Tunnelling current in Schottky diodes containing InAs quantum dots

Current transport mechanism in Schottky diode containing InAs quantum dots (QDs) is investigated using temperature-varying current-voltage characteristics. We found that the tunnelling emission has obvious effects on the I-V characteristics. The I-V-T measurements revealed clear effects of QDs on the overall current flow. Field emission (FE, pure tunnelling effect) was observed at low temperature and low voltages bias region. The zero-bias barrier height decreases and the ideality factor increases with decreasing temperature, and the ideality factor was found to follow the T₀-effect. When the reverse bias is varied, the ideality factors of Schottky barriers exhibit oscillations due to the tunnelling of electrons through discrete levels in quantum dots. The traps distributed within InAlAs layer can also act as a transition step for reverse bias defect-assisted tunnelling current which can phenomenologically explain the decrease of the effective barrier height with measurement temperature.     

Selection of timed token protocol parameters to guarantee messagedeadlines

Networks that use the timed token protocol (such as the 100 Mbit/s FDDI network) are well suited for real-time applications because they guarantee, to each node, an average bandwidth and a bounded access time to the communication network. This guarantee is necessary but not sufficient for the timely delivery of deadline-constrained messages; protocol parameters must be carefully selected to ensure that these messages meet their deadlines. This paper addresses the issue of selecting the protocol parameters TTRT (target token rotation time) and the synchronous capacities assigned to each node. The objective is to guarantee that each synchronous message is transmitted before its deadline. An upper bound is derived on the worst case achievable utilization (WCAU) of any parameter selection scheme. The WCAU of a scheme is defined as the maximum utilization U such that the scheme guarantees all synchronous messages as long as their utilization is less than U. An algorithm for selecting the above parameters is proposed, The algorithm is shown to have a WCAU that is very close to the upper bound     

Multi-scale Modeling of Vision-Guided Remodeling and Age-Dependent Growth of the Tree Shrew Sclera During Eye Development and Lens-Induced Myopia

The sclera uses unknown mechanisms to match the eye’s axial length to its optics during development, producing eyes with good focus (emmetropia). A myopic eye is too long for its own optics. We propose a multi-scale computational model to simulate eye development based on the assumption that scleral growth is controlled by genetic factors while scleral remodeling is driven by genetic factors and the eye’s refractive error. We define growth as a mechanism that changes the tissue volume and mass while remodeling involves internal micro-deformations that are volume-preserving at the macro-scale. The model was fitted against longitudinal refractive measurements in tree shrews of different ages and exposed to three different visual conditions: (i) normal development; (ii) negative lens wear to induce myopia; and (iii) recovery from myopia by removing the negative lens. The model was able to replicate the age- and vision-dependent response of the tree shrew experiments. Scleral growth ceased at younger age than scleral remodeling. The remodeling rate decreased as the eye emmetropized but increased at any age when a negative lens was put on. The predictive power of the model was investigated by calculating the susceptibility to scleral remodeling and the response to form deprivation myopia in tree shrews. Both predictions were in good agreement with experimental data that were not used to fit the model. We propose the first model that distinguishes scleral growth from remodeling. The good agreement of our results with experimental data supports the notion that scleral growth and scleral remodeling are two independently controlled mechanisms during eye development.     

Adsorption kinetics of 4-chlorophenol onto granular activated carbon in the presence of high frequency ultrasound

This work describes the results of investigations carried out to examine the adsorption kinetics of 4-chlorophenol (4-CP) from aqueous solution containing tert-butyl alcohol (10%, v/v) onto granular activated carbon (GAC) in the presence of ultrasound of different high frequencies (516, 800 and 1660 kHz) and acoustic powers (15.2, 21.5, 31.1 and 38.3 W). The main objective of this study is to describe the mechanism of ultrasound-assisted adsorption rather than the enhancement of adsorption capacity. Sonochemical degradation of 4-CP was studied in the absence and presence of tert-butyl alcohol. The sonolysis of 4-CP is effectively inhibited by the addition of tert-butyl alcohol (10%, v/v) and very little 4-CP degradation occurs, indicating that little or no pyrolysis of the compound occurs. Without addition of tert-butyl alcohol, after 300 min and at 1660 kHz, the removal of 4-CP in the presence of ultrasound for an acoustic power of 38.3 W was nearly total (99%), but in the conventional method only 60% was eliminated. In this case, the removal of 4-CP by GAC in the ultrasound-assisted technique is due to both adsorption and ultrasonic degradation, but the removal by simple stirring is only due to adsorption, which makes a direct comparison unacceptable. In order to distinguish sonochemical degradation and adsorption of 4-CP onto GAC and to make an exact and practical comparison of the adsorption in the absence and presence of ultrasound, kinetic adsorption experiments were conducted using aqueous solution containing 10% (v/v) tert-butyl alcohol. The obtained results show that both adsorption rate and adsorbed amount were significantly enhanced and improved in the presence of ultrasound for all the studied frequencies and powers. The enhancement of adsorption is favored by increasing ultrasonic power. Adsorption kinetic data were modeled using the liquid-film mass transfer equation and intraparticle diffusion model. The values of the intraparticle diffusion coefficient obtained in the presence of ultrasound are greater than that obtained in the absence of ultrasound. In the initial period of adsorption, where external mass transfer is assumed to predominate, liquid-film mass transfer coefficients significantly increased by the assistance of ultrasound. These results indicate that ultrasound enhances the mass transport in the pores as well as across the boundary layer. This effect increased with increasing ultrasonic power for the three studied frequencies. The average order for the studied ultrasonic waves according to the initial adsorption rate, the intraparticle diffusion coefficient and the liquid-film mass transfer coefficient is 516 kHz>800 kHz>1660 kHz.     

