A novel InP/InGaAs TEBT for ultralow current operations

A novel InP/InGaAs tunneling emitter bipolar transistor (TEBT) is fabricated and demonstrated. The studied device exhibits a very small collector-emitter offset voltage of 40 mV and an extremely wide operation regime. The operation region is larger than 11 decades in magnitude of collector current (10/sup -12/ to 10/sup -1/A). A current gain of 3 is obtained even if the device is operated at an ultralow collector current of 3.9 /spl times/ 10/sup -12/A (1.56 /spl times/ 10/sup -7/A/cm/sup 2/). Furthermore, the common-emitter breakdown voltage of the studied device is higher than 2 V. Consequently, the studied device shows a promise for low supply voltage, and low-power consumption circuit applications.     

Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.     

Effect of oxygen exposure on the magnetic properties of ultrathin Co/Ge(1 1 1) films

Influences of oxygen exposure on the magnetic properties of Co/Ge(1 1 1) ultrathin films have been investigated by surface magneto-optic Kerr effect technique. As the oxygen exposure increases on Co/Ge(1 1 1) films, their magnetic properties could be modified. As an example for 15 ML Co/Ge(1 1 1) films, the coercivity increases from 730 to 920 Oe and the remanence Kerr intensity is reduced for 500 Langmuir (L) of oxygen exposure. Corresponding compositions analyzed by Auger electron spectroscopy measurement shows that the amount of oxygen on the surface layers increases with increasing the oxygen exposure time. Oxygen distributes on the topmost layers of the film. The adsorbed oxygen influences the electronic density of states of Co and results in the changes of the magnetic properties. Besides, the appearance of O/Co/Ge interface could modify the stress anisotropy, and as a result the coercivity of ultrathin Co/Ge(1 1 1) film is enhanced.     

Barrier layer effect of tantalum on the electromigration in sputtered copper films on hydrogen silsesguioxane and SiO2

As IC devices scale down to the submicron level, the resistance-capacitance (RC) time delays are the limitation to circuit speed. A solution is to use low dielectric constant materials and low resistivity materials. In this work, the influence of underlying barrier Ta on the electromigration (EM) of Cu on hydrogen silsesquioxane (HSQ) and SiO₂ substrates was investigated. The presence of a Ta barrier not only improves the adhesion between Cu and dielectrics, but also enhances the crystallinity of Cu film and improves the Cu electromigration resistance. The activation energy obtained suggests a grain boundary migration mechanism and the current exponent calculated indicates the Joule heating effect.     

Broadband dual-polarized patch antennas fed by capacitively coupledfeed and slot-coupled feed

Designs of broadband dual-polarized patch antennas fed by promising feed structures of a capacitively coupled feed and a slot-coupled feed (antenna A), two capacitively coupled feeds of a 180° phase shift and a slot-coupled feed (antenna B), and two capacitively coupled feeds of a 180° phase shift and two slot-coupled feeds (antenna C) are proposed and experimentally studied. The first two feed designs are for the excitation of a single-element broadband patch antenna, while the last design is for a two-element broadband patch antenna. These proposed patch antennas have a thick air substrate, and the 10 dB return-loss impedance bandwidths obtained for the two polarizations are all greater than 13%. High isolation (<-30 dB for antenna A, <-32 dB for antenna B, <-35 dB for antenna C) between the two feeding ports for the entire impedance bandwidth of the proposed antennas can be obtained. Also, improved cross-polarization levels (>20 dB) in both E and H plane patterns for the two polarizations of antennas B and C are achieved     

InGaN/GaN MQW p–n junction photodetectors

InGaN/GaN multiquantum well (MQW) p–n junction photodetectors with semi-transparent Ni/Au electrodes were fabricated and characterized. It was found that the fabricated InGaN/GaN MQW p–n junction photodetectors exhibit a 20 V breakdown voltage and a 3.5 V forward 20 mA turn on voltage. It was also found that the photocurrent to dark current contrast ratio is higher than 10⁵ when a 0.4 V reverse bias was applied to the InGaN/GaN MQW p–n junction photodetectors. Furthermore, it was found that the maximum responsivity was 1.28 and 1.76 A/W with a 0.1 and 3 V applied reverse bias, respectively.     

Fabrication and properties of PLZT ceramics from spray-dried aqueous solution

PLZT ceramics with the composition of 9/62/38 (La/Zr/Ti) were fabricated from spraydried aqueous solution. Complete crystallization of the spray-dried powder is achieved after 1 hr calcination at 650‡ C as compared to 800‡ C, 1 hr for conventional mixedoxide method. Sintering environment plays an important role in the densification of PLZT ceramics. Densities of the atmosphere sintered samples are much higher than those of normal sintered ones. PLZT ceramics derived from spray-dried powders have properties comparable to those derived from sol-gel ones. The spray-dried method presents a less expensive and more effective approach in the synthesis of PLZT ceramics.     

Rapid Protein Hydrolysis by Microwave Irradiation Using Heat-Resistant Teflon-Pyrex Tubes

A rapid peptide-bond hydrolysis by means of microwave irradiation is introduced for the facile preparation of protein hydrolysates used for amino acid analysis. The optimal hydrolysis condition has been determined using several enzymes with known amino acid compositions. The effects of hydrolysis time on the recovery of various labile and hydrophobic amino acids are also exemplified in the microwave heating of standard amino acids. The method has been applied to the complete amino acid analysis with a single nonvolatile solvent of methanesulfonic acid with good recovery of tryptophan and half-cystine. It provides a radical expedition of protein and peptide hydrolysis via commercial microwave ovens and specially-designed Teflon-Pyrex tubes, circumventing the tedious procedures using vacuum-sealed pyrex lubes heating at 110°C for more than 24 h. This novel type of microwave chemistry associated with rapid peptide-bond cleavage is of great potential in the automation of the complete process of amino acid analysis starting from the preparation of protein hydrolysates.     

Synthesis of 2-Oxo amide triacylglycerol analogues and study of their inhibition effect on pancreatic and gastric lipases

A general method for the synthesis of chiral 2-oxo amide triacylglycerol analogues, from (R)- or (S)-3-aminopropane-1,2-diol, was developed. These novel inhibitors of digestive lipases are analogues of the triacylglycerol molecule, a natural substrate of lipases, and they were designed to contain the 2-oxo amide functionality in place of the scissile ester bond at the sn-1 or sn-3 position and nonhydrolysable ether bonds instead of ester bonds at the other two remaining positions. The 2-oxo amide derivatives synthesised were tested for their ability to form stable monomolecular films at the air/water interface by recording their surface pressure/molecular area compression isotherms. The inhibition of porcine pancreatic and human gastric lipases by the 2-oxo amides was studied by means of the monolayer technique with mixed films of 1,2-dicaprin and with variable proportions of each inhibitor. The alpha50 values of these triacylglycerol analogues for PPL and HGL varied between 4.4 to 7.0% and 5.6 to 15.9%, respectively. The chirality at the sn-2 position of 2-oxo amide triacylglycerol analogues affected the alpha50 value for HGL, but not for PPL.