An optical instrumentation using a sensor with a sensordummyagainst noises on sensor and transmission line

This short paper discusses the method of effectively canceling equal status normal mode noise not only on a sensor line but also on a transmission line of an optical instrument using a sensor with a sensordummy resistance     

Asymmetric reduction of 2-substituted 2-butenolides with reductase from Marchantia polymorpha

A p68 reductase participating in the asymmetric reduction of the C–C double bond of 2-substituted 2-butenolides was isolated from Marchantia polymorpha. The enzyme reduced 2-substituted 2-butenolides to give (R)-butanolides, and the reduction of citraconic anhydride afforded (R)-methylsuccinic anhydride.     

Novel UV‐induced photografting process for preparing poly(tetrafluoroethylene)‐based proton‐conducting membranes

A novel process comprising the UV‐induced photografting of styrene into poly(tetrafluoroethylene) (PTFE) films and subsequent sulfonation has been developed for preparing proton‐conducting membranes. Although under UV irradiation the initial radicals were mainly generated on the surface of the PTFE films by the action of photosensitizers such as xanthone and benzoyl peroxide, the graft chains were readily propagated into the PTFE films. The sulfonation of the grafted films was performed in a chlorosulfonic acid solution. Fourier transform infrared and scanning electron microscopy were used to characterize the grafted and sulfonated membranes. With a view to use in fuel cells, the proton conductivity, water uptake, and mechanical properties of the prepared membranes were measured. Even through the degree of grafting was lower than 10%, the proton conductivity in the thickness direction of the newly prepared membranes could reach a value similar to that of a Nafion membrane. In comparison with γ‐ray radiation grafting, UV‐induced photografting is very simple and safe and is less damaging to the membranes because significant degradation of the PTFE main chains can be avoided. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2624–2637, 2007     

Soft-decision Viterbi decoding with diversity combining formulti-beam mobile satellite communication systems

Diversity combining methods for mobile satellite communication systems employing convolutional encoding and soft-decision Viterbi decoding are evaluated. Computer simulation clarifies that the pre-Viterbi-decoding maximal ratio combining method has better performance than other methods in Rician fading channels. The simulation results agree with the Pe (bit error probability) performance derived from the numerical analysis for slow fading using the approximate Pe performance of Viterbi decoding in AWGN (additive white Gaussian noise) channels and the probability density function of Rician fading. Applying this diversity method to the multi-beam mobile satellite communication systems, a satellite beam diversity reception scheme is proposed. A computer simulation result shows that the proposed scheme decreases the packet error rate of the control signals to less than 1/100 around the satellite beam boundary     

New color TV cameras for ultraviolet, near infrared and visiblelight

Two kinds of TV cameras have been developed that are capable of showing the wavelengths of ultraviolet, infrared, and visible light by means of a false color method. One is sensitive to wavelengths from 250 to 650 nm (ultraviolet to yellow). It can simulate the color vision of the honey bee and other insects, reproducing the nectar guide of a flower or displaying the sex of a cabbage white moth, which is indistinguishable to the naked eye. The other is sensitive to a wider wavelength of 250 to 1,050 nm (ultraviolet to near infrared). According to the filter selected, it obtains not only visual images of invisible light information but also pictures same as those from an ordinary color camera. These TV cameras can be applied in many fields, including science, art, medicine, and industry     

Strained silacycle-catalyzed asymmetric Diels-Alder cycloadditions: the first highly enantioselective silicon Lewis acid catalyst

The first highly enantioselective silicon Lewis acid catalyst for an asymmetric organic transformation has been developed. The catalyst derives its activity from the strain induced in the silicon center by virtue of being constrained in a five-membered ring. A simple tridentate ligand has been developed and the derived chlorosilane complex catalyzes the Diels-Alder cycloaddition of methacrolein and cyclopentadiene with 94% ee.     

Soliton self-frequency shift in orthogonally polarised femtosecondsolitons

The soliton self-frequency shift (SSFS) in orthogonally polarised femtosecond soliton pulses is reported for the first time. It is shown that SSFS for orthogonally polarised solitons is approximately 1/3 of that for parallel polarised solitons. This is attributed to the orthogonal Raman term. The 2π and π dependences of the SSFS on the phase difference between the two solitons are newly obtained for parallel and orthogonal polarisations, respectively. The largest SSFS occurs in-phase under parallel polarisation     

Latest advances in camcorder technology

Camcorders have been developed to be compact with high performance. Latest advancement of key technologies and devices such as digital signal processing LSI, six-layer printed circuit board with micro chips, high-speed power lens with linear motor, 103 K pixels 0.7-in LCD electronic viewfinder, and high-energy Li-ion battery are described. High-band format is also explained     

Method of observation of low density interface states by means of X-ray photoelectron spectroscopy under bias and passivation by cyanide ions

X-ray photoelectron spectroscopy (XPS) measurements under bias can observe low density interface states for metal-oxide-semiconductor (MOS) diodes with low densities. This method can give energy distribution of interface states for ultrathin insulating layers for which electrical measurements cannot be performed due to a high density leakage current. During the XPS measurements, a bias voltage is applied to the rear semiconductor surface with respect to the ∼3 nm-thick front platinum layer connected to the ground, and the bias voltage changes the occupation of interface states. Charges accumulated in the interface states shift semiconductor core levels at the interface, and thus the analysis of the bias-induced shifts of the semiconductor core levels measured as a function of the bias voltage gives energy distribution of interface states. In the case of Si-based MOS diodes, the energy distribution and density of interface states strongly depend on the atomic density of silicon dioxide (SiO₂) layers and the interfacial roughness, respectively. All the observed interface state spectra possess peaked-structures, indicating that they are due to defect states. An interface state peak near the Si midgap is attributable to isolated Si dangling bonds at the interface, while those above and below the midgap to Si dangling bonds interacting weakly with Si or oxygen atoms in the SiO₂ layers. A method of the elimination of interface states and defect states in Si using cyanide solutions has been developed. The cyanide method simply involves the immersion of Si in KCN solutions. Due to the high Si-CN bond energy of ∼4.5 eV, the bonds are not ruptured at 800 °C and upon irradiation. The cyanide treatment results in the improvement of the electrical characteristics of MOS diodes and solar cells.     

Improved ADPCM voice signal transmission employing click-noisedetection scheme for TDMA-TDD personal communication systems

In personal communication systems, better voice quality and lower terminal price are essential requirements, and adaptive differential pulse-code modulation (ADPCM) codecs are one of the voice codec candidates that have good voice quality and reasonable cost. However, in slow fading environments, burst errors induce click noise in ADPCM voice signal transmission. This paper proposes a novel error-concealment scheme to improve the ADPCM voice signal transmission quality of time division multiple access time division duplex (TDMA-TDD) personal communication systems in slow fading environments. The proposed scheme employs an improved error-detection technique with PCM differential detection and overflow detection coupled with a cyclic redundancy check (CRC) code. To compensate for residual click noise, an expanded CRC error-detection signal is used. Erroneous PCM signals are adaptively suppressed according to the click-noise detection information. Hardware simulation results show that these techniques significantly improve ADPCM voice signal transmission quality by 0.5 points and 1.0 compared to that of the conventional ADPCM muting scheme and no processing, respectively, with the mean opinion scoring (MOS) test in the slow fading environments typical of personal communication systems