Linear and Nonlinear Optical Properties Of Racemic (±)2-(α-Methylbenzylamino)-5-Nitropyridine Single Crystals

Linear and nonlinear optical properties of racemic (±)2-(α-methylbenzylamino)-5-nitropyridine ((±)MBANP) single crystals have been comprehensively investigated and compared with those of the enantiomorph (–)2-(α-methylbenzylamino)-5-nitropyridine ((–)MBANP) crystals. (±)MBANP crystal exhibits very high chemical and physical stability, but relatively small nonlinear optical coefficients (d₃₁ = 6.8 pm/V, d₃₂ = 4.7 pm/V, d₃₃ = 0.84 pm/V). A comparison between the nonlinear optical coefficients of (±)MBANP and (–)MBANP demonstrates the validity of the oriented-gas model in molecular crystals that neglects all the contributions from intermolecular interaction.     

Syntheses and electrical conductivity of polyamides containing tetrathiafulvalene moieties in the main chain

Novel polyamides that contain tetrathiafulvalene (TTF) moieties were synthesized by direct polycondensation of Δ^2,2′ -bi-1,3-dithiole-4,4′(5′)-dicarboxylic acid with aromatic diamines in the presence of triphenylphosphine, hexachloroethane, and pyridine. Complexes of these polyamides with bromine were TTF cation radical () salts which resulted from the charge transfer of TTF moieties to bromine. The electrical conductivity of undoped polyamides increased with a decrease in diamine length. By doping the bromine the conductivity of the polyamides was enhanced by 3–5 orders of magnitude and reached 10^?5–;10^?9S cm^?1. Maximum conductivity was observed at the doping ratio of [Br]/[repeat unit] < 1. The electrical conduction in the bromine complexes may be attributed to the hopping of odd electrons of between TTF moieties.     

Improved Crystallinity of Poly(3-hexylthiophene-2,5-diyl):[6,6]-Phenyl-C61 Butyric Acid Methyl Ester Film by Pulsed Electrospray Deposition

We investigated crystallinity parameters and ordering domains of poly(3-hexylthiophene-2,5-diyl) blended in [6,6]-phenyl-C₆₁-butyric acid methyl ester films, which were fabricated by pulsed electrospray deposition methods. The crystallinity parameter and the ordering domain were estimated from Raman and optical absorption spectra, respectively. As a result, they were improved with decreasing the off time of pulse voltage, corresponding to the slow evaporation speed of solvent. In addition, both the space-charge limited current mobility and the photoconversion efficiency showed same trend. A highest photoconversion efficiency of 1.11 % was achieved without the thermal annealing process after depositing the active layer.     

Spin Excitations in the Field-Induced Phase of the Quasi-One-Dimensional S = 1 Heisenberg Antiferromagnet NDMAP

The S = 1 quasi-one-dimensional Heisenberg antiferromagnet [Ni(C₅H₁₄N₂)₂N₃](PF₆), abbreviated as NDMAP, has been studied by electron spin resonance in a magnetic field above the critical field (H _c). We studied angular and frequency dependences of spin excitations. The angular dependence of the spin excitations in the vicinity of H _c is explained well by a phenomenological field theory, but the agreement between the experiment and the calculation is not satisfactory above 10 T. In high magnetic fields above 15 T, we obtained some characteristic spin excitations which are well explained by conventional antiferromagnetic resonance modes. These results suggest that the spin excitations change from a quantum state to a classical one due to the suppression of quantum fluctuations by high magnetic fields.     

Preparation of an Organized Film Composed of Polymers,Avidin, and Concanavalin A and Its Binding Properties

The multilayer thin films composed of polymers, avidin, and concanavalin A (Con A) were prepared on the surface of a quartz slide by alternate deposition of anionic and cationic polymers and the proteins. The loading of avidin and Con A in the film was evaluated spectroscopically by using Texas Red tagged avidin and Con A. Avidin molecules assembled in the film caused its binding activity toward biotin and analogue 2-(4′-hydroxyphenylazo)benzoic acid to be retained. The polymer layers contributed to improving stability of the protein film.

Polymer/Con A/avidin composite film on a solid surface.     

