ICP－AES法测定金属矿产品中的磷

本文研究了铁矿石、铬矿石、锰矿石中的微量磷的电感耦合等离子体发射光谱法的测定。方法简便，具有很好的精密度和准确度。标准样品的分析结果基本与标称值相吻合，回收率在９５％－１０５％之间。     

溶胶-凝胶制备技术与新型催化材料Ⅲ.溶胶粒子表面修饰方法制备催化膜

提出用溶胶粒子表面修饰方法，结合溶胶凝胶技术制备无机催化膜．该方法的基本原理是利用合适的金属配合物在胶粒表面的吸附作用，经溶胶凝胶过程，将活性组分结合到无机膜中．实验测定结果表明：（ＮｉＥＤＴＡ）２－，ＶＯ－３，ＭｏＯ２－４，（Ｐｄ（ＮＨ３）４）２＋，ＰｄＣｌ２－４，ＰｔＣｌ２－６和ＲｈＣｌ３－６可用来修饰ＡｌＯＯＨ溶胶．以Ｐｄ／γＡｌ２Ｏ３催化膜的制备为例，经三次溶胶凝胶过程，可制得无裂缺的厚度为９μｍ的Ｐｄ／γＡｌ２Ｏ３催化膜，膜材料的平均孔直径为６ｎｍ，Ｐｄ被均匀地分布在膜的顶层，其平均粒径为２３ｎｍ．     

New ligands for the Fe(III)‐mediated reverse atom transfer radical polymerization of methyl methacrylate

A series of (di)picolinic acids and their derivates are investigated as novel complexing tridentate or bidentate ligands in the iron‐mediated reverse atom transfer radical polymerization of methyl methacrylate in N,N‐dimethylformamide at 100 °C with 2,2′‐azobisisobutyrontrile as an initiator. The polymerization rates and polydispersity indices (1.32–1.8) of the resulting polymers are dependent on the structures of the ligands employed. Different iron complexes may be involved in iron‐mediated reverse atom transfer radical polymerization, depending on the type of acid used. ¹H NMR spectroscopy has been used to study the structure of the resulting polymers. Chain‐extension reactions have been performed to further confirm the living nature of this catalytic system. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2912–2921, 2006     

凸域内单叶函数的导数

设函数f（w）为凸区域D内的单叶解析函数,对于2≤n≤8和所有w∈D,本文得到估计式|f（n）（w）/f＇（w）|的精确上界.这个结果推广了一些已知的结论.     

对位酚类衍生物作为化学发光分析的增强剂研究

在化学发光分析中，常常要用到碱性条件下鲁米诺与过氧化氢的反应系统，通过催化剂辣根过氧化物酶使反应顺利进行。如果再加入适当的增强剂，则灵敏度提高且发光时间延长，可改善测定的重现性。实验证明，对位酚类衍生物，如：对叔丁基苯酚，对甲苯酚的发光增强作用明显，其发光效率可上升几十倍，发光时间也获得有效延长。     

Diode-pumped 671 nm laser frequency doubled by CPM LBO

A design of diode-pumped high-efficiency Nd:YVO₄/LBO red laser is reported. Using critical phase-matching (CPM) LBO, 671 nm red laser was obtained from 1342 nm light by intracavity frequency doubling. With an incident pump laser of 800 mW, using type-I and type-II CPM LBO, 97 and 52 mWTEM₀₀ mode red laser outputs were obtained, with optical-to-optical conversion efficiencies of up to 12.1% and 6.5%, respectively.     

一种可能的简并谱NNS分布

利用随机矩阵理论,通过对一特殊情形的简并谱展开研究,得到了简并谱一种可能的最小相邻间距NNS分布函数．研究表明,由于简并的存在,简并谱不仅可分解成随机谱和规则谱两个子谱,同时还影响其规则谱,使规则谱的能级斥力减少．     

环保意识调查问卷的Logistic模型

本文应用多元统计分析中的方差分析 ,logistic模型等方法对环保意识调查问卷反馈的信息进行统计分析 ,建立被调查企业对环境保护意识的logistic模型 ,进而可对企业家的环境保护意识的好坏进行判断。     

Fiber-optic reflex sensor for in-line production measurement

The paper describes experiments concerning distance measurement with fiber-optic sensor and improvement of the measurement principle. The sensor probe was well-designed with a small structure and multi-function. The novel optical fiber probe arrangement as well as the possibilities of use for complex measurement problems are explained using the measurement of an internal screw thread as an example. The experimental results show that the measurement uncertainty of the thread minor diameter can reach ±10 μm, and the stability of the measurement system is better than 0.07%.     

Acoustic reflection from a baffled elastic/piezoelectric plate

A finite difference/boundary integral procedure to determine the acoustic reflected pressure from a fluid-loaded bi-laminated plate is described. The bi-laminate is composed of a piezoelectric layer and an elastic layer in contact with the fluid, and is held by an acoustically hard baffle. In the numerical model, the fluid pressure at fluid/solid interface is replaced by a continuum of point sources weighted by the normal acceleration of the elastic plate, and the governing equation system is solved in the solid domain. With the normal acceleration found, the reflected pressure in the fluid is determined by an integral expression involving the Green's function. It is demonstrated that an appropriate applied voltage potential across the piezoelectric layer has the effect of cancelling either the reflected or scattered pressure of the plate at any chosen field points in the fluid. Project supported by the National Natural Science Foundation of China (No. 10172039).