Mass and isotopic concentrations of water-insoluble refractory carbon in total suspended particulates at Mt.Waliguan Observatory(China)

Mass concentration and isotopic values δ¹³C and ¹⁴C are presented for the water-insoluble refractory carbon（WIRC） component of total suspended particulates（TSP）,collected weekly during 2003,as well as from October 2005 to May 2006 at the WMO-GAW Mt.Waliguan（WLG） site.The overall average WIRC mass concentration was（1183±120）ng/m³（n = 79）,while seasonal averages were 2081 ±1707（spring）,454±205（summer）,650±411（autumn）,and 1019±703（winter） ng/m3.Seasonal variations in WIRC mass concentrations were consistent with black carbon measurements from an aethalometer,although WIRC concentrations were typically higher,especially in winter and spring.The δ¹³C PDB value（-25.3 ± 0.8）%.determined for WIRC suggests that its sources are C₃ biomass or fossil fuel combustion.No seasonal change in δ¹³C PDB was evident.The average percent Modern Carbon（pMC） for ¹⁴C in WIRC for winter and spring was（67.2 ± 7.7）%（n = 29）.Lower pMC values were associated with air masses transported from the area east of WLG,while higher pMC values were associated with air masses from the Tibetan Plateau,southwest of WLG.Elevated pMC values with abnormally high mass concentrations of TSP and WIRC were measured during a dust storm event.     

Low Cost, High Efficiency, Gain Flattened L Band EDFA Using FBGs as C Band Seed Generators

A low cost, coolerless 980nm diode pumped, gain flattened L band EDFA with fast transient control, high pump efficiency and gain clamping effect was realized by using FBGs as C band seed generators.     

The Monitoring System Using FOBG Sensor for The Health of the Rocket

A novel heath monitoring system of the rocket based on fiber optic Bragg gratings is brought forward, its component units and working principle are also described.     

Millimeter wave beams diffracted from reflecting gratings

According to the angular-spectrum method, a radiation beam of an antenna horn in the Fresnal region is decomposed into the plane waves with the fast Fourier transform algorithm and the waves diffracted from a reflection grating are superposed as a diffracted beam. Compared with the reflected beam from the same size mirror, the radiation half width of the diffracted beam from a grating is narrower and its lateral shape is shift. These performances have been experimentally verified at Ka-band by: (1). The relative diffraction efficiencies in the first order with two triangular gratings which is put along propagating direction of a beam produced by a conical lens-horn. (2). H-plane lateral width with power—3dB lapsed of the focus beam from a grating and a mirror in a grating spectrometer for millimeter waves (25–100 GHz).     

Thin strain-relaxed SiGe grown by ultrahigh vacuum chemical vapor deposition

Large-scale preparation of thin strain-relaxed SiGe is achieved by combining ion implantation and ultrahigh vacuum chemical vapor deposition. The resulting materials were analyzed by double crystal X-ray diffraction, micro-Raman spectroscopy, and tapping mode atomic force microscope. Results revealed that 100-nm-thick Si_0.7Ge_0.3 layers with the diameter of 125 mm and full strain relaxation are successfully prepared by pre-modifying the Si substrates using 50 keV Ar⁺ ions. The strain relaxation is also disclosed to change with both ion species and energy. However, post-modification of SiGe by ion implantation will cause serious damage to the crystal structures, and result in the formation of poly-crystal SiGe.     

一类随机环境中的随机游动

在Solomn的模型的基础上对一类随机环境中随机游动进行了讨论，并得出了一个常返性准则和一些极限性质。     

拟线性抛物型方程广义解的局部有界性

本文给出了一类较广泛的拟线性抛物型方程广义解的局部有界性,进而也得到了解的Holder连续性.     

合肥同步辐射软X射线显微术研究

合肥国家同步辐射实验室首期建设的光束线之一用于软Ｘ射线显微成像研究。实验站现已装置初型的扫描透射Ｘ射线显微镜，并正在进行亲一代的扫描显微建设，同时还使同步辐射光进行接触软Ｘ射线呈微成像研究，并对选取的一些生物样品进行了成像试验。本文介绍了合肥同步辐射光源上软Ｘ射线显微术实验线站的建设及完成的一些实验结果。     

铜在HOPG上电沉积过程的现场ECSTM研究

用自制的电化学扫描隧道显微镜（ＥＣＳＴＭ）现场研究Ｃｕ在ＨＯＰＧ上的电沉积过程．结果表明Ｃｕ在ＨＯＰＧ上的电沉积为三维成核的过程．当电位较低或Ｃｕ２＋离子浓度较低时，铜在本体金属生长主要沿着台阶方向．过电位较高时，铜的成核数目增加，沉积层的晶粒有所细化．同时，非现场ＥＣＳＴＭ比较研究表明，ＳＴＭ针尖对针尖局部区域的电沉积起屏蔽作用，针尖所在区域Ｃｕ的沉积速度比其它区域明显减小     

The evolution of morphology of ordered porous TiO2 films fabricated from sol-gel method assisted ZnO nanorod template

Ordered porous TiO₂ films, including TiO₂ nanotube arrays, are fabricated by a sol-gel dip-coating approach via ZnO nanorod templates obtained from aqueous solution approach. The results indicate that the morphologies of ordered porous TiO₂ films have been great affected by the sol-gel dip-coating cycle number. Open-ended TiO₂ nanotube arrays can be obtained in optimum dip-coating cycle numbers. The TiO₂ nanotubes with the inner diameter matching well with the diameters of ZnO nanorods, are well assembled and separate each other. When the cycle number is less than this optimum value, no intact porous TiO₂ film can be obtained. As the cycle number is larger than this optimum value, an ordered porous TiO₂ film with many throughout holes is formed. The evolutive mechanism of ordered porous TiO₂ films is proposed.