某轴流压气机叶尖间隙效应实验研究

本文对某低速轴流压气机叶尖间隙尺度对性能的影响进行了实验研究,并通过不同的机匣结构情况研究一种叶尖漏流不敏感机匣。实验表明,不同的间隙尺度对叶轮机总体性能存在十分明显的影响。对绝大部分运行状态,小间隙下的压升和效率均明显高于大间隙的情况。另外,所采用的毛刷式和篦齿式的机匣实验结果表明,不论毛刷式还是篦齿式机匣,在大流量负攻角情况下对性能的影响不大,但毛刷式机匣并不能达到提高失速裕度的目的,而篦齿式机匣在小流量情况下对压升有所提高,但对效率影响不大。     

一维链状冠醚配合物:[{Na(18-C-6)}2(H2O)]n[M(SCN)4]n(M=Pd、Pt)的合成与结构

The reactions of 18-crown-6 with Na₂[M(SCN)₄] (M= Pd,Pt) were studied and the complex 1 [{Na(18-C-6)}₂(H₂O)]_n[Pd(SCN)₄]_n and complex 2 [{Na(18-C-6)}₂(H₂O)]_n[Pt(SCN)₄]_n were characterized by ele-mental analysis, IR and X-ray diffraction analysis. The complexes belong to monoclinic, space group P2₁/n with cell dimensions, 1:a=1.05734(7),b=1.42250(10),c=1.47762(10) nm,β=107.5330(10)°,V=2.1192(2)nm³,Z=2,D_calcd=1.460g·cm^-3,F(000)=964,R₁=0.0406,wR₂=0.1264 and 2:a=1.05985(19),b=1.4237(3),c=1.4744(3) nm,β=107. 096(3)°, V=2.1264(7)nm³,Z=2,D_calcd=1.690g·cm^-3,F(000)=1028,R₁=0.0292,wR₂=0.0859. In the solid state, the complexes 1 and 2 show an one-dimensional chain of [{Na(18-C-6)}₂(H₂O)]²⁺ complex cations and [M(SCN)₄]^2- (M=Pd,Pt) complex anions bridged by Na-N in-teractions.     

Bi-Sb-Te基热电薄膜温差电池离子束溅射制备与表征

本文采用离子束溅射Bi/Te和Sb/Te二元复合靶,直接制备n型Bi₂Te₃热电薄膜和p型Sb₂Te₃热电薄膜.在退火时间同为1 h的条件下,对所制备的Bi₂Te₃薄膜和Sb₂Te₃薄膜进行不同温度的退火处理,并对其热电性能进行表征.结果表明,在退火温度为150 ℃时,制备的n型Bi₂Te₃关键词： 薄膜温差电池 2Te₃薄膜')" href="#">Sb₂Te₃薄膜 2Te₃薄膜')" href="#">Bi₂Te₃薄膜 离子束溅射     

随机噪声对经验模态分解非线性信号的影响

采用Monte-Carlo随机模拟方法来研究外部噪声对经验模态分解非线性信号的影响.结果表明:噪声对低阶特征模态函数(IMF)影响较为明显,对高阶IMF影响较小;白噪声强度系数越大,分解出的IMF纯噪声分量阶数越多;用含噪声信号减去经验模态分解后的主要IMF噪声分量,可较为明显地削弱噪声的影响;含噪声响应的最大Lyapunov指数比不含噪声响应的最大Lyapunov指数小     

Growth and Characterization of CIS Thin Films Prepared by Ion Beam Sputtering Deposition

Copper indium diselenide （CuInSe2） thin films were prepared by ion beam sputtering Cu, In and Se targets continuously on BK7 glass substrates and the three-layer film was then annealed in the same vacuum chamber. X-ray diffraction shows that the CuInSe2 thin films have a single chalcopyrite structure with preferential （112） orientation. Scanning electron microscopy reveals that the CIS thin films consist of uniform and densely packed grain clusters. Energy dispersive x-ray spectroscopy demonstrates that the elemental composition of CIS films approaches the stochiometric composition ratios of 1：1：2. Raman measurement shows that the main peak is at about 174cm^-1 and this peak is identified as the A1 vibrational mode from chaicopyrite ordered CulnSe2. Optical transmission and absorption spectroscopy measurement reveal an energy band gap of about 1.05 eV and an absorption coefficient of 10^5 cm^-1. The film resistivity is about 0.01 Ωcm.     

