘脱除率可达73.0%，显示了良好的应用前景。     

外部治理环境与公司绩效:代理成本的中介效应

中国经济发展过程中存在区域发展不平衡现象,这种不平衡现象对公司绩效产生了重要影响。基于2003-2015年沪、深两市A股上市公司数据,以管理费用率度量上市公司管理层与股东间的第一类代理成本,以其他应收款占比度量上市公司控股股东与中小股东之间的第二类代理成本,采用多元回归和中介效应检验程序,实证检验了外部治理环境通过两类代理成本的中介作用对上市公司绩效影响的内在机理。研究结果表明,外部治理环境的提升能够显著的降低两类代理成本,进而提高上市公司的绩效,两类代理成本在外部治理环境影响公司绩效的过程中发挥显著的部分中介作用。     

Highly Luminescent Red Phosphorescent OLED with Interfacial Layers for Hole Transport and Electron Injection

Four kinds of red phosphorescent organic light-emitting devices were fabricated and compared to investigate the effect of interfacial layers for hole transport and electron injection. 1 nm-thick LiF in the device A and C and 1 nm-thick Cs₂CO₃ in the device B and D were deposited as an electron injection layer between the anode and the electron transport layer, and 5 nm-thick layer of dipyrazion[2,3-f:2′,2′-h]quinoxaline-2,3,6,7,10,11-hexacarbonitrile[HATCN] was inserted as a hole transport interfacial layer between the hole injection layer and the hole transport layer only in the device C and D. Under a luminance of 1000 cd/m², the power efficiencies were 7.6 lm/W and 8.5 lm/W in the device A and B, and 8.6 lm/W and 13.4 lm/W in the device C and D. The quantum efficiency of the device D was 15.8% under 1000 cd/m² which was somewhat lower than those of the device A and C, but a little higher than that of the device B. The luminance of the device D was much higher than those of the other devices at a given votage. The luminance of the device D at 7 V was 23,710 cd/m², which was 13.0, 3.4, and 4.0 times higher than those of the device A, B, and C at the same voltage, respectively.