Characteristics investigation on heat transfer growth of sonochemically synthesized ZnO-DW based nanofluids inside square heat exchanger

Journal of Thermal Analysis and Calorimetry - In recent decades, the growth of heat transfer using nanomaterials in the conventional base fluid has caught the attention of researchers...     

Survivability in IP-over-WDM Networks: WDM Lightpath Protection versus IP LSP Protection

This article compares the performance of WDM lightpath protection and IP LSP protection schemes for IP-over-WDM networks. A mathematical formulation of the maximum throughput problem is presented and analytical expressions for recovery time are derived for both schemes. The throughputs and recovery times are analyzed and compared. Results show that the IP LSP protection scheme presents higher throughputs then WDM lightpath protection. The IP LSP protection scheme, providing individual IP LSP protection has, however, scalability problems. This scheme presents high recovery times when a failure affects many lightpaths and many hops are allowed for the primary routes of IP LSPs.     

The effect of rapid rotation on a vertical bridgman furnace at large Rayleigh number

In quasi-steady operation, convection currents in a Bridgmandevice, used for producing a semi-conductor crystal, createinhomogeneities that may make the crystal unusable. It has oftenbeen suggested that additional forces due to rotation or magnetismmight be efficacious in reducing the segregation of the elementsof the alloy. It has been found that, over a wide range of rotationrates, there is no improvement in performance due to rotationabout the vertical axis. However, numerical results that havebeen obtained previously (Lee & Pearlstein, J. Crys. Growth240, 2002) indicate that, when effects of centrifugal buoyancyare introduced, a substantial reduction in segregation is achieved.In the work reported here, by contrast, in which we extend previouslarge-Rayleigh-number asymptotic analysis to include centrifugalbuoyancy, we find no improvement in radial segregation, butrather increasing segregation with increasing rotation rate.     

Analysis and finite element simulations of a second‐order fluid model in a bounded domain

This article is concerned with the equations governing the steady motion of a viscoelastic incompressible second‐order fluid in a bounded domain. A new proof of existence and uniqueness of strong solutions is given. In addition, using appropriate finite element methods to approximate a coupled equivalent problem, sharp error estimates are obtained using a fixed point argument. The method is applied to the two‐dimensional lid‐driven cavity problem, at low Reynolds number and in a certain range of values of the viscoelastic parameters, to analyze the combined effects of inertia and viscoelasticity on the flow. © 2007 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq, 2007     

Binding evaluation of isoform 1 fromCratylia mollis lectin to human mammary tissues

The phenomenon of altered carbohydrates in transformed cell surfaces has been studied through histochemical techniques using lectins. Specific binding patterns to normal and transformed mammary tissues were evaluated by Isoform 1 fromCratylia mollis lectin (Cra Iso 1). Protocols using a direct method, incubation of Cra Iso I conjugated to peroxidase (Cra Iso 1-Per) with mammary tissues, followed by diaminobenzidine and hydrogen peroxidase interaction, were performed. Neoplastic tissues, marked by Cra Iso 1, showed a higher intensity of staining than normal ones, in comparison withCanavalia ensiformis lectin, Concanavalin A (Con A), conjugated to peroxidase (Con A-Per). The assay with Cra Iso 1 also indicated a possible utilization of this lectin to characterize normal and transformed mammary cells.     

Technological quality determination of pharmaceutical disintegrant by DSC cooling and DSC photovisual

A number of disintegrants are available on the market. They improve tablets’ disintegration. The objective of this work is the comparison of the technological quality parameters of disintegrants using different analytical techniques. Three batches of disintegrants and their binary mixtures (water:disintegrants) were investigated. Cooling experiments were used from –30 up to 200°C. The data obtained showed calorimetric differences between the samples. In the binary mixtures water showed different crystallization behaviour from the one found in the literature. According to the results DSC technique helped the quality control of different disintegrants.     

Palladium-catalyzed arylation of allylic benzoates using hypervalent siloxane derivatives

Palladium-catalyzed cross-coupling of hypervalent arylsiloxane derivatives proceeded in good to excellent yields with allylic benzoates. Arylation occurred with complete inversion of configuration. The scope and limitations of this reaction, an alternative to the Stille coupling, is summarized.     

Kinetics and Mechanism of Ni(II) Chelation in Model and Real Solutions of Xylem Sap of Quercus ilex

The kinetics of formation and dissociation of Ni(II) complexes with oxalic and citric acids was studied by cyclic voltammetry in model solutions of xylem sap of Q. ilex (the dominant tree growing on serpentine soils of Northeast Portugal) using representative concentrations, pH and ionic strength. The role of magnesium on complex formation was analyzed from solutions where Mg is present at concentration levels found in the xylem sap of Q. ilex growing on both nonserpentine and serpentine soils. Kinetics studies were also done in diluted solutions of real xylem sap samples, spiked with increasing amounts of magnesium. The values obtained for the apparent rate constants were those anticipated by the proposed model. To test the validity of the methodology and mechanisms, formation rate constants, k_f (M^?1 s^?1) of Ni(II) complexes with citrate and oxalate were evaluated that compare with the values from Eigen mechanism.     

Performance of a sound card as data acquisition system and a lock-in emulated by software in capillary electrophoresis

The performance of fluorescence detectors in capillary electrophoresis is maximized when the excitation light intensity is modulated in time with optimal frequencies. This is especially true when photomultiplier tubes are used to detect the fluorescent light. The photomultiplier tube amplified raw output signal can in principle be captured directly by a personal computer sound card (PCSC) and processed by a lock-in emulated by software. This possibility is demonstrated in the present work and the performance of this new setup is compared with a traditional data acquisition system. The results obtained with this “PCSC and lock-in emulated by software” were of the same quality or even better compared to that obtained by conventional time integrators (Boxcars) and data acquisition boards. With PCSC the limits of detection (LOD) found for both naphthalene-2,3-dicarboxaldehyde-derivatized tyrosine and alanine were 3.3 and 3.5 fmol (injection of 5 nL of samples at 0.66 and 0.70 μmol/L), respectively. This is at least three times better compared to conventional systems when light emitting diodes (LEDs) are used as the excitation source in fluorescence detectors. The PCSC linear response range was also larger compared to conventional data acquisition boards. This scheme showed to be a practical and convenient alternative of data acquisition and signal processing for detection systems used in capillary electrophoresis.     

Multiple bonds between main group elements and transition metals, 155. (Hexamethylphosphoramide) methyl(oxo) bis(η-peroxo)rhenium(VII), the first example of an anhydrous rhenium peroxo complex: crystal structure and catalytic properties

Methyl(oxo)bis(η²-peroxo)rhenium(VII)1, the active species of the system CH₃ReO₃/H₂O₂ in the catalytic oxidation of different organic and organometallic compounds, is stabilized by a water molecule attached to the rhenium center. This water molecule can be removed and substituted by hexamethylphosphoramide (HMPA) to yield (hexamethylphosphoramide)methyl(oxo)bis(η²-peroxo rhenium(VII) (3). The synthesis, crystal structure (X-ray difraction study), and catalytic properties of which compound are reported. Crystal data are as follows: monoclinic, space group P2₁/n, A = 900.76(7) pm, B = 1229.80(11) pm, C = 1318.57(11) pm, β = 90.251(7)°, R_w = 0.034 for 1878 reflections. The catalytic properties of compound 3 in the oxidation of olefins with H₂O₂ are similar to those of 1.