Polypyrrole Shell@3D‐Ni Metal Core Structured Electrodes for High‐Performance Supercapacitors

Three‐dimensional (3D) nanometal films serving as current collectors have attracted much interest recently owing to their promising application in high‐performance supercapacitors. In the process of the electrochemical reaction, the 3D structure can provide a short diffusion path for fast ion transport, and the highly conductive nanometal may serve as a backbone for facile electron transfer. In this work, a novel polypyrrole (PPy) shell@3D‐Ni‐core composite is developed to enhance the electrochemical performance of conventional PPy. With the introduction of a Ni metal core, the as‐prepared material exhibits a high specific capacitance (726 F g^?1 at a charge/discharge rate of 1 A g^?1), good rate capability (a decay of 33 % in C_sp with charge/discharge rates increasing from 1 to 20 A g^?1), and high cycle stability (only a small decrease of 4.2 % in C_sp after 1000 cycles at a scan rate of 100 mV s^?1). Furthermore, an aqueous symmetric supercapacitor device is fabricated by using the as‐prepared composite as electrodes; the device demonstrates a high energy density (≈21.2 Wh kg^?1) and superior long‐term cycle ability (only 4.4 % and 18.6 % loss in C_sp after 2000 and 5000 cycles, respectively).     

The Combinatorics of Laguerre,Charlier, and Hermite Polynomials

This paper describes several combinatorial models for Laguerre, Charlier, and Hermite polynomials, and uses them to prove combinatorially some classical formulas. The so-called “Italian limit formula” (from Laguerre to Hermite), the Appel identity for Hermite polynomials, and the two Sheffer identities for Laguerre and Charlier polynomials are proved. We also give bijective proofs of the three-term recurrences. These three families form the bottom triangle in R. Askey's chart classifying hypergeometric orthogonal polynomials.     

不同重力环境下辐射加热材料表面着火特性分析

研究外界辐射加热下，不同重力环境中热薄燃料的着火特性．探讨了重力、环境氧浓度、环境压力及外界辐射强度对着火的影响．结果表明，随着重力的变化，存在不同的着火机制．在微重力和在高的环境氧浓度中，材料的着火延迟时间变短．压力减小，着火延迟时间增大．随着辐射强度的增大，着火延迟时间变小．     

曲轴箱窜气量检测仪的研制

介绍了车用压差式气体流量传感器的结构设计和电测电路，指出了传感器的使用范围，由实验测出了特性曲线．该仪器可检测车用发动机曲轴箱窜气量，适用于发动机不解体故障诊断．     

SPME-GC-MS快速分析炼油厂废水中痕量VOCs

采用固相微萃取-气相色谱-质谱联用(SPME-GC-MS)对炼油厂废水中痕量挥发性有机化合物(VOCs)进行了定性分析,简化了预处理过程,总分析时间为1h左右.对比处理前后的废水样品的MS定性结果,为废水处理工艺的评价以及有机物降解机理提供了依据.     

蓝宝石R面上ZnO薄膜的NH3掺杂研究

以NH₃为掺杂源,利用金属有机化学气相沉积(MOCVD)系统在蓝宝石R面上生长出掺氮ZnO薄膜。通过XRD,SEM测量优化了其生长参数,在610℃和在80sccm的NH₃流量下生长出了〈1120〉单一取向的ZnO薄膜。经Hall电阻率测量,得知该薄膜呈现弱p型或高电阻率,并对其光电子能谱进行了研究。     

Differential pulse anodic stripping voltammetric determination of traces of copper with a tobramycin-Nafion modified electrode.

A Nafion-modified glassy carbon electrode incorporated with tobramycin for the voltammetric stripping determination of Cu2+ has been explored. The electrode was fabricated by tobramycin containing Nafion on the glassy carbon electrode surface. The modified electrode exhibited a significantly increased sensitivity and selectivity for Cu2+ compared with a bare glassy carbon electrode and the Nafion modified electrode. Cu2+ was accumulated in HAc-NaAc buffer (pH 4.6) at a potential of -0.6 V (vs. SCE) for 300 s and then determined by differential pulse anodic stripping voltammetry. The effects of various parameters, such as the mass of Nafion, the concentration of tobramycin, the pH of the medium, the accumulation potential, the accumulation time and the scan rate, were investigated. Under the optimum conditions, a linear calibration graph was obtained in the concentration range of 1.0 x 10(-9) to 5.0 x 10(-7) mol l(-1) with a correlation coefficient of 0.9971. The relative standard deviations for eight successive determinations were 4.3 and 2.9% for 1.0 x 10(-8) and 2.0 x 10(-7) mol l(-1) Cu2+, respectively. The detection limit (three times signal to noise) was 5.0 x 10(-10) mol l(-1). A study of interfering substances was also performed, and the method was applied to the direct determination of copper in water samples, and also in analytical reagent-grade salts with satisfactory results.     

BEPCⅡ LINAC束流光学匹配及轨道校正计算研究

 北京正负电子对撞机直线注入器(BEPCⅡ LINAC)的升级改进要求建立束流光学匹配计算和轨道校正系统，为此对束流光学匹配计算和轨道校正计算的方法进行了研究，并采用VC++语言编写了相应的程序，利用最小二乘法原理进行了束流光学匹配计算，模拟了束流轨道校正，取得了较为理想的结果。     

空间有源消声的微机控制

本文讨论用通用微机控制空间有源消声．以修正的PID（比例、积分、微分）算法加上逻辑判断构成的控制软件，使得系统收敛迅速，跟踪速度快，消声效果令人满意，而且系统工作稳定可靠，     

屋顶绿化的自动灌溉系统设计

屋顶绿化对提高城市空气质量、减少“热岛效应”、改善居住环境有积极的意义，但其灌溉环节与普通园林绿化灌溉相比有更高的要求．为了增强屋顶灌溉的科学性，根据其特点提出了建立自动灌溉系统的设想，并对灌溉过程建立了混杂自动机模型，从离散事件动态系统与连续变量动态系统的角度共同描述了自动灌溉的过程，最后给出了自动灌溉系统的工程设计方案，对屋顶绿化自动化、精细化程度的提高具有一定的启示意义．