NO adsorption on unreconstructed and reconstructed Pt(100) surface at 300 K: HREELS studies

Dissociative adsorption at 300 K is shown to proceed only on unreconstructed Pt(100)–(1×1) surface. When heated, NO (ad) layers behave in a similar way on both surfaces. Dissociation products are N₂ and O(ad). Adsorption on the (hex) surface is supported to occur in islands. The island size in the saturation layer appears to be 40 Å.     

Electrical Conductivity in a Laser Beam Channel

Russian Physics Journal - Electrical conductivity in a laser beam channel has been investigated. Oscillations of the conductivity caused by the oscillation motion of electrons in laser-induced...     

Investigation of time characteristics of photodetectors based on Ge/Si nanoheterostructures

Results of investigations into the time characteristics of photosensitive layers based on Ge/Si nanoheterostructures excited by femtosecond laser pulses with a wavelength of 1.55 μm are given. It is demonstrated that the leading front duration of the photoresponse pulse for the examined specimens excited by laser pulses of 120 fs duration does not exceed 30–40 пs.     

Influence of scattering on superluminescence in composites dye solution – nanoparticles

Spectral and energy luminescence characteristics of R6G dye solutions in ethanol with addition of Ag nanoparticle suspensions in different aggregate states are experimentally investigated. It is demonstrated that incorporation of non-aggregated and aggregated nanoparticles causes the superluminescence thresholds in R6G solutions to decrease. It is established that the optical properties of the laser beam propagation channel are transformed when low-power (20 mW) cw laser radiation passes through the suspension of nanoparticles. This is manifested through the occurrence of a region with enhanced nanoparticle density in the laser beam center, on which diffraction of laser radiation is observed.     

Atomic vibration spectra of the metallic glass Ni64Zr36

This paper describes measurements of the inelastic neutron scattering spectrum of samples of the metallic glass Ni₆₄Zr₃₆ grown using an isotope of Ni. These measurements were used to reconstruct the partial densities of vibrational states of the atoms Ni and Zr. A weakening of the interatomic interactions of Ni with surrounding atoms was identified, but found to be less important than numerical calculations predicted. Fiz. Tverd. Tela (St. Petersburg) 40, 3–6 (January 1998)     

Effect of diffraction on stimulated Raman scattering of laser radiation in the middle atmosphere

The theoretical aspects of propagation of laser radiation along slanted paths in the atmosphere at high altitudes under conditions of stimulated Raman scattering (SRS) by molecular nitrogen are considered. The SRS power conversion coefficient, the transverse intensity distribution, and the effective size of laser beams with different initial spatial profiles are numerically simulated along the propagation path. The behavior of these parameters is studied for different ratios between the optical path length and the length of free diffraction of the initial laser beam. It is shown that, at a given level of the increment of the SRS amplification, the diffraction can both increase and decrease the efficiency of the Raman interaction of waves owing to the intensity redistribution in the transverse beam profile. This effect is the most pronounced for beams with non-Gaussian initial spatial intensity profiles.     

Characterization of peptide adsorption on InAs using X-ray photoelectron spectroscopy

The well-defined structure and high stability of peptides make them attractive biotemplates for low-temperature synthesis of semiconductor nanocrystals. Adsorbed peptide monolayers could also potentially passivate semiconductors by preventing regrowth of the oxide layer. In this work, the adsorption and passivation capabilities of different collagen-binding peptides on InAs surfaces were analyzed by X-ray photoelectron spectroscopy (XPS). Before peptide functionalization, Br(2)- and HCl-based etches were used to remove the native oxide layer on the InAs surfaces. The presence of the N 1s peak for peptide-functionalized samples confirms the adsorption of peptides onto the etched InAs surfaces. Calculated coverages were similar for all peptide sequences and ranged from ～20 to 40% of a monolayer using the deconvoluted C 1s spectra and from ～2 to 5% for the N 1s spectra. The passivation ability of the peptides was analyzed by comparing the ratios of the oxide components to the nonoxide components in the XPS spectra. The thickness of the oxide layer was also approximated by accounting for the attenuation of the substrate photoelectrons through the oxide layer. We find that the oxide layer regrowth still occurs after peptide functionalization. However, the oxide layer thicknesses for peptide-functionalized samples do not reach as received levels, indicating that the peptides do have some passivation ability on InAs.