Properties of polystyrene-poly(methylmethacrylate) random and diblock copolymers in dilute and semidilute solutions

Solution properties for random and diblock copolymers of polystyrene (PS) and poly(methyl methacrylate) (PMMA) have been measured by dynamic and total intensity light scattering in solvents of differing quality. The results are compared with the corresponding properties for PS and PMMA homopolymers of similar molecular weight, in order to determine if interactions between unlike monomers are significant. The hydrodynamic radius (R_h) and diffusion second virial coefficient (k_d) for the random copolymer are found to be larger than the corresponding values for the homopolymers in a solvent which is near-theta for the two homopolymers, whereas no such effect is observed for the block copolymer. This suggests that most intrachain interactions occur a relatively short distance along the chain backbone. In a mutual good solvent R_h and k_d of the random copolymer are comparable to the average of the values for the homopolymers, indicating that in a good solvent monomer/solvent interactions dominate over monomer/monomer interactions. For an isolated diblock copolymer in a mutual good solvent, there is no evidence that interactions between unlike monomers lead to additional expansion of the entire molecule, as measured by R_h, nor expansion of the individual blocks as probed by light scattering with one block optically masked. However, at low but finite concentration there is evidence (the coefficients of the binary interaction terms in the viscosity and the mutual diffusion coefficient, and the second and third virial coefficients) that a weak ordering effect may exist in block copolymer solutions, far from the conditions where microphase separation occurs. Finally, measurements of ternary polymer-polymer-solvent solutions show no dependence on monomer composition or monomer distribution for the tracer diffusion of probe PS-PMMA copolymers in a PMMA/toluene matrix. This indicate that the frictional interaction is largely unaffected by interactions between unlike monomers. However, there is evidence that the thermodynamic interaction is more unfavorable between a random copolymer and the homopolymer matrix than between a diblock and the matrix. © 1994 John Wiley & Sons, Inc.     

Bundles, Handcuffs, and Local Freedom

We answer a question of J. Anderson's by producing infinitely many commensurability classes of fibered hyperbolic 3-manifolds whose fundamental groups contain subgroups that are locally free and not free. These manifolds are obtained by performing 0–surgery on a collection of knots with the same properties.     

Formation, isolation and characterization of an AB-biaryl atropisomer of oritavancin

Oritavancin is a semi-synthetic glycopeptide antibiotic which is structurally related to vancomycin. When oritavancin bisphosphate is dried in vacuo with heat, a new compound forms. This new compound is stable only in the solid state and reverts to oritavancin in solution. Highly enriched samples of this compound were obtained by preparative HPLC and the structure of this compound was elucidated by using one and two-dimensional (¹H and ¹³C) NMR spectroscopy in conjunction with computer-assisted molecular modeling. It has been determined that oritavancin adopts a conformation similar to that of vancomycin in solution, while the new compound is the unnatural R-AB-biaryl atropisomer of oritavancin. This is the first observation and isolation of an AB-biaryl atropisomer in an intact member of the vancomycin family of glycopeptide antibiotics.     

Quantitative measurements of Ge surface segregation during SiGe alloy growth

Ge segregation during the growth of Si_{1 − x}Ge_x alloys (x = 5, 10, 20, and 40%) was studied using X-ray photoelectron spectroscopy. The alloys were grown in thicknesses up to 20.0 nm at 500°C to measure quantitatively the amount of segregated surface Ge. The length of alloy needed to reach steady-state growth edge was found to decrease with increasing alloy concentration (4.8, 2.8, 2.4, and 2.0 nm, respectively). It was found that each alloy had a complete monolayer of Ge on the surface and an increasing amount of segregated Ge in the second layer (20, 55, 80, and 95%, respectively) during steady-state growth. An increase in the temperature of alloy growth (400–750°C) resulted in an increase in the leading edge of alloy growth but did not change the amount of segregated Ge during steady-state growth. We propose that film stress is responsible for the amount of Ge segregation.     

Determination of calcium in water by flow injection analysis — inductively coupled plasma (FIA-ICP) emission spectrometry

Summary Using an 11 ml centrifugal type spray chamber, a rapid sample introduction rate of 320 injections per hour may be achieved when interfacing flow injection analysis and inductively coupled plasma emission spectrometric techniques. Calcium was determined in water samples with a relative standard deviation of better than 3.5% over the analytical range of 10 to 200 mg · l^–1 Ca. Mean recovery was 97%.

---

Calciumbestimmung im Wasser mit dem Flow-injection-Prinzip kombiniert mit der Induktions-gekoppelten Plasma-Emissions-Spektrometrie (FIA-ICP)

     

Effects of processing on the structure of zein/oleic Acid films investigated by x-ray diffraction

Zein films plasticized with oleic acid were formed by solution casting, by the stretching of moldable resins, and by blown film extrusion. The effects of the forming process on film structure were investigated by X-ray diffraction. Wide-angle X-ray scattering (WAXS) patterns showed d-spacings at 4.5 and 10 A, which were attributed to the zein alpha-helix backbone and inter-helix packing, respectively. The 4.5 A d-spacing remained stable under processing while the 10 A d-spacing varied with processing treatment. Small-angle X-ray scattering (SAXS) detected a long-range periodicity for the formed films but not for unprocessed zein, which suggests that the forming process-promoted film structure development is possibly aided by oleic acid. The SAXS d-spacing varied among the samples (130-238 A) according to zein origin and film-forming method. X-ray scattering data suggest that the zein molecular structure resists processing but the zein supramolecular arrangements in the formed films are dependent on processing methods. Structural model for a zein molecular aggregate (based on Matsushima et al.10). Rectangular prisms of individual zein molecules are hexagonally aligned parallel to each other.     

Synthetic erythropoietic proteins: tuning biological performance by site-specific polymer attachment

Chemical synthesis in combination with precision polymer modification allows the systematic exploration of the effect of protein properties, such as charge and hydrodynamic radius, on potency using defined, homogeneous conjugates. A series of polymer-modified synthetic erythropoiesis proteins were constructed that had a polypeptide chain similar to the amino acid sequence of human erythropoietin but differed significantly in the number and type of attached polymers. The analogs differed in charge from +5 to -26 at neutral pH and varied in molecular weight from 30 to 54 kDa. All were active in an in vitro cell proliferation assay. However, in vivo potency was found to be strongly dependent on overall charge and size. The trends observed in this study may serve as starting points for the construction of more potent synthetic EPO analogs in the future.