The glow curve structure for the LiF:Mg,Cu,Na,Si TL detector with dopants concentrations and sintering temperatures

The glow curve structures for LiF:Mg,Cu,Na,Si TL detectors with various dopant concentrations and sintering temperatures were investigated for the improvement of the glow curve structure and sensitivity of the TL detector. The dopant concentrations were varied over the following ranges: Mg (0–0.25 mol%), Cu (0–0.07 mol%), Na and Si (0–1.5 mol%). With increasing Cu concentration, the intensity of the main peak was intensified and reached a maximum at a concentration of 0.05 mol%. The high-temperature peak was reduced. The dependency of the main peak intensity on the Mg concentration exhibits a sharp maximum at 0.2 mol%. The intensity of the high-temperature peak tends to rise slightly with increasing Mg concentration. It was found that the optimum concentrations of the dopants in the LiF:Mg,Cu,Na,Si TL material are Mg: 0.2 mol%, Cu: 0.05 mol%, Na and Si: 0.9 mol%. The dependency of the main peak intensity on sintering temperature exhibits a very sharp maximum at 830°C. The high-temperature peak was rapidly reduced after 825°C.     

Desorption behavior of a surfactant in a linear low‐density polyethylene blend at elevated temperatures

The desorption behavior of a surfactant in a linear low‐density polyethylene (LLDPE) blend at elevated temperatures of 50, 70, and 80 °C was studied with Fourier transform infrared spectroscopy. The composition of the LLDPE blend was 70:30 LLDPE/low‐density polyethylene. Three different specimens (II, III, and IV) were prepared with various compositions of a small molecular penetrant, sorbitan palmitate (SPAN‐40), and a migration controller, poly(ethylene acrylic acid) (EAA), in the LLDPE blend. The calculated diffusion coefficient (D) of SPAN‐40 in specimens II, III, and IV, between 50 and 80 °C, varied from 1.74 × 10^?11 to 6.79 × 10^?11 cm²/s, from 1.10 × 10^?11 to 5.75 × 10^?11 cm²/s, and from 0.58 × 10^?11 to 4.75 × 10^?11 cm²/s, respectively. In addition, the calculated activation energies (E_D) of specimens II, III, and IV, from the plotting of ln D versus 1/T between 50 and 80 °C, were 42.9, 52.7, and 65.6 kJ/mol, respectively. These values were different from those obtained between 25 and 50 °C and were believed to have been influenced by the interference of Tinuvin (a UV stabilizer) at elevated temperatures higher than 50 °C. Although the desorption rate of SPAN‐40 increased with the temperature and decreased with the EAA content, the observed spectral behavior did not depend on the temperature and time. For all specimens stored over 50 °C, the peak at 1739 cm^?1 decreased in a few days and subsequently increased with a peak shift toward 1730 cm^?1. This arose from the carbonyl stretching vibration of Tinuvin, possibly because of oxidation or degradation at elevated temperatures. In addition, the incorporation of EAA into the LLDPE blend suppressed the desorption rate of SPAN‐40 and retarded the appearance of the 1730 cm^?1 peak. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 1114–1126, 2004     

Moment vanishing properties of harmonic Bergman functions

We show that Poisson integrals belonging to certain weighted harmonic Bergman spaces b_δ^p on the upper half-space must have the moment vanishing properties. As an application, we show that b₀^p, p?1, contains a dense subspace whose members have the horizontal moment vanishing properties. Also, we derive related weighted norm inequalities for Poisson integrals. As a consequence, we obtain a characterization for Poisson integrals of continuous functions with compact support in order to belong to b_δ^p.     

Nonequilibrium synthesis and assembly of hybrid inorganic-protein nanostructures using an engineered DNA binding protein

We show that a protein with no intrinsic inorganic synthesis activity can be endowed with the ability to control the formation of inorganic nanostructures under thermodynamically unfavorable (nonequilibrium) conditions, reproducing a key feature of biological hard-tissue growth and assembly. The nonequilibrium synthesis of Cu(2)O nanoparticles is accomplished using an engineered derivative of the DNA-binding protein TraI in a room-temperature precursor electrolyte. The functional TraI derivative (TraIi1753::CN225) is engineered to possess a cysteine-constrained 12-residue Cu(2)O binding sequence, designated CN225, that is inserted into a permissive site in TraI. When TraIi1753::CN225 is included in the precursor electrolyte, stable Cu(2)O nanoparticles form, even though the concentrations of [Cu(+)] and [OH(-)] are at 5% of the solubility product (K(sp,Cu2O)). Negative control experiments verify that Cu(2)O formation is controlled by inclusion of the CN225 binding sequence. Transmission electron microscopy and electron diffraction reveal a core-shell structure for the nonequilibrium nanoparticles: a 2 nm Cu(2)O core is surrounded by an adsorbed protein shell. Quantitative protein adsorption studies show that the unexpected stability of Cu(2)O is imparted by the nanomolar surface binding affinity of TraIi1753::CN225 for Cu(2)O (K(d) = 1.2 x 10(-)(8) M), which provides favorable interfacial energetics (-45 kJ/mol) for the core-shell configuration. The protein shell retains the DNA-binding traits of TraI, as evidenced by the spontaneous organization of nanoparticles onto circular double-stranded DNA.     

