排序方式: 共有50条查询结果,搜索用时 218 毫秒
1.
A diode end-pumped self-Q-switched Cr,Nd:YAG laser was established with pulse duration in the range of 8-10ns. The maximum average output power was 4.4 W and the slope efficiency was 27% using an output coupler of R=70%. At pumping power of 17.4 W the laser produces high-quality pulses at 1064 nm in a TEMoo-mode. 相似文献
2.
3.
使用倾斜角沉积(GLAD)的电子束蒸发技术,制备了倾斜角度在60°~85°之间的ZnS双折射雕塑薄膜(STF)。使用X射线衍射(XRD)和扫描电镜(SEM)检测了ZnS薄膜的结晶状态和断面形貌,使用Lamda-900分光光度计测量了薄膜在不同的偏振光入射时的透过率。研究发现,室温下倾斜沉积ZnS薄膜断面为倾斜柱状结构,且薄膜的结晶程度不高。在相同的监控厚度时,随倾斜角度增大,沉积到基片上的薄膜厚度逐渐变小,但仍然大于余弦曲线显示的理论厚度。根据偏振光垂直入射时薄膜的透过光谱计算了不同角度沉积的薄膜的折射率和双折射。结果显示当倾斜角度为75°时,薄膜的双折射效应最显著,此时Δn=0.044。 相似文献
4.
Graded-index ZrO2 films has been fabricated on K9 glass by glancing angle deposition. Because the index mismatch at the interface has been reduced, the film results in wideband high-transmission antireflection. From 400nm to 1200nm, the film reflection is lower than 0.8% and the lowest value is 0.2% at 432nm. 相似文献
5.
It is well known that conventional multi-layers are oftenused for antireflective coatings[1,2]. There are, however,only a handful of optical materials available, thus limit-ing the performance that could ideally be achieved. Onthe other hand, sub-wavelength structure surfaces, whichare surface-relief gratings with periods smaller than theincident wavelength, have been researched and foundto have antireflective properties[3,8]. Compared withstandard optical thin-film coating technologies, the h… 相似文献
6.
We report a diode-pumped self-Q-switched 1064-nm Cr,Nd:YAG of 16-18 ns. The maximum average output power up to 7 W, 3370, is obtained in a simple and compact linear cavity by using transmittance of 1570. The laser operates at TEM00 mode with a laser with pulse duration in the range corresponding to a slope efficiency of a plane-concave output coupler with a pump power of 14.2 W. 相似文献
7.
A high temperature sensor based on an ultra-abrupt tapered fiber Michelson interferometer fabricated by the fusion-splicing method is proposed. The sensor consists of a single abrupt taper and the cleaved surface is used as the reflection mirror. The thermal characteristic is investigated at 25 to 1 000℃. The sensitivity of the sensor is observed to vary with the temperature, that is, 25 and 78 pm/℃ at 25-300 and 300-1 000℃, respectively. The Michelson interferometer sensors have the advantages of simple structure, cost effectiveness, compactness, and simple fabrication process. 相似文献
8.
用15 nm的纳米金标记羊抗人铜蓝蛋白抗体(GCP)可获得铜蓝蛋白(CP)纳米金探针(AuGCP). 在pH 7.8柠檬酸-磷酸氢二钠缓冲溶液中, CP与AuGCP发生特异性结合生成胶体金免疫复合物. 离心分离后, 离心液中的AuGCP可作为酒石酸铜(C4H4O6Cu)-葡萄糖反应体系的催化剂, 生成的Cu2O微粒在620 nm处有一共振散射峰. 在选定条件下, 620 nm处共振散射信号降低值△I620 nm与铜蓝蛋白浓度cCP在0.18~45 ng/mL范围内存在良好线性关系, 回归方程为 ΔI620 nm=2.27cCP+5.05, 相关系数为0.9940, 检出限为0.14 ng/mL. 该法用于人血清中铜蓝蛋白的检测, 结果满意. 相似文献
9.
Energy transport in femtosecond laser ablation can be divided into two stages:1) laser energy absorption by electrons during the pulse irradiation, and 2) phase change stage that absorbed energy redistributes in bulk materials leading to material removals. We review challenges in understanding the phase change process mainly for the femtosecond ablation of wide bandgap materials at the intensities on the order of 1013~1014 W/cm2. Thermal vaporization and Coulomb explosion are two major mechanisms considered for material removals. Based on the discussions of energy transport, the estimation equations and unsolved problems for threshold fluence and ablation depth are presented. 相似文献
10.
剪切应变量对Al-3%Mg多晶材料性能的影响 总被引:1,自引:1,他引:0
本文采用内角为105°、外角为45°的模具对多晶Al-3;Mg材料进行了等径角挤压实验,研究了等径角挤压的剪切应变量对其力学性能的影响.结果表明:等径角挤压可以显著改善多晶Al-3;Mg材料的力学性能,而且剪切应变量的大小与材料的力学性能密切相关.经过等径角挤压,Al-3;Mg合金的抗拉强度和硬度得到显著提高,其中抗拉强度提高146.8;,硬度提高104.7;,而等径角挤压一次后,Al-3;Mg合金延伸率由5.85;下降至4.59;,此后材料的延伸率得到改善. 相似文献