Intensification of sonochemical decolorization of anthraquinonic dye Acid Blue 25 using carbon tetrachloride

In this work, the influence of CCl₄ on the sonochemical decolorization of anthraquinonic dye Acid Blue 25 (AB25) in aqueous medium was investigated using high frequency ultrasound (1700 kHz). This frequency, reputed ineffective, was tested in order to introduce the ultrasound waves with high frequency in the field of degradation or removal of dyes from wastewater, due to its limited use in this field, and to increase the application of high frequency ultrasound wave in the field of environmental protection. The effects of various parameters such as the concentration of CCl₄, frequency (22.5 and 1700 kHz), solution pH, temperature and tert-butyl alcohol adding on the decolorization rate of AB25 was studied. The obtained results clearly demonstrated the significant intensification of AB25 decolorization in the presence of CCl₄. The enhancement effect of CCl₄ increased by decreasing temperature and by increasing the CCl₄ concentration. The pH has a significant influence on the bleaching of dye both in the absence and presence of CCl₄. The three investigated dosimeter methods (KI oxidation, Fricke reaction and H₂O₂ production) well corroborate the improvement of the sonochemical effects in the presence of CCl₄. The best sonochemical decolorization rate of AB25 in aqueous solution both in the absence and presence of CCl₄ is observed to occur at 1700 kHz compared to 22.5 kHz. The sonochemical oxidation of CCl₄ generates oxidizing species in the liquid phase that are highly beneficial for oxidation of hydrophilic and non-volatile pollutant, such as dyes, because they are less susceptible to free radical attack due to lower stability of the generated free radicals.     

Finite elastic deformations of transversely isotropic circular cylindrical tubes

We consider the finite radially symmetric deformation of a circular cylindrical tube of a homogeneous transversely isotropic elastic material subject to axial stretch, radial deformation and torsion, supported by axial load, internal pressure and end moment. Two different directions of transverse isotropy are considered: the radial direction and an arbitrary direction in planes normal locally to the radial direction, the only directions for which the considered deformation is admissible in general. In the absence of body forces, formulas are obtained for the internal pressure, and the resultant axial load and torsional moment on the ends of the tube in respect of a general strain-energy function. For a specific material model of transversely isotropic elasticity, and material and geometrical parameters, numerical results are used to illustrate the dependence of the pressure, (reduced) axial load and moment on the radial stretch and a measure of the torsional deformation for a fixed value of the axial stretch.     

Removal of Malachite Green Dye from Aqueous Solution by Catalytic Wet Oxidation Technique Using Ni/Kaolin as Catalyst

In this study, natural Algerian kaolin was used as a support and impregnated with nickel at different loading amounts (2 wt.%, 5 wt.%, and 7 wt.%) in order to prepare a supported catalyst. The wet impregnation technique was used in this preparation; nickel oxide (NiO) was the active phase precursor of the catalyst, and the catalysts were designated as follows: 2%, 5%, and 7% Ni/kaolin. These catalysts were put to the test in catalytic wet peroxide oxidation (CWPO) for degrading the organic contaminant malachite green dye (MG). Analytical techniques such as FTIR spectroscopy, X-ray diffraction, BET, and X-fluorescence were used to examine the structure, morphology, and chemical composition of the support and the produced catalysts. Several parameters, including temperature, catalytic dose, metal loading, hydrogen peroxide volume, and kinetic model were systematically investigated. The combination of improved parameters resulted in a significant increase in the catalytic activity, achieving a high removal rate of MG dye of 98.87%.     