Optimum conditions for preparing micron-sized PMMA beads in the dispersion polymerization using PVA

The optimum conditions for preparing micron-sized monodisperse polymethylmethacrylate (PMMA) beads by dispersion polymerization in a methanol/water mixture were proposed. PMMA forming microspheres having an average molecular weight of 55,300 g/mol, 2.6 μm weight-average diameter, with a 5.3% coefficient of variation and 91% conversion, were successfully obtained in the presence of 15 wt.% of polyvinylalcohol (PVA), 100/50 (g/g) of MeOH/water mixtures at 70°C; the reaction lasted for 8 h. Compared to dispersion polymerization using polyvinylpirrolydone, PVA proved to be an extremely stable steric stabilizer in the dispersion polymerization of methylmethacrylate.     

Increasing Chemical Diversity of B2N2 Anthracene Derivatives by Introducing Continuous Multiple Boron-Nitrogen Units

Increasing the chemical diversity of organic semiconductors is essential to develop efficient electronic devices. In particular, the replacement of carbon-carbon (C−C) bonds with isoelectronic boron-nitrogen (B−N) bonds allows precise modulation of the electronic properties of semiconductors without significant structural changes. Although some researchers have reported the preparation of B₂N₂ anthracene derivatives with two B−N bonds, no compounds with continuous multiple BN units have been prepared yet. Herein, we report the synthesis and characterization of a B₂N₂ anthracene derivative with a BNBN unit formed by converting the BOBN unit at the zigzag edge. Compared to the all-carbon analogue 2-phenylanthracene, BNBN anthracene exhibits significant variations in the C−C bond length and a larger highest occupied molecular orbital–lowest unoccupied molecular orbital energy gap. The experimentally determined bond lengths and electronic properties of BNBN anthracene are confirmed through theoretical calculations. The BOBN anthracene organic light-emitting diode, used as a blue host, exhibits a low driving voltage. The findings of this study may facilitate the development of larger acenes with multiple BN units and potential applications in organic electronics.     

Tunneling in the loss of hydrogen chloride from isopropyl chloride cation

The unimolecular dissociation of isopropyl chloride cation has been investigated using mass-analyzed ion kinetic energy spectrometry. The C3H6*+ ion was the only product ion in the metastable dissociation. The kinetic energy release distribution for the HCl loss was determined. Ab initio molecular orbital calculations were performed at the MP2/6-311++G(d,p) level together with single point energy calculations at the QCSID(T)/6-311++G(2d,2p) level. The calculations show that the molecular ion rearranges to an ion-dipole complex prior to loss of HCl via a transition state containing a four-membered ring. The rearrangement involves H atom transfer. On the basis of the potential energy surface obtained for the loss of HCl and Cl*, the rate constants were calculated by transition-state statistical theories with considering tunneling effect. From the calculated result, it is proposed that the observed HCl loss would occur via tunneling through the barrier for isomerization to the ion-dipole complex, CH3CHCH2*+...HCl.     

Fast and Selective Semihydrogenation of Alkynes by Palladium Nanoparticles Sandwiched in Metal–Organic Frameworks

The semihydrogenation of alkynes into alkenes rather than alkanes is of great importance in the chemical industry. Unfortunately, state-of-the-art heterogeneous catalysts hardly achieve high turnover frequencies (TOFs) simultaneously with almost full conversion, excellent selectivity, and good stability. Here, we used metal–organic frameworks (MOFs) containing Zr metal nodes (“UiO”) with tunable wettability and electron-withdrawing ability as activity accelerators for the semihydrogenation of alkynes catalyzed by sandwiched palladium nanoparticles (Pd NPs). Impressively, the porous hydrophobic UiO support not only leads to an enrichment of phenylacetylene around the Pd NPs but also renders the Pd surfaces more electron-deficient, which leads to a remarkable catalysis performance, including an exceptionally high TOF of 13835 h⁻¹, 100 % phenylacetylene conversion 93.1 % selectivity towards styrene, and no activity decay after successive catalytic cycles. The strategy of using molecularly tailored supports is universal for boosting the selective semihydrogenation of various terminal and internal alkynes.     

PMA-induced up-regulation of MMP-9 is regulated by a PKCalpha-NF-kappaB cascade in human lung epithelial cells

Expression of matrix metalloproteinase-9 (MMP-9) is associated with airway remodeling and tissue injury in asthma. However, little is known about how MMP-9 is up-regulated in airway epithelial cells. In this study, we show that phorbol myristate acetate (PMA) induces MMP-9 expression via a protein kinase Calpha (PKCalpha)-dependent signaling cascade in BEAS-2B human lung epithelial cells. Pretreatment with either GF109203X, a general PKC inhibitor, or Go6976, a PKCalpha/beta isozyme inhibitor, inhibited PMA-induced activation of the MMP-9 promoter, as did transient transfection with PKCalpha antisense oligonuclotides. PMA activated NF-kappaB by phosphorylating IkappaB in these cells and this was also inhibited by GF109203X and Go6976, suggesting that PKCa acts as an upstream regulator of NF-kappaB in PMA-induced MMP-9 induction. Our results indicate that a "PKCalpha-NF- kappaB"-dependent cascade is involved in the signaling leading to PMA-induced MMP-9 expression in the lung epithelium.     

Transfection of Mammalian Cells Using Block Copolypeptide Vesicles

An arginine‐leucine block copolypeptide (R₆₀L₂₀) is synthesized, which is capable of forming vesicles with controllable sizes, able to transport hydrophilic cargo across the cell membrane, and exhibit relatively low cytotoxicity. The R₆₀L₂₀ vesicles also possess the ability to deliver DNA into mammalian cells for transfection. Although the transfection efficiency is lower than that of the commercially available transfection agent Lipofectamine 2000, the R₆₀L₂₀ vesicles are able to achieve transfection with significantly lower cytotoxicity and immunogenicity. This behavior is potentially due to its stronger interaction with DNA which subsequently provides better protection against anionic heparin.