Determination of sulfa antibiotic residues in river and particulate matter by field-amplified sample injection-capillary zone electrophoresis

In the present research, field-amplified sample injection–CZE (FASI–CZE) coupled with a diode array detector was established to determine trace level sulfa antibiotic. Sulfathiazole, sulfadiazine, sulfamethazine, sulfadimethoxine, sulfamethoxazole, and sulfisoxazole were selected as analytes for the experiments. The background electrolyte solution consisted of 70.0 mmol/L borax and 60.0 mmol/L boric acid (including 10% methanol, pH 9.1). The plug was 2.5 mmol/L borax, which was injected into the capillary at a pressure of 0.5 psi for 5 s. Then the sample was injected into the capillary at an injection voltage of –10 kV for 20 s. The electrophoretic separation was carried out under a voltage of +19 kV. The capillary temperature was maintained at 20˚C throughout the analysis, and six sulfonamides were completely separated within 35 min. Compared with pressure injection-CZE, the sensitivity of FASI-CZE was increased by 6.25–10.0 times, and the LODs were reduced from 0.2–0.5 to 0.02–0.05 μg/mL. The method was applied to the determination of sulfonamides in river water and particulate matter samples. The recoveries were 78.59–106.59%. The intraday and interday precisions were 2.89–7.35% and 2.77–7.09%, respectively. This provides a simpler and faster method for the analysis of sulfa antibiotic residues in environmental samples.     

差分跳频通信系统的特点及性能

文章介绍了一种新型的短波跳频通信技术——差分跳频,分析了差分跳频技术区别于常规跳频技术的主要特点。针对按序列检测的信号接收方法,对差分跳频通信系统在AWGN信道下的性能进行了理论分析,同时做出相应的计算机仿真,证实了差分跳频通信技术和按序列检测方法的结合,使通信系统在AWGN信道下的性能得到了比较显著的提升。     

激光等离子体2660紫外探针及干涉系统

成功地在六路高功率Nd玻璃激光装置上建立了2660紫外激光探针和适合紫外波段的Normaski干涉仪,首次将可见波长的连续激光应用于紫外干涉仪中靶成像调整和光路准直。利用该紫外光干涉仪,在铜柱状靶(φ500μm)上测量了厚等离子体中高达0.6n。的电子密度。     

Liquid phase oxidation of p-chlorotoluene to p-chlorobenzaldehyde over cobalt-doped mesoporous titania with a crystalline framework

Cobalt-doped mesoporous titania with a crystalline framework synthesized by surfactant templating method presented highly selective (99%) and reasonable conversion rate (49%) of catalytic oxidation of para-chlorotoluene to para-chlorobenzaldehyde in acetic acid using aqueous hydrogen peroxide as oxidant for the first time. Recycling of the catalyst indicates that the catalyst can be used a number of times without losing its activity to a greater extent. By contrast, cobalt-doped mesoporous titania without a crystalline structure and cobalt doped the commercial titania, Degussa P25 prepared by impregnation method with the similar concentration of cobalt were found inactive. The effects of catalyst concentration, reaction time, reaction temperature, and solvents on the performance of the catalyst were also investigated.     

具有高机械强度的掺Er~(3 )∶TeO_2-Nb_2O_5玻璃的光谱性质研究

熔制了掺铒碲铌玻璃样品(100-X)TeO2-XNb2O5(X=5,10,15,20mol%),测试了其密度、折射率、转变温度、析晶温度、维氏机械强度、吸收光谱、荧光光谱、荧光寿命等参量。利用Judd-Ofelt和McCumber理论分别计算了铒离子强度参量Ωt(t=2,4,6)和受激发射截面σemi的大小,研究了掺铒碲铌玻璃样品光谱参量对Nb2O5成分的依赖性,并与典型的碲锌钠玻璃(75TeO2-20ZnO-5Na2O)在热学、机械强度、光谱性质和放大品行四个方面进行了比较.     

ISDN的现状和发展

９０年代将是ＩＳＤＮ和宽带ＩＳＤＮ迅速发展的年代，本文介绍了国外Ｎ－ＩＳＤＮ和Ｂ－ＩＳＤＮ的发展动向，并结合我国通信网的现状，对发展ＩＳＤＮ（Ｂ－ＩＳＤＮ）提出若干建议。     

劈刀和肋环夹持工况对超声键合换能系统电学特性的影响

通过实验分析了肋环夹持松紧度和劈刀存在两个因素对超声键合换能系统电学导纳特性的影响规律。对换能系统在悬挂有无劈刀和夹持8个松紧度等各个情况下进行谐振频率附近的导纳圆测量,确定换能系统等效电路各特征参数的变化情况。由实验结果的分析可知,劈刀的附加质量以及肋环松紧程度对换能系统谐振频率的影响不大,但劈刀的存在改变了换能系统的能量分布和耗散,是影响换能系统各特征参量的主要因素之一。这些结论有助于超声键合换能系统的优化。     

高温超导红外探测器的电极工艺探讨

介绍了高温超导红外探测器电极材料的选择和制备。选用先蒸、后蒸金，再合金化的电极工艺。芯片装配成器件后，器件性能稳定，膜层牢固，接触电阻小。     

PVC膜电极上的示波电位滴定法及其在药物分析中的应用

本文研究了用于示波电位滴定的PVC膜电极,成功地用于中和、络合及沉淀滴定,并探讨了它们在药物分析中的应用。所研究电极见表1。实验部分一仪器与试剂 SR-071型双踪示波器,213型铂片电极     

树脂吸附法处理水杨酸甲酯生产废水的研究

采用吸附树脂NDA—99处理水杨酸甲酯生产废水，结果表明该树脂时废水中的5磺基水杨酸及水杨酸均具有良好的吸附—脱附性能．废水经预处理和吸附处理后，CODCr由57000-59000mg／L降至6300mg／L左右，去除率接近89％．用IBV8％NaOH 3BVH2O作脱附剂，在温度为60℃、流量为IBV／h的条件下，脱附率接近100％，树脂可重复使用．高浓度脱附液经酸化、浓缩、冷却结晶，可回收5—磺基水杨酸，回收率为95％左右。纯度为78％。