Network-Level QoS Assurances Through Adaptive Allocation of CDMA Resources

In a Code Division Multiple Access (CDMA) network, multiple Mobile Hosts (MHs) can simultaneously transmit over the wireless channel by using different codes. To assure an acceptable Quality of Service (QoS) for all MHs' flows, the network usually tunes the transmit powers of all MHs to achieve a certain level of signal strength as compared to the noise and the interference (SINR) for each MH. The traditional assumption in power control schemes is that the SINR requirement is statically determined for each MH's flow. In contrast, in this paper, we propose a scheme that dynamically adapts the SINR requirements of MH's flow based on its QoS requirements and the conditions of the wireless channel between the MHs and the base station. As a result of this adaptation, we show that network-level QoS measures such as fraction of packets meeting their delay requirements and energy consumed per packet transmission are significantly better than in a scheme that statically fixes the SINR requirements. We show that the adaptation approach works well for the Matched Filter (MF) and the Minimum Mean Squared Error (MMSE) receivers. Our scheme uses a simple table-driven approach for optimally selecting the target SINR requirement for each MH at run time. The entries in the table are computed off-line using a dynamic programming algorithm with the objective of maximizing a profit function that balances the need for meeting the network-level QoS requirements and the cost of using a particular target SINR for a given transmission. Moncef Elaoud (M'97) received his B.Sc. (1988) his M.Sc. (1990) and his Ph.D. (2000) in electrical an computer engineering from the University of Wisconsin-Madison. He is currently a senior research Scientist at Telcordia Technologies' Applied Research organization. His main research interests are in the areas of quality of service, self-forming and self healing networks, auto-configuration, and mobility management in wireless and ad-hoc networks. Bechir Hamdaoui received the B.S. degrees in both electrical and mechanical engineering, and the M.S. degree in mechanical engineering from the National School of Engineering in Tunis (BAC+6+DEA, ENIT), Tunisia, in 1997 and 1998, respectively. He also received the M.S. degree in electrical and computer engineering from the University of Wiconsin, Madison, WI, in 2002, where he is currently working toward the Ph.D. degree. From 1998 to 1999, he worked as a quality control and planning engineer on power generation plant project under the supervision of FIAT Avio. His research focuses on various aspects in the area of computer networking including mobile networks, wireless communication systems, and ad hoc networks. Parameswaran Ramanathan received the B. Tech degree from the Indian Institute of Technology, Bombay, India, in 1984, and the M. S. E. and Ph. D. degrees from the University of Michigan, Ann Arbor, in 1986 and 1989, respectively. Since 1989, Dr. Ramanathan has been faculty member in the Department of Electrical & Computer Engineering, University of Wisconsin, Madison, where is presently a Full Professor. He leads research projects in the areas of sensor networks and next generation cellular technology. In 1997–98, he took a sabbatical leave to visit research groups at AT&T Laboratories and Telcordia Technologies. Dr. Ramanathan's research interests include wireless and wireline networking, real-time systems, fault-tolerant computing, and distributed systems. He is presently an Associate Editor for IEEE Transactions on Mobile Computing and Elsevier AdHoc Networks Journal. He served as an Associate Editor for IEEE Transactions on Parallel and Distributed Computing from 1996–1999. He has also served on program committees of conferences such as Mobicom, Mobihoc, International Conferences on Distributed Systems and Networks, Distributed Computing Systems, Fault-tolerant Computing Symposium, Real-time Systems Symposium, Conference on Local Computer Networks, and International Conference on Engineering Complex Computer Systems. He was the Finance and Registration Chair for the 1999 Fault-tolerant Computing Symposium. He was the program chairman of the Workshop on Architectures for Real-time Applications, 1994 and the program vice-chair for the International Workshop on Parallel and Distributed Real-time Systems, 1996. He is a member of Association of Computing Machinery and a senior member of IEEE.     

A network-layer soft handoff approach for mobile wireless IP-based systems

Handoff is the process during which a mobile node (MN) needs to change its connectivity point to the wireless internetwork from one access node (AN) to another during an ongoing communication. If MNs are allowed to have two or more simultaneous connections to the internetwork through different ANs, then the handoff is said to be soft; otherwise, it is said to be hard. Traditionally, during forward-link soft handoff, multiple identical copies of each packet are simultaneously transmitted to the MN through the associated ANs. At the MN's physical-layer, the received signals are combined on a bit-by-bit basis resulting in improving the bit-error rate. However, this approach requires tight synchronization of the ANs involved in the soft handoff. In addition, as shown in the literature, the capacity often decreases due to the increase of the number of channels used by MNs during soft handoff. In this paper, we propose, analyze, simulate, and implement a soft handoff scheme called soft handoff over IP (SHIP) for forward-link that 1) overcomes the need for synchronization and 2) increases the capacity of the network. Through both analytic and simulation studies, we show that SHIP achieves significant performance improvements. We derive analytic expressions of the power-capacity relationship for two-dimensional (2-D) and one-dimensional (1-D) cell models. By comparing our scheme with the hard handoff, we empirically show that the capacity increases by about 30% and 20%, respectively, for the 2-D and 1-D cell models. Further, the simulation results show that SHIP saves up to 30% of the total power consumed by the ANs.