Nanocomposite hydrogel consisting of Na‐montmorillonite with enhanced mechanical properties

A new kind of nanocomposite (NC) hydrogel with Na‐montmorillonite (MMT) is presented in this article. The NC hydrogels were synthesized by free radical copolymerization of acrylamide and (3‐acrylamidopropyl) trimethylammonium chloride (ATC) in the presence of MMT and N,N′‐methylene‐bis‐acrylamide used as chemical cross‐linker. Due to the cation‐exchange reaction between MMT and ATC (cationic monomer) during the synthesis of NC hydrogels, MMT platelets were considered chemical “plane” cross‐linkers, different from “point” cross‐linkers. With increasing amount of MMT, the crosslinking degree enhanced, causing a decrease of the swelling degree at equilibrium. Investigations of mechanical properties indicated that NC hydrogels exhibited enhanced strength and toughness, which resulted from chemical interaction between exfoliated MMT platelets and polymer chains in hydrogels. Dynamic shear measurements showed that both storage modulus and loss modulus increased with increasing MMT content. The idea described here provided a new route to prepare hydrogels with high mechanical properties by using alternative natural Na‐MMT. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1020–1026     

新型含吡啶基团二羧酸配体的合成及单晶培养

以1，4-二溴-2，5-二甲基苯和4-吡啶硼酸为原料，经两步合成了一种新颖的含吡啶基团的二羧酸配体。通过核磁共振氢谱及傅里叶变换红外光谱对配体结构进行表征，通过热重分析对配体的热稳定性进行了测试；通过溶剂热法对配体的单晶进行培养，并考察反应温度、时间、pH和溶剂等条件对单晶培养的影响。结果表明：在反应温度为80 ℃，反应时间为12 h、溶剂为蒸馏水、溶液pH=5的条件下可获得高质量单晶。该配体为单斜晶系，属于C2/c空间群，结构中含有4个氧原子和2个氮原子，可为金属离子的配位提供足够的位点，有望应用于配合物的设计或催化、吸附和医药载体等行业。     

Lipase‐Supported Metal–Organic Framework Bioreactor Catalyzes Warfarin Synthesis

A green and sustainable strategy synthesizes clinical medicine warfarin anticoagulant by using lipase‐supported metal–organic framework (MOF) bioreactors (see scheme). These findings may be beneficial for future studies in the industrial production of chemical, pharmaceutical, and agrochemical precursors.     

A Novel Biomass Supported Na2CO3 System for Flue Gas Desulfurization

The breakthrough and stoichiometric SO2 adsorption efficiencies of a biomass supported Na2CO3 system (80 wt %Na2CO3/straw) have reached 48.9% and 80.6% respectively at a desulfurization temperature of 80℃.     

从诺贝尔物理学奖看光学的发展

从一个新的角度分析、讨论了光学的发展过程.并对光学今后的发展做了展望.     

生长温度对碳纳米管阴极场发射性能的影响

碳纳米管(Carbon Nanotubes,CNTs)场发射平面显示器(Field Emission Display,FED)与其他显示器比较显示了其独特优点,被认为是未来理想的平面显示器之一。碳纳米管阴极作为器件的核心部分,其性能的好坏直接影响显示器的性能。针对30~60英寸(76.2~152.4cm)大屏幕显示器所用的厚膜工艺,即采用丝网印刷法制备了碳纳米管阴极阵列,研究了化学气相沉积法在不同温度下生长的CNTs的场发射电流-电压特性,找到了适合FED用碳纳米管的最佳生长温度。结果表明生长温度越高(750℃),CNTs场发射性能越好。并用荧光粉阳极测试这些CNTs的场发射发光显示效果,验证了上述结论。     

宽带膜厚实时监控过程中膜层折射率的确定方法

为了准确计算出镀膜过程中每层膜的折射率，介绍了实时监控过程中确定膜层折射率的2种方法：一种是由实测的透射比光谱直接反算出膜层的折射率；另一种是用最小二乘法的优化算法实时拟合折射率。试验结果表明：在线反算适合单点监控，所得折射率误差小于2%。然而在实际镀膜过程中,由于宽带内膜层参数误差较大,一般大于25%。为此，采用最小二乘法拟合，即在整个宽光谱范围内采集每个波长点的信息，所得结果误差很小，一般都在2％～5%之间,有时可达到10%,在很大程度上提高了实际镀膜时膜厚监控的精度。     

Theoretical Study on the Reaction Mechanism between Dichlorocarbene and Armchair Single-walled Carbon Nanotubes

1 INTRODUCTION Carbon nanotubes have many potential applica- tions due to their unique structures and properties[1～4]. Physicists have been studying their electrical, me- chanical and other properties since their discove- ries[5, 6]. Recently, chemists are interested in carbon nanotubes because their properties can be altered by chemical functionalization[7～14], and these functiona- lized nanotubes can undergo further chemical trea- tment. So the potential application range of such na- …     

X射线衍射研究N2+注入Si

本文首先给出了180keV的N₂⁺注入Si的X射线衍射(XRD)分布,然后用Levenberg-Marquardt最优化方法模拟实验曲线。根据XRD运动学理论,在我们给出的试探胁变函数和多层模型的基础上,用自编程序计算给出了晶格胁变随注入深度、剂量和退火温度的变化。最后我们对实验和计算结果进行了初步的分析讨论。 关键词：     

能谱法和催化光度法测定无机纤维中铁含量的比较研究

本文研究了铁(Ⅲ)在酸性介质中催化抗坏血酸(Vc或H2A)还原4-硝基-3’-甲基-氨基偶氮苯的褪色反应,拟定了反应的最佳条件,探讨了反应机理,建立了催化动力学测定痕量铁的新方法,该方法的检出限为2.98×10~(-11)g·mL-1,线性范围为0-200 ng·(25 mL)-1。比较了X射线能量色散谱法和催化光度法在玄武岩纤维样品中铁含量的测定,结果误差为2.89％。