A New Approach to Develop a Standardized Method for Simultaneous Analysis of Astragaloside IV and Formononetin in Radix Astragali by High-Performance Thin-Layer Chromatography

JPC – Journal of Planar Chromatography – Modern TLC - A new high-performance thin-layer chromatographic (HPTLC) method has been developed for the simultaneous estimation of...     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

置换模,ρ置换模与Conlon比析

本文对特征P的基域F引入适当的Galois群T,讨论p置换模的Green环的Conlon比析在Galois群T作用下的动态,证明了在T作用下p置换模的Green环的不动点集重合于置换模的Green环。     

A Novel Biomass Supported Na2CO3 System for Flue Gas Desulfurization

The breakthrough and stoichiometric SO2 adsorption efficiencies of a biomass supported Na2CO3 system (80 wt %Na2CO3/straw) have reached 48.9% and 80.6% respectively at a desulfurization temperature of 80℃.     

激光产生的铝、硅、氧、铜、硒等离子体X光谱

利用长晶格的OHM晶体谱仪,从激光等离子体中获得丰富的铜、硒类氖、类氟、类钠离子的二、三、四级软X射线衍射光谱和铝、氧、硅的类氢、类氦、类锂离子一到四级谱,波长在14～40(?)之间,在此基础上,本文较为细仔地分析了各光谱结构.     

抗生素调节的单种群chemostat模型研究

构建并分构了抗生素调节的单种群chemosta模型 ,得到了依赖于抗生素输入浓度的微生物种群绝灭和一致持续生存的充分条件 .     

“神龙一号”注入器研制

“神龙一号”注入器是直线感应加速器的束流源，它采用了感应叠加的高压加载方式，包括脉冲功率系统、感应腔、阴阳极杆、绝缘支撑、二极管和束流传输系统等子系统. 在研制中采用了径向绝缘支撑、对中支撑调节系统、类Pierce阴极等先进技术，以及二极管线圈内置和外径为800mm的铁氧体大环等创新. 参数测试显示，3.5MeV注入器达到了世界先进水平.     

Interpretation and quality of the tilted axis cranking approximation

Comparing with the exact solutions of the model system of one and two particles coupled to an axial rotor, the quality of the semi classical tilted axis cranking approximation is investigated. Extensive comparisons of the energies and M1 and E2 transition probabilities are carried out for the lowest bands. Very good agreement is found, except near band crossings. Various recipes to take into account finite K within the frame of the usual principal axis cranking are included into the comparison. A set of rules is suggested that permits to construct the excited bands from the cranking configurations, avoiding spurious states.     

MATLAB/SIMULINK在电力系统仿真中的应用

介绍了Matlab／Simulink仿真工具在电力系统仿真中的应用方法．