全文获取类型
收费全文 | 47篇 |
免费 | 12篇 |
国内免费 | 11篇 |
专业分类
化学 | 27篇 |
晶体学 | 1篇 |
力学 | 6篇 |
数学 | 4篇 |
物理学 | 32篇 |
出版年
2022年 | 1篇 |
2021年 | 1篇 |
2018年 | 2篇 |
2017年 | 3篇 |
2016年 | 1篇 |
2015年 | 4篇 |
2014年 | 6篇 |
2013年 | 7篇 |
2012年 | 1篇 |
2011年 | 7篇 |
2010年 | 6篇 |
2009年 | 6篇 |
2008年 | 7篇 |
2007年 | 2篇 |
2006年 | 1篇 |
2005年 | 1篇 |
2003年 | 1篇 |
2000年 | 2篇 |
1996年 | 2篇 |
1995年 | 1篇 |
1992年 | 1篇 |
1991年 | 1篇 |
1936年 | 2篇 |
1933年 | 1篇 |
1918年 | 1篇 |
1917年 | 2篇 |
排序方式: 共有70条查询结果,搜索用时 15 毫秒
1.
2.
膜的动电特性研究中,往往采用流动电位方法。该方法中,Ag-Ag Cl测试电极的质量是影响测试准确性的关键要素。本文采用正交试验设计和方差分析,着重考察电解法制备Ag-Ag Cl电极过程中,电流强度(I)、氯化时间(t)、电解质溶液浓度(CHCl)、电极来源(n)、烘烤温度(T)、活化电极溶液浓度(CKCl)等因素对Ag-Ag Cl电极稳定性的影响。得到Ag-Ag Cl电极的最优制备参数为:电流密度3.0m A/cm2,氯化时间50min,盐酸浓度0.1mol·L-1,烘烤温度120℃,活化电极溶液(KCl)浓度0.001mol·L-1;最显著影响因素为电极来源,显著影响因素为氯化时间和烘烤温度。对最优条件组合下制备的AgAg Cl电极,进行了稳定性实验,结果表明:制备的电极具有较好的稳定性,24h内电极电位漂移量小于0.10mv,7天内电极电位漂移量小于0.2mv;在聚偏氟乙烯中空纤维超滤膜流动电位测试中,流动电位与流动压差具有良好的线性和可重复性,回归曲线R20.99,变化规律符合Helmholtz-Smoluehowski公式,可以较好满足膜的流动电位测试要求。 相似文献
3.
采用共沉淀法成功地合成了不同Mg掺杂量的Ce1-xMgxO2(x=0.05、0.10、0.15、0.20)固溶体催化材料,并运用透射电子显微镜(TEM)、X射线衍射(XRD)、氮气吸附-脱附测试、拉曼光谱、X射线光电子能谱(XPS)、CO2程序升温脱附(CO2-TPD)等技术对这些材料进行了表征。结果发现,通过调控CeO2晶格中Mg的含量,可以调控所制备的Ce1-xMgxO2催化材料的粒径、比表面积、表面缺陷等。其中Ce0.90Mg0.10O2展现了最佳的表面性质,具有最小的平均粒径(约5.8 nm),最大的比表面积(约136 m2·g-1)以及最高的表面氧含量(31.98%)。将Ce1-xMgxO2催化材料涂覆在堇青石蜂窝陶瓷上制成整体催化剂,考察其对CO2和CH3OH直接合成碳酸二甲酯的催化性能。在140℃、2.4 MPa、反应2 h的条件下,Ce0.90Mg0.10O2整体催化剂上碳酸二甲酯的收率高达20.21%,催化效果明显优于CeO2和其余的Ce1-xMgxO2(x=0.05、0.15、0.20)催化材料。 相似文献
4.
5.
6.
以4-氯-7-硝基苯并-2-氧杂-1,3-二唑、乙二胺和溴乙酸乙酯等为原料,合成4-氨基-7-硝基苯并-2-氧杂-1,3-二唑类衍生物(NBD-OEt),通过IR、NMR和MS对其进行结构表征。研究NBD-OEt的吸收光谱和荧光光谱性质,探讨其在H2O/EtOH(60/40, V/V) pH 7.40的HEPES缓冲体系中对Hg2 的响应,以及NBD-OEt与Hg2 的结合模式。结果表明, 随Hg2 的不断加入可诱使NBD-OEt在476nm的吸收峰红移至514nm,并有两个等吸收点(347nm、482nm);其荧光发射峰由536nm红移至559nm,且在525nm出现等发射点;通过Job plot法测定NBD-OEt与Hg2 以1:1的计量比结合。 相似文献
7.
The ultrasonic signals in long bones contain multiple guided modes which are mutual superposed.The velocities of guided waves in long bones are very sensitive to cortical thickness (CTh).In this paper,Hilbert-Huang transform(HHT) was proposed to analyze multi-mode guided waves,which can decompose superposed waves into many independent modes.Then the group velocity of each mode was obtained at corresponding frequency,which was compared with the results of short time Fourier transform(STFT).The CTh was also obtained by comparing with the theoretical calculation.The results showed that the experimental determined thickness was in agreement with the actual CTh,indicating that measuring the velocity of the guided mode can be used to estimate the CTh.The HHT is an effective method to identify multimode guided waves. 相似文献
8.
9.
S. B. Kuzirian Thompson Morgan Mc Crudden und Shedd 《Fresenius' Journal of Analytical Chemistry》1917,56(12):600-602
Ohne Zusammenfassung 相似文献
10.
A two-component (air-water) annular flow model is presented requiring only flow rates, absolute pressure, temperature, and tube diameter. Film thicknesses (base film and wave height) are calculated from a critical film thickness model. Modeled pressure gradient is weighted by wave intermittency to compute average pressure gradient. Film flow rate and wave velocity are estimated using the universal velocity profile in the waves and a piecewise linear profile in the base film. For vertical flow, mean absolute errors for film thickness, wave velocity, and pressure gradient are 9%, 9%, and 19%, respectively. In horizontal flow, mean absolute errors for pressure gradient, base film thickness, and disturbance wave velocity are 17%, 10%, and 14%, respectively, on par with those from single-behavior models that require additional film thickness or other data as inputs. 相似文献