Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

Nonspecific medium effects versus specific group positioning in the antibody and albumin catalysis of the base-promoted ring-opening reactions of benzisoxazoles

The mechanisms by which solvents, antibodies, and albumins influence the rates of base-catalyzed reactions of benzisoxazoles have been explored theoretically. New experimental data on substituent effects and rates of reactions in several solvents, in an antibody, and in an albumin are reported. Quantum mechanical calculations were carried out for the reactions in water and acetonitrile, and docking of the transition state into a homology model of antibody 34E4 and an X-ray structure of human serum albumin was accomplished. A microenvironment made up of catalytic polar groups (glutamate in antibody 34E4 and lysine in human serum albumin) surrounded by relatively nonpolar groups is present in both catalytic proteins.     

套索冠醚毛细管色谱柱的研制

用套索冠醚N,N′-双(2-甲基吡啶)-二氮杂-18-冠-6作为固定相,涂渍在弹性石英毛细管内,测其柱效、惰性、热稳定性、平均极性及选择性等性质.其结构由元素分析、红外光谱、核磁共振及质谱分析的试验数据所证实.试验表明,它具有良好的色谱性能、中等极性,适用于对醇、卤代烃、芳香烃