Determination of cyclosporin A in the serum of kidney transplant patients by rapid-flow fractionation and normal-phase high-performance liquid chromatography

High-performance liquid chromatography was used to determine cyclosporin A (CsA) concentrations in the serum of kidney transplant patients by rapid-flow fractionation (RFF) followed by silica gel normal-phase high-performance liquid chromatography (HPLC). The extraction of CsA from serum was achieved by RFF using a short diatomaceous earth column eluted with diethyl ether-n-hexane (50:50, v/v). The recovery was more than 80% at concentrations of 50-150 micrograms/l. The concentration of this compound was determined by HPLC using a conventional silica gel column with 3.3 M ammonia solution-ethanol-n-hexane (0.31:10.69:89, v/v) as eluent. Concentration calibration was made on the basis of the peak-height ratio of CsA to CsD as the internal standard. The coefficient of variation of this assay was less than 6.5% and the results were used for the therapeutic drug monitoring of CsA administered to kidney transplant patients. Measurements of the CsA concentrations in 160 serum specimens were also made by conventional radioimmunoassay (RIA) using commercial kits. The data obtained by RIA were on average 2.5 times those obtained by HPLC. Higher values in RIA were observed characteristically with patients with severe disfunction resulting from CsA hepatotoxicity. From the results, it appeared that HPLC rather than RIA provides more precise and reliable values for the concentration of this drug.     

Role of the special pair in the charge-separating event in photosynthesis

We synthesized special-pair/electron-acceptor systems consisting of a complementary slipped cofacial dimer of imidazolyl-substituted zinc porphyrin, bearing pyromellitdiimide as the electron acceptor. In the case of the dimer, the first and second oxidation potentials were split into a total of four peaks in the differential pulse voltammetry measurement. Furthermore, the shift values of the first oxidation potentials obtained by changing the solvent polarity for the dimer were almost half of those observed for the monomer. These results indicate that the radical cation is delocalized over the whole pi system of the dimer. Time-resolved transient absorption measurements revealed that, relative to the corresponding monomer, the dimer accelerated the charge separation rate, but decelerated the charge recombination rate. The smaller reorganization energy of the slipped cofacial dimer relative to that of the monomeric system demonstrates the significance of the special-pair arrangement for efficient charge separation in photosynthesis.     

Characterization of cationic acid phosphatase isozyme from rat liver mitochondria.

Acid phosphatase isozyme was highly purified from rat liver mitochondrial fraction. The enzyme showed an isoelectric point value of above 9.5 on isoelectric focusing, and the apparent molecular weight was estimated to be 32000 by Sephadex G-100 gel filtration or 16000 by sodium dodecyl sulfate-polyacrylamide gel electrophoresis. The enzyme catalyzed the hydrolysis of adenosine 5'-triphosphate, adenosine 5'-diphosphate, thiamine pyrophosphate, inorganic pyrophosphate, and phosphoprotein such as casein and phosvitin, but not of several phosphomonoesters, except for p-nitrophenyl phosphate and o-phosphotyrosine. The enzyme was not inhibited by L-(+)-tartrate, and was significantly activated by Fe2+ and reducing agents such as ascorbic acid, L-cysteine,and dithiothreitol. The enzyme was found to be distributed in various rat tissues including liver, spleen, kidney, small intestine, lung, stomach, brain and heart, but not in skeletal muscle.     

Preparation and characterization of polypropylene/mesoporous silica nanocomposites with confined polypropylene

Polypropylene (PP)/Ti-MCM-41 nanocomposites were prepared by isospecific propylene polymerization with Ti-MCM-41/Al(i-C₄H₉)₃ catalyst. The cross polarization/magic angle spinning (CP/MAS) ¹³C NMR spectrum of the composite was similar to that of the conventional isotactic PP, and the decrease in the pore volume of Ti-MCM-41 in the nanocomposites, as measured by N₂ adsorption, was consistent with the value calculated from the weight loss in the thermogravimetric analysis (TGA) curve; both these facts attest to propylene polymerization within the mesopores of Ti-MCM-41. Alkali treatment followed by extraction with o-dichlorobenzene allows us to extract the confined PP out of the Ti-MCM-41 mesopores. Although the PP/Ti-MCM-41 nanocomposites do not exhibit a crystalline melting point, the same PP when extracted from the mesopores showed a clear melting point at 154.7 °C; this indicates that the crystallization of PP confined in mesopores is strongly hindered. For the PP polymerized within the confinement, the molecular weight (M_w) and molecular weight distribution (M_w/M_n) were 84,000 and 4.3, respectively; these values were considerably smaller than those of the PP polymerized concurrently outside the Ti-MCM-41 mesopores (M_w = 200,000–450,000, M_w/M_n = 40–75). Therefore, the confinement also has a marked effect on the molecular weight of the PP. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 3324–3332, 2003     

Synthesis of chiral 2-(anilinophenylmethyl)pyrrolidines and 2-(anilinodiphenylmethyl)pyrrolidine and their application to enantioselective borane reduction of prochiral ketones as chiral catalysts

Chiral diamines, 2-(anilinophenylmethyl)pyrrolidines and 2-(anilinodiphenylmethyl)pyrrolidine, were prepared from N-(tert-butoxycarbonyl)pyrrolidine or (S)-proline as a starting material, respectively. These chiral diamines were efficient for the catalytic enantioselective borane reduction of acetophenone. Using (S)-2-(anilinodiphenylmethyl)pyrrolidine, chiral secondary alcohols were obtained from prochiral ketones with good to excellent enantiomeric excesses (up to 98% ee).     

Investigation of radon and thoron concentrations in a landmark skyscraper in Tokyo

The temporal variation of the radon concentration, and the radon and thoron concentrations every 3 months for a year were measured using two types of devices in a landmark skyscraper, the Tokyo Metropolitan Government Daiichi Building. In the measurement of temporal variation of the radon concentration using a pulse type ionization chamber, the average radon concentration was 21 ± 13 Bq m^?3 (2–68 Bq m^?3). The measured indoor radon concentration had a strong relationship with the operation of the mechanical ventilation system and the activities of the office workers. The radon concentration also increased together with temperature. Other environmental parameters, such as air pressure and relative humidity, were not related to the radon concentration. In the long-term measurements using a passive radon and thoron discriminative monitor, no seasonal variation was observed. The annual average concentrations of radon and thoron were 16 ± 8 and 16 ± 7 Bq m^?3, respectively. There was also no relationship between the two concentrations. The annual average effective dose for office workers in this skyscraper was estimated to be 0.08 mSv y^?1 for 2000 working hours per year. When considering the indoor radon exposure received from their residential dwellings using the annual mean radon concentration indoors in Japan (15.5 Bq m^?3), the annual average effective dose was estimated to be 0.37 mSv y^?1. This value was 31 % of the worldwide average annual effective dose.