Composition-Dependent Characterization of Sb2Te3 Thin Films Prepared by Ion Beam Sputtering Deposition

The optimization of ion beam sputtering deposition process for Sb2 Te3 thin films deposited on BK7 glass substrates is reported. The influence of composition ratio on the thermoelectric properties is investigated. X-ray diffraction shows that the major diffraction peaks of the films match with those of Sb2 Te3. Hall effect and Seebeck coefficient measurement reveal that all the samples are of p-type. The Sb2 Te3 thin films exhibit the Seebeck coefficient of 190μVk^-1 and the electrical conductivity of 1.1 × 10^3 Scm^-1 when the atomic ratio of Sb to Te is 0.65. Carrier concentration and motility of the films increase with the increasing atomic ratio of Sb to Te. The Sb2 Tea film with a maximum power factor of 2.26×10^-3 Win^-1K^-2 is achieved when annealed at 400℃. Raman measurement shows that the main peaks are at about 120 cm^-1, 252 cm^-1 and 450 cm^-1, in agreement with those of V-VI compound semiconductors.     

Th(IV) adsorption on alumina: effects of contact time, pH, ionic strength and phosphate

Adsorption of Th(IV) (total concentration, 10(-5)-10(-4) mol/L) was studied by a batch technique. The effects of pH, ionic strength, contact time, and phosphate on the adsorption of Th(IV) onto alumina were investigated. Adsorption isotherms of Th(IV) on alumina at approximately constant pH and three ionic strengths (0.05, 0.1, 0.5 mol/L KNO3) were determined. It was found that the pH values of aqueous solutions of both the Th(IV)-alumina and phosphate-alumina adsorption systems increase with increasing contact time, respectively. Adsorption of Th(IV) on alumina steeply increases with increasing pH from 1 to 4.5 and the adsorption edge consists of three regions. The phosphate added clearly enhances Th(IV) adsorption in the pH range 1-4. From the adsorption isotherms at approximately constant pH and three different ionic strengths, a reduced ionic strength effect was observed and is contradictory to the insensitive effect obtained from the adsorption edges on three oxides of Fe, Al, and Si at different ionic strengths. Compared with the adsorption edges at different ionic strengths, the adsorption isotherms at approximately constant pH and different ionic strengths are more advantageous in the investigation of ionic strength effect. The significantly positive effect of phosphate on Th(IV) adsorption onto alumina was attributed to strong surface binding of phosphate on alumina and the subsequent formation of ternary surface complexes involving Th(IV) and phosphate.     

Pb,Cu和Zn在自然水体生物膜中铁/ 锰氧化物等组分上的富集规律

用选择性萃取法萃取天然基质采集的生物膜中的铁/锰氧化物, 考察生物膜上铁/锰氧化物对水体中Pb, Cu及Zn的富集作用. 结果表明, 锰氧化物对生物膜富集Pb起主要作用, 而铁氧化物和除铁/锰氧化物以外的以有机质为主的其它组分的作用很小; 膜上其它组分对Cu的富集贡献较大, 锰氧化物的贡献与铁氧化物的接近; 锰氧化物对Zn的富集贡献最大, 铁氧化物和其它组分的贡献比较接近. 锰氧化物对Pb, Cu及Zn的富集能力分别高于铁氧化物的富集能力, 铁氧化物和锰氧化物对3种金属富集能力的大小顺序分别是Zn>Cu>Pb和Zn>Pb≥Cu.     

微波辅助萃取法提取菟丝子总黄酮的最佳工艺

设计单因素和正交试验,采用微波快速反应系统对菟丝子进行提取,以芦丁为对照品,采用紫外分光光度法测定菟丝子中总黄酮的含量,以总黄酮的含量为考察指标,考察微波功率、提取时间、提取温度、乙醇浓度及料液比对总黄酮提取量的影响,优选最佳提取工艺。结果表明,微波辅助萃取法提取菟丝子总黄酮的最佳工艺条件为：乙醇体积分数70%、提取温度80℃、提取时间30min、料液比1∶20（g/mL）。     

光谱法研究不同pH范围内三磷酸腺苷与Mg2+的相互作用

研究金属离子与ATP的相互作用方式,对于阐明金属离子与ATP参与的酶反应过程具有重要的意义.31P NMR光谱结果表明ATP分子的a-P在pH 2-8研究范围内都不参与键合作用,而β-P 和γ-P都参与键合作用.1H NMR光谱结果表明,当ATP与Mg2+发生相互作用时,其磷酸根阴离子与腺嘌呤碱基都会参与配位作用.紫外吸收光谱结果表明在碱性条件时,Mg2+会引起ATP分子发生碱基堆积,而在酸性条件时,碱基堆积则不会发生.