Combined effects of clay modifications and compatibilizers on the formation and physical properties of melt‐mixed polypropylene/clay nanocomposites

The melt mixing technique was used to prepare various polypropylene (PP)‐based (nano)composites. Two commercial organoclays (denoted 20A and 30B) served as the fillers for the PP matrix, and two different maleated (so‐called) compatibilizers (denoted PP‐MA and SMA) were employed as the third component. The results from X‐ray diffraction (XRD) and transmission electron microscope (TEM) experiments revealed that 190 °C was an adequate temperature for preparing the nanocomposites. Nanocomposites were achieved only if specific pairs of organoclay and compatibilizer were simultaneously incorporated in the PP matrix. For example, PP/20A(5 wt %)/PP‐MA(10 wt %) and PP/30B(5 wt %)/SMA(5 wt %) composites exhibited nanoscaled dispersion of 20A or 30B in the PP matrix. Differential scanning calorimetry (DSC) results indicated that the organoclays served as nucleation agents for the PP matrix. Generally, their nucleation effectiveness increased with the addition of compatibilizers. The thermal stability enhancement of PP after adding 20A was confirmed with thermogravimetric analysis (TGA). The enhancement became more evident as a suitable compatibilizer was further added. However, for the 30B‐included composites, thermal stability enhancement was not evident. The dynamic mechanical properties (i.e., storage modulus and loss modulus) of PP increased as the nanocomposites were formed; the properties increment corresponded to the organoclay dispersion status in the matrix. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4139–4150, 2004     

Suppression of Chaos and Phase Locking in Two Coupled Nonidentical Neurons under Periodic Input

Dynamical behaviour of two coupled neurons with at least one of them being chaotic is presented. Bifurcation diagrams and Lyapunov exponents are calculated to diagnose the dynamical behaviour of the coupled neurons with the increasing coupling strength. It is found that when the coupling strength increases, a chaotic neuron can be controlled by the coupling between neurons. At the same time, phase locking is studied by the maxima of the differences of instantaneous phases and average frequencies between two coupled neurons, and the inherent connection of phase locking and the suppression of chaos is formulated. It is observed that the onset of phase locking is closely related to the suppression of chaos. Finally, a way for suppression of chaos in two coupled nonidentical neurons under periodic input is suggested.     

反相薄层色谱法添加环糊精流动相分离d、l-色氨酸

研究了用β-环糊精(β-CD)作为流动相手性添加剂，在反相C18板上分离d、l-色氨酸对映体的薄层色谱法。该法不需将色氨酸进行衍生，流动相最佳组成配比为β-CD饱和溶液：甲酸t甲醇=9:2:1(V／V／V)，最佳分离温度为50℃。d、l-色氨酸对映体相对比移值α为1．35。     

Structure and reflective properties of Al-Cu-Fe quasicrystalline thin film prepared by laser induced arc method

Al-Cu-Fe thin films were prepared by laser induced arc (laser-arc) method from a single source—Al₆₃Cu₂₅Fe₁₂ alloy, which was proved to consist of quasicrystalline phase together with approximant phase. The composition of the deposited films meets the requirement for formation of icosahedral symmetry phase. Quasicrystalline phase was obtained after annealing the amorphous as-deposit film samples. The optical properties of the samples were investigated. Thin film samples of Al, Cu and Fe deposited under the same condition were employed for comparison. The results showed specific reflective properties of Al-Cu-Fe quasicrystal thin film in some wavelength range. The optical conductivity of the films exhibited a negative peak, centered about 440 nm in range of 190 to 800 nm. The Al-Cu-Fe quasicrystal thin films could absorb almost all the ray in the wavelength range from 420nm to 450 nm. The ratio of absorption was greater than 99%.     

关于meso—四苯基卟啉在冰醋酸中的存在形式

前言卟啉在生物化学、分析化学、药物化学等领域有着广泛研究和重要应用［１～３］。近年来虽然对卟啉类化合物的研究报道很多［４～６］，但对卟啉在酸性介质中的研究很少。较早期的研究工作认为卟啉类化合物在酸性介质中仅以其二酸形式存在［７］。本文实验结果显示ｍｅ...     

一个新颖三维配位聚合物Pb(1，4-napdc)(DMF)的合成、结构及热稳定性研究

A novel 3D metal-organic coordination polymer Pb(1,4-napdc)(DMF) (1,4-napdc=naphthalene-1,4-dicarboxylate) was synthesized at room temperature using slow vapor diffusion method to grow single crystal that has been analyzed by X-ray diffraction. The crystal belongs to orthorhombic with space group P2₁2₁2₁. The unit cell parameters are as fellows: a=0.701 3(2) nm, b=1.407 6(3) nm, c=1.521 5(4) nm, V=1.501 8(6) nm³ and Z=4. In the crystal structure of Pb(1,4-napdc)(DMF), the square grids constructed with paddle-wheel units of Pb(Ⅱ) and 1,4-napdc links stack over each other to generate infinite 3D network, which has square apertures (1.158×1.158 nm²) along the crystallographic a-axis. The thermal stability of compound was investigated by differential scanning calorimetry and thermogravimetric analysis. CCDC: 293617.     

Co-immobilization of polymeric luminol,iron(II) tris(5-aminophenanthroline) and glucose oxidase at an electrode surface,and its application as a glucose optrode

The anodic polymerization of 3-aminophthalhydrazide (luminol) and iron(II) tris 5-aminophenanthroline (Fe(phen-NH2)3(2+)) has been reported in this paper. A bilayer electrode was developed based on these polymers and the ITO conductive glass (denoted ITO[Fe(phen-NH2)3(2+)]luminol electrode). This electrode emitted light (lambdaem: 430 nm) as it was brought into contact with H2O2. At pH 10, the resulting electrochemiluminescence (ECL) showed a linear relationship with the concentration of H2O2 in the range of 10 microM(-1) mM. This bilayer electrode also showed an application potential for the detection of glucose after being further modified with glucose oxidase (denoted ITO[Fe(phen-NH2)3(2+)]luminol]GOx electrode). Although the resulting ECL decayed more rapidly in concentrated glucose solutions (e.g., I M) because of the consumption of luminol during use, the decay became less severe in diluted glucose solutions (e.g., 10 mM). According to the flow injection analysis, a linear relationship existed between the ECL and the concentration of glucose from 10(-5)-10(-3) M at pH 9. The detection limit could reach a level of 5 x 10(-5) M at this pH.     

Size of Micelles Determined by Static Fluorescence Quenching

We developed a new method to measure the average aggregation number of large rod-like micelles using static fluorescence self-quenching of a solubilized fluorophore. The method is based on the increase of self-quenching of micelle-solubilized pyrene through excimer formation. We consider the effect of random distribution of pyrene in micelles and the micellar size distribution. The measured average aggregation <n> _M is based on a new M-weighted raging similar to our exponential-weighted averaging in the transient decay method. We apply this method to study the effect of a large concentration of salt on the average aggregation behavior of sodium dodecyl sulfate (SDS) and cetyle tetraammonium bromide (CTAB). The sizes increase with increasing ionic concentrations. For SDS, we used the thermodynamic model developed by Missel et al. to calculate < n > _M which we compare with experimental results.