沸石催化剂上醇的醚化反应

研究了乙醇，正丁醇，仲丁醇和正戊醇有ＺＳＭ－５和Ｂｅｔａ沸石上的醚化反应。用ＮＨ３－ＴＰＤ和ＩＲ测定了ＺＳＭ－５沸石的表面酸性，讨论了沸石表面Ｂ酸和Ｌ酸和与醚化活性的关系。结果表明，乙醇的脱水反应既可以在Ｂ酸中心上进行，也可以在Ｌ酸中心中心上进行，既可以在强酸中心上进行，亦可以在弱酸中心上进行。     

CrMCM-41分子筛的合成与表征

直接合成了含铬 MCM- 4 1中孔 (mesoporous)分子筛 ;通过 XRD、骨架 IR、ESR、紫外漫反射(DRS)、2 9Si MASNMR等测试 ,表明铬处在分子筛骨架上 ,同时也存在非骨架铬。骨架红外光谱中除发现铬分子筛的特征峰 690 cm-1 外 ,还发现被归属于 O3 Si- O- T振动的吸收峰 960 cm-1 ;ESR中观察到 g=2 .4处有信号 ,可能与骨架铬直接有关 ;固体魔角核磁 2 9Si谱也进一步证实骨架铬的存在。同时对 Cr MCM- 4 1分子筛的热稳定性、吸附量和酸性进行了考察。     

Pd/SAPO-34催化剂上CO低温氧化反应

 采用水热法合成了小晶粒的 SAPO-34, MnSAPO-34 和 CuSAPO-34 分子筛, 并以它们为载体采用浸渍法制备了一系列不同 Pd 含量的催化剂用于催化 CO 氧化反应. 结果表明: 分子筛载体、催化剂制备条件、反应条件、Pd 含量及预还原等对催化剂的活性影响较大. 催化剂活性随焙烧温度的增加而降低, 而随着反应温度的升高而提高, 担载在 SAPO-34 上 Pd 含量为 1.35% 时性能最佳. X射线衍射和透射电镜结果表明 Pd 物种高度分散于催化剂上, 粒子粒径在 2~8 nm; X射线光电子能谱及氢气程序升温还原结果表明, 高度分散的 Pd2+ 物种是 CO 氧化反应活性位. 随着反应进行被还原为 Pd0 物种, 因而导致催化剂活性下降. H2 预还原处理催化剂致使活性下降的实验结果也支持了这一结论.     

软模板合成有序介孔碳材料

有序介孔碳材料由于其较大的表面积、均一的孔径、良好的热稳定性和化学稳定性,广泛应用于吸附、分离、催化以及能量储存等众多领域。与传统的以硅基介孔材料为硬模板的反向复制方法相比,通过嵌段共聚物和聚合物前驱体之间的有机-有机自组装的软模板法简便易行,已成为合成有序介孔碳材料有效方法。本论文综述了介孔碳材料的软模板合成机制、合成方法、功能化及其应用,对合成技术、结构控制、孔径调控以及形貌控制等方面进行了讨论,并探讨了其在吸附、催化、电极材料等领域的应用。     

A cubically convergent Newton-type method under weak conditions

Under weak conditions, we present an iteration formula to improve Newton's method for solving nonlinear equations. The method is free from second derivatives, permitting f^′(x)=0 in some points and per iteration it requires two evaluations of the given function and one evaluation of its derivative. Analysis of convergence demonstrates that the new method is cubically convergent. Some numerical examples illustrate that the algorithm is more efficient and performs better than classical Newton's method.     

Wigner Transforms and Fractional Fourier Transforms of the First Order Optical Systems

１ＩｎｔｒｏｄｕｃｔｉｏｎＤｕｒｉｎｇｒｅｃｅｎｔｙｅａｒｓｆｒａｃｔｉｏｎａｌＦｏｕｒｉｅｒｔｒａｎｓｆｏｒｍ（ＦＲＴ）ｈａｓｂｅｎａｔｒａｃｔｅｄｍｕｃｈａｔｅｎｔｉｏｎｉｎａｗｉｄｅｆｉｅｌｄｏｆａｐｐｌｉｃａｔｉｏｎｓ．ＴｈｅｆｉｒｓｔＦＲＴ...     

Phase behaviors of cyclic diblock copolymers

A spectral method of self-consistent field theory has been applied to AB cyclic block copolymers. Phase behaviors of cyclic diblock copolymers, such as order-disorder transition, order-order transition, and domain spacing size, have been studied, showing good consistency with previous experimental and theoretical results. Compared to linear diblocks, cyclic diblocks are harder to phase separate due to the topological constraint of the ring structure. A direct disorder-to-cylinder transition window is observed in the phase diagram, which is significantly different from the mean field phase diagram of linear diblock copolymers. The domain spacing size ratio between cyclic and linear diblock copolymers is typically close to 0.707, indicating in segregation that the cyclic polymer can be considered to be made up of linear diblocks with half of the original chain length.     

无外加氟施主产生KrF准分子发射谱实验研究

We report a new technique to suppress the low-spatial-frequency rings and ripples (LSFRs) of laser near-field intensity distribution in the spatial filter (SF) used in ICF laser drivers. This technique employs a spatial filter with Gaussian transmission, instead of the hard-edged pinhole, at the confocal plane of a Newtonian telescope. The resulting beam has a super-Gaussian transverse intensity profile without the LSFRs that certainly appear when a hard-pinhole was used as a filter in the conventional technique.     

用楔角偏差改善光楔列阵系统焦线的大尺度不均匀性

在加工光楔列阵线聚焦系统时，人为地使各单元楔角与精确的理论值之间存在一定的偏差，以使单元衍射引起的大尺度不均匀性得到改善，文中进行了理论计算和实验验证，在既能改善均匀性，又能保证一定的焦线能量利用率的情况下，给出了合理的偏差数据，为优化均匀聚焦系统的工程设计提供了必要的依据。     

Synthesis and characterization of mesoporous ceria with hierarchical nanoarchitecture controlled by amino acids

In this work, we report the synthesis and characterization of mesoporous ceria with hierarchical nanoarchitectures controlled by amino acids. During the synthesis procedure, cerium oxalate precipitate was treated hydrothermally with different amino acids as crystallization modifiers, and hierarchically structured cerium oxalate precursors were obtained. Ceria can be produced after thermal decomposition of the cerium oxalate precursors. Structure and properties of the product were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), Raman spectroscopy, N2 adsorption analysis, and X-ray photoelectron spectroscopy (XPS) methods. The results indicate that the mesoporous ceria with hierarchical nanoarchitectures are composed of nanosized ceria crystallites as building units and possess high surface area and high concentration of oxygen vacancy. Depending on different amino acids as the crystallization modifiers, the ceria exhibit different morphologies, such as dendritic aggregation of rods, dumbbells of nanorod arrays, or aggregated spheres. It is proposed that both the type of functional side groups and the length of the side groups of the amino acids influence the morphologies of the ceria. Meanwhile, the solvent and hydrothermal treatment temperatures also play important roles in the morphological control. The method reported in this work would be regarded as a general way to fabricate mesoporous metal oxides with hierarchical nanoarchitectures.