油水两液相一维非等温渗流的传递分析

在求解油水两液相非等温渗流的温度场、压力场基础上,以驱动功、驱动功率、驱动阻力、驱动速率为特征参数,对该过程进行(火用)传递分析。数值模拟的结果表明:含水通过降低油的相对渗透率、从而增大驱动阻力、减小驱动功率, 最终导致原油产量降低。     

As+注入硅的紫外-可见椭圆偏振光谱

本文采用椭圆偏振光谱法研究了剂量为1×10¹⁶—3×10¹²cm^-2的As⁺注入硅,及其在700℃退火后的光学性质。得出:当As⁺注入剂量增大到某一程度后,便呈非晶特性。低于临界剂量的样品,其n-λ,ε₂-λ关系曲线随剂量的增大而往下方移动,呈有规律变化;退火后,在大于4000?波段,n-λ与ε₂-λ曲线基本恢复到单晶硅状态。但在小于4000?的紫外区却未完全恢复,注入剂量越大,偏离单晶硅就越大。并指出,紫外光区是离子注入硅的信息敏感区;用有效质量模型计算出注入剂量与损伤度的关系。计算结果与实验符合得较好。 关键词：     

光纤的能量传输特性及应用

着重分析了影响光纤传输能量以及光纤传输中造成能量损耗的因素。这些因素主要包括光纤材料、构造、光纤的折射率分布、光纤的长度和芯径、光纤的数值孔径和热效应以及耦合等。同时 ,结合激光二极管点火的实例 ,分析探讨了其背景和应用价值。结论是 :为了尽可能减少能量损耗、提高光纤输出的激光功率和激光功率密度 ,应当选取合适的激光工作波长、较小的光纤长度、较小的芯径和较小的数值孔径 ,应采用渐变折射率分布光纤 ,应减少弯曲与耦合     

Theoretical Studies on the Si（001）-SiO2 Interface Structure

1 INTRODUCTION Silicon and its alloy have been widely applied in such fields as electronic industry, high-temperature structural ceramics, etc. In addition, the researches on silicon and its relevant materials greatly promote the rapid development of modern optics and infor- mation technology. Therefore, more and more at- tention is focused on the structure of silicon, oxide of silicon and the interfaces between silicon and metal or nonmetal. As an ideal passive film on the Si surface, S…     

居民收入和消费预测的灰理论方法

阐述灰色模型GM(1,1)建立及检验的基本理论和方法.并依据2000年—2005年浙江农村居民人均纯收入和人均生活消费数据,利用GM(1,1)模型建模方法,对“十一五”期间浙江农民的纯收入和生活消费进行了预测.     

C-V法提取SiC隐埋沟道MOSFET沟道载流子浓度

本文对用C-V法提取SiC隐埋沟道MOSFET沟道载流子浓度的方法进行了理论和实验分析. pn结的存在所造成的埋沟MOS结构C-V曲线的畸变为沟道载流子浓度的提取带来一些问题. SiC/SiO₂界面上界面态的存在也会使提取出的数值与实际数值产生偏差. 本文首先从理论上分别分析了沟道深度和界面态对沟道载流子浓度提取结果的影响，然后对两种沟道深度的埋沟MOS结构C-V曲线进行了测试，提取出了沟道掺杂浓度. 在测试中，采用不同的扫描速率，分析了界面态对提取结果的影响. 理论分析结果和实验测 关键词： C-V法 SiC 隐埋沟道MOSFET 沟道载流子浓度     

On Tanaka formulae for (α,d,β)-superprocesses

In this paper,Tanaka formulae for (α,d,β)-superprocesses in the dimensions where the local time exists are established under the optimal initial condition.     

Effect of carbon content on the microstructure and the cracking susceptibility of Fe-based laser-clad layer

The laser cladding of Fe-based alloys on a medium carbon steel substrate was performed using a CO₂ laser and Ar shielding gas that was blown into a molten pool. The microstructure and cracking susceptibility of the laser-clad layers were studied in terms of carbon additions. Results show that the small change of the carbon content in the alloy powders can obviously change the microstructure and properties of the layers. When the carbon content is in the range of 0.3–0.4 wt.%, the decrease of the carbon content in alloy powders will increase the hardness and toughness of the layers simultaneously under the same process parameters. As a result, crack-free coatings with high hardness can be obtained. As the carbon content increases from 0.2 wt.% to 0.4 wt.%, the segregation ratio of chromium increases, while the segregation ratios of nickel, manganese, and silicon first decrease and then increase. At the same time, a new designing principle concerning the composition and microstructure has been put forward, and the principal mechanisms of strengthening and toughening of the layers are fine-grain strengthening and low carbon martensitic phase transformation strengthening.     

Study on Inhibitors of Methionine Synthase Ⅷ: Synthesis of 2,5-Diamino-4-oxo-6- (3-butenyl) pyrimidine

Cobalamin-dependent methionine synthase plays a crucial role in folate metabolism and such would appear to be an excellent target for rational antifolate drug design. However, to date, no anticancer agents directed at this enzyme are available, but the enzyme is efficiently and specifically inhibited by N2O and this has proven invaluable for evaluating the biochemical consequence of enzyme inhibition and for mechanistic studies. [1,2] 2,5-Diamino-4-oxo-6-(3-butenyl) pyrimidine, a key intermediate in synthetic inhibitors of methionine synthase, was first synthesized using γbutenyl-β-ketoester and guanidine carbonate (Scheme 1). [3]     

数量级在物理实验中的应用

介绍了数量级在物理实验设计、实验失败原因分析、误差分析及实验结果判断方面的应用．