New membrane materials for potassium-selective ion-sensitive field-effect transistors

Several polymeric materials were studied as membrane materials for potassium-selective ion-sensitive field-effect transistors (ISFETs) to overcome the problems related with the use of conventional plasticized poly(vinyl chloride) membranes casted on ISFET gate surfaces. Several acrylate materials, such as ACE, Epocryl and derivatives, showed no reproducible results. Three room-temperature vulcanizing (RTV)-type silicone rubbers were tested. The addition-type RTV-2 silicone rubber was not suitable as a membrane material, but the condensation-type RTV-1 and especially the RTV-2 silicone rubber showed good results. ISFETs with a Silopren membrane showed a durability of at least 2 months.     

pH sensitivity of Si--C linked organic monolayers on crystalline silicon surfaces.

The electrochemical behavior of Si--C linked organic monolayers is studied in electrolyte-insulator-Si devices, under conditions normally encountered in potentiometric biosensors, to gain fundamental knowledge on the behavior of such Si electrodes under practical conditions. This is done via titration experiments, Mott-Schottky data analysis, and data fitting using a site-binding model. The results are compared with those of native SiO(2) layers and native SiO(2) layers modified with hexamethyldisilazane. All samples display pH sensitivity. The number of Si--OH groups on the alkylated samples is calculated to be less than 0.7 % of that of a pure SiO(2) insulator, which still causes a pH sensitivity of approximately 25 mV per pH unit in the pH range: 4-7. The alkylated samples hardly suffer from response changes during up- and down-going titrations, which indicates that very little oxide is additionally formed during the measurements. The pK(a) values of all samples with monolayers (4.0-4.4) are lower than that of native SiO(2) (6.0). The long-term drift (of approximately 1 mV h(-1)) is moderate. The results indicate that biosensors composed of alkylated Si substrates are feasible if a cross-sensitivity towards pH in the sensor signal is taken into account.     

Tailor-made functionalization of silicon nitride surfaces

This communication presents the first functionalization of a hydrogen-terminated silicon-rich silicon nitride (Si3Nx) surface with a well-defined, covalently attached organic monolayer. Properties of the resulting monolayers are monitored by measurement of the static water contact angle, X-ray photoelectron spectroscopy (XPS), and infrared reflection absorption spectroscopy (IRRAS). Further functionalization was performed by reaction of Si3Nx with a trifluoroethanol ester alkene (CH2=CH-(CH2)8CO2CH2CF3) followed by basic hydrolysis to afford the corresponding carboxylic acid-terminated monolayer with hydrophilic properties. These results show that Si3Nx can be functionalized with a tailor-made organic monolayer, has highly tunable wetting properties, and displays significant potential for further functionalization.     

n-Hexane dehydrocyclization over Pt?Ni supported on alumina catalysts

Pt–Ni/-Al₂O₃ catalysts have been prepared and studied in n-hexane dehydrocyclization. The selectivity for benzene and toluene, a chain lengthening product formation was improved by Ni and correlated with its content.

---

Pt–Ni/-Al₂O₃ -. Ni . Ni , .

     

Role of tin in a PtSb alloy and a Pt-Sn/Al2O3 reforming catalyst

The conversion of n-hexane was studied on a Pt-Sn/Al₂O₃ catalyst, a PtSn alloy and on the corresponding Pt catalysts. The results indicate the same catalytic effect of tin in supported and unsupported catalysts. It is concluded that the role of tin is connected with alloy formation.

---

- Pt-Sn/Al₂O₃, PtSn Pt-. . , .

     

Oberflächenzusammensetzung und katalytische Aktivität von Nickel–Kupfer-Legierungen

The decomposition of formic- acid vapour has been studied on annealed nickel-copper alloy films. The activity pattern of short-time annealed alloys reveals two maxima and in the range of 50% Ni a minimum. The maxima disappear, when the films are annealed for a longer time. One gets nearly the same variations of the curves of short-and long-time annealed films, when plotting the initial change of electric resistance of the films during reaction against the composition. It is concluded that depending on annealing conditions the surface of the alloys is more or less covered by a copper-rich alloy phase. This is supported by X-ray analysis, confirming the formation of two alloy phases.     

Oberflächenchemie,Sintern und Redispergieren von Pd/Al2O3-Katalysatoren

Surface Chemistry, Sintering, and Redispersion of Pd/Al₂O₃ Catalysts Surface chemistry of Pd/Al₂O₃ has been investigated by temperature-programmed reduction, O₂ chemisorption, and u.v.-vis spectroscopy. Depending on conditions of different thermal pretreatments especially in O₂, different chlorine-free and chlorine-containing Pd compounds exist on the alumina. Sintering and redispersion of Pd are governed by properties of chlorine-free Pd oxide. The mechanism of Pd sintering consists in the thermal decomposition of a two-dimensional PdO phase; redispersion consists in formation of this phase by spreading of bulk PdO. There is no direct connection between Pd oxidation and redispersion. The discussion compares properties of Pd/Al₂O₃ and Pt/Al₂O₃.     

Hole Migration in Telomere-Based Oligonucleotide Anions and G-Quadruplexes

Vacuum ultraviolet photoionization of a gas-phase oligonucleotide anion leads to the formation of a valence hole. This hole migrates towards an energetically favorable site where it can weaken bonds and ultimately lead to bond cleavage. We have studied Vacuum UV photoionization of deprotonated oligonucleotides containing the human telomere sequence dTTAGGG and G-quadruplex structures consisting of four dTGGGGT single strands, stabilized by NH₄⁺ counter ions. The oligonucleotide and G-quadruplex anions were confined in a radiofrequency ion trap, interfaced with a synchrotron beamline and the photofragmentation was studied using time-of-flight mass spectrometry. Oligonucleotide 12-mers containing the 5'-TTAGGG sequence were found to predominantly break in the GGG region, whereas no selective bond cleavage region was observed for the reversed 5'-GGGATT sequence. For G-quadruplex structures, fragmentation was quenched and mostly non-dissociative single and double electron removal was observed.     

Non‐symmetric bent‐core mesogens with one terminal vinyl group

Two series of non‐symmetric banana‐shaped compounds, both with one alkyl and one alkenyl terminal tail, have been synthesized and studied. Both series were compared with the corresponding series with two saturated terminal alkyl tails. All the compounds have a bent central 1,3‐phenylene bis(4‐benzoyloxy)benzoate core; their mesophases were characterized by polarizing optical microscopy, differential scanning calorimetry, X‐ray diffraction and switching current response experiments. In all four series one of the terminal tails is varied from OC₈H₁₇ to OC₁₆H₃₃. The other terminal tails are OC₁₁H₂₃, O(CH₂)₉CH?=?CH₂, OC₁₀H₂₁ and O(CH₂)₈CH?=?CH₂. The short‐tailed compounds show monotropic or enantiotropic B₁ phases and the long‐tailed compounds the B₂ phase. The introduction of one terminal vinyl group slightly lowers the transition temperatures. The introduction of a second terminal vinyl group further suppresses the liquid crystalline properties. All compounds with B₂ phases have layer spacings that suggest a tilt of ～45° of the bent molecules in the layers, and their switching behaviour is antiferroelectric.