164Lu的三轴超形变核态的研究

利用TRS方法对双奇核¹⁶⁴Lu的位能面进行了计算,确认了¹⁶⁴Lu核的一条三轴超形变带,结果与实验较好地符合,同时指出了三轴超形变带的一个具体的组态     

(ΩΩ)0+ Dibaryon Productions in Central Au+Au Collisions at RHIC Energy(SNN)= 130 GeV

Based on the measured transverse mass spectra ofπr-, K-, and p at the RHIC energy s()NN = 130 GeV,di-omega productions from baryon-baryon reactions in hadronic matter are studied. Results about the (ΩΩ)0+ numbershow that the deeply bound state (ΩΩ)o+ can be observed at RHIC energies.     

Spectral manifestations of the splitting of the lowest triplet levels in Pd complexes of nonsymmetric porphyrins

Based on the study of the phosphorescence and phosphorescence excitation spectra of Pd(II) tetramethylporphyrin (PdTMP) and Pd(II) tetramethyldiethylporphyrin (PdTMDEP) in solutions in 2-methyltetrahydrofuran and dodecane in the temperature range 77–283 K, the occurrence of the splitting of the lowest degenerate singlet (S ₁) and triplet (T ₁, T ₂) levels of porphyrin molecules is established. In the absorption of molecules of the compounds studied, two components, S ₁ and S ₂, are revealed in the range of allowed long-wavelength Q(0,0) transitions (530–550 nm) and four components, T ₁–T ₄, are observed in the range of spin-forbidden intersystem crossing transitions S ₀ → T _n (560–670 nm), with all the triplet levels T ₁-T ₄ being located below the S ₁ level on the energy scale. It is shown that an increase in the degree of deformation of the porphyrin macrocycle caused by steric interactions between β alkyls and hydrogen meso atoms is accompanied by an increase in the splitting in the system of singlet levels δE(S ₂–S ₁) from 120 cm^?1 for PdTMDEP to 215 cm^?1 for PdTMP, as well as by an increase in the splitting in the system of triplet levels δE(T ₂–T ₁) from 190 cm^?1 for PdTMDEP to 250 cm^?1 for PdTMP.     

Numerical Study on Left-Handed Materials Made of Ferrite and Metallic Wires

Due to coupling effect, we show that it is difficult to realize the left-handed material by placing metallic wires directly into a ferrite matrix. However by introducing an insulating material round the metallic wires to decouple the direct interaction between the metallic wire and ferrite matrix, we have proposed two microstructures, which are shown by numerical simulation to have negative refractive indexes. The influence of microstructure on the transmission property is also examined.     

An Improved Extra-Gradient Method for Minimizing a Sum of p-norms—A Variational Inequality Approach

This paper presents a variational inequality (VI) approach to the problem of minimizing a sum of p-norms. First the original problem is reformulated as an equivalent linear VI. Then an improved extra-gradient method is presented to solve the linear VI. Applications to the problem of p-norm Steiner Minimum Trees (SMT) shows that the proposed method is effective. Comparison with the general extra-gradient method is also provided to show the improvements of the new method.     

Li^＋／MgO上乙烷氧化脱氢制乙烯的研究（Ⅱ）：催化作用机理

借助ＸＲＤ、ＩＲ、ＴＧ等技术对Ｌｉ＾＋／ＭｇＯ进行了表征，结果表明，酸、碱中心的数目，强度、催化性与Ｌｉ＾＋的添加量相关 ，起酸碱作用的表面金属离子、表面低配位氧集团、Ｏ（Ｌ ｉ＾＋Ｏ＾－）是其反应的活性物种，反应机理可能由离子基、游离基协同完成。     

固体CD光谱研究及其应用于手性席夫碱M(II)配合物

结合课题组近期的相关研究,对固体CD光谱在手性配合物研究中的应用,特别是手性样品固体CD光谱的测试方法进行了概述,通过对四对手性席夫碱M(II)(M=Ni、Cu)配合物的固体和溶液CD光谱进行比较研究,发现配合物的手性构型在固液相中保持一致,但其固液CD光谱之间存在不同程度的差异,可能是由于相应配合物在固体和溶液相中的四面体扭曲或构象的微妙不同所致.     

Preparation and electrochemistry of azobenzene self-assembled monolayers on gold--long range tunneling and end-group hydrogen bonding effect

A series of thiol-functionalied azobenzene derivatives (RAzoCnSH: R=H for n=3-6, abbreviated as AzoCnSH; R=CH(3)CONH for n=4, abbreviated as aaAzoC4SH) on gold electrodes were prepared and their self-assembly and electrochemical properties were studied by cyclic voltammetry. They all formed uniform and reproducible self-assembled monolayers (SAMs) on gold and showed well-behaved voltammetric responses in aqueous solution. Both the length of the alkyl chain spacer and the H-bonding of the end acetamino group had effects on the stability and the electrochemical kinetics of the SAMs, and the effect of the H-bonding was dominant. The surface coverage of the SAMs (AzoCnSH) is gradually increased with an increase of the alkyl chain spacer length, whereas the presence of the terminal acetamino group leads to a greater increase of the surface coverage. At a low scan rate, voltammetric responses corresponding to an irreversible two-electron, two-proton reduction/oxidation of the trans-azobenzene redox center were obtained in the range of +300 mV and -800 mV, which exhibited very large peak-to-peak splitting. At a high scan rate of 500 mV/s, two steps of reversible one-electron, one-proton reduction/oxidation corresponding to the cis-isomer in azobenzene-thiol SAMs (n is odd) was clearly observed between +300 and -200 mV. The apparent electron-transfer rate is decreased with increasing distance between the azobenzene redox center and the gold electrode. The existence of the end acetamino group which restricted the conformational change during the redox process also led to a decrease of the standard rate constant, and this restriction effect is more predominant than the distance effect.     

Surface-enhanced Raman scattering (SERS) from different azobenzene self-assembled monolayers and sandwiches

Self-assembled monolayers (SAMs) of functionalized azobenzene thiols (RAzoCnSH, n=3-6 for R=H, abbreviated as AzoCnSH; and n=4 for R=CH(3)CONH, abbreviated as aaAzoC4SH) on different substrates RAzoCnSz.sbnd;z.sfnc;S (S represents substrates of vacuum-deposited gold (Au), silver foil (Ag), HNO(3) etched silver foil (EAg), and silver mirror (mAg)) have been studied by SERS in the near-infrared region. SERS of the SAMs on EAg and/or mAg exhibit SERS effects that vary with etching time and/or deposition time. The most appropriate time is 5 s for etching in 1:1 HNO(3) and 40 s for deposition in 0.1 M Ag(NH(3))(2)NO(3). Further, a layer of Ag mirror was conveniently deposited on the top of the SAMs on different substrates, yielding a more efficient SERS-active system possessing a "sandwiched" structure of mAgz.sfnc;RAzoCnS-z.sfnc;S. An appropriate surface roughness is required for the strongest SERS effect. Scanning electron microscopy (SEM) indicates that there exist a large number of projects around 100 nm on the surface showing the strongest SERS effect. When the surface roughness is decreased or increased, the SERS effect decreases sharply. The relationship between the SERS effect and the structural nature was investigated and showed that the enhancement factor decays exponentially with increasing in distances of the azobenzene group from the underlying substrate or the overlying silver mirror. This result reveals that the SERS effect may be the result of the electromagnetic coupling effect between two metal layers.