The structure and ordering of ε-MnO2

The presence of ε-MnO₂ as a major component of electrolytic manganese dioxide (EMD) has been demonstrated by a combined X-ray diffraction/transmission electron microscopy (TEM) study. ε-MnO₂ usually has a partially ordered defect NiAs structure containing 50% cation vacancies; these vacancies can be fully ordered by a low temperature (200 °C) heat treatment to form a pseudohexagonal but monoclinic superlattice.Numerous fine-scale anti-phase domain boundaries are present in ordered ε-MnO₂ and cause extensive peak broadening and a massive shift of a very intense, 0.37 nm superlattice peak. This suggests a radically different explanation of the ubiquitous, very broad ∼0.42 nm peak (∼21-22° 2θ, CuKα radiation) in EMDs, which heretofore has been attributed to Ramsdellite containing numerous planar defects. This work confirms the multi-phase model of equiaxed EMDs proposed by Heuer et al. [ITE Lett. 1(6) (2000) B50; Proc. Seventh Int. Symp. Adv. Phys. Fields 92 (2001)], rather than the defective single-phase model of Chabre and Pannetier [Prog. Solid State Chem. 23 (1995) 1] and Bowden et al. [ITE Lett. 4(1) (2003) B1].     

Proton-induced cis-trans conversion of a platinum(II) center coordinated by L-cysteinatocobalt(III) metalloligands

Treatment of LambdaL-[Co(L-cys-N,S)(en)2]+ (l-H2cys = L-cysteine) with [PtCl4]2- in water, followed by the addition of acid, gave an S-bridged CoIII2PtII trinuclear complex ([1]4+), which was reversibly converted to its deprotonated complex ([2]2+) in an aqueous solution. While [1]4+ formed only a trans isomer, [2]2+ existed as a mixture of trans and cis isomers. The selective formation of a cis isomer was achieved by treatment of [1]4+ or [2]2+ with phthalic acid in water, which afforded a unique CoIII4PtII2 hexanuclear complex ([3]4+). Complex [3]4+ was reverted back to [1]4+ by treatment with aqueous HCl, accompanied by the complete cis-to-trans conversion.     

Stability of sol–gel derived glass coated Eu complex using deuterated methanol

A high‐stability Eu complex has been achieved by coating with a silica glass via a low temperature sol–gel process using deuterated methanol. A three‐dimensional glass network protects the Eu complex from free oxygen and/or water to change the ligand structure. In addition, the chemical bond of the deuterated Eu complex is more stable than that of the conventional Eu complex. Therefore, we achieved a high‐thermal‐stability Eu complex encapsulated by a sol–gel derived silica glass using deuterated methanol instead of ethanol.

     

Bulk heterojunction organic photovoltaic cell fabricated by the electrospray deposition method using mixed organic solvent

A high‐efficiency bulk heterojunction organic photovoltaic cell (OPV) was achieved by the electrospray deposition method. The surface roughness of the P3HT:PCBM thin film can be reduced using the mixed solvent consisting of o‐dichlorobenzene (o‐DCB) and acetone. The effect of acetone concentration is related to its dielectric constant. Under an optimized concentration of acetone in o‐DCB (20 vol%), the P3HT/PCBM active layer with a smooth surface can be formed, and the power conversion efficiency of the OPV was 1.9%.

     

Computational Modeling of O-Linked Glycan Biosynthesis in CHO Cells

Glycan biosynthesis simulation research has progressed remarkably since 1997, when the first mathematical model for N-glycan biosynthesis was proposed. An O-glycan model has also been developed to predict O-glycan biosynthesis pathways in both forward and reverse directions. In this work, we started with a set of O-glycan profiles of CHO cells transiently transfected with various combinations of glycosyltransferases. The aim was to develop a model that encapsulated all the enzymes in the CHO transfected cell lines. Due to computational power restrictions, we were forced to focus on a smaller set of glycan profiles, where we were able to propose an optimized set of kinetics parameters for each enzyme in the model. Using this optimized model we showed that the abundance of more processed glycans could be simulated compared to observed abundance, while predicting the abundance of glycans earlier in the pathway was less accurate. The data generated show that for the accurate prediction of O-linked glycosylation, additional factors need to be incorporated into the model to better reflect the experimental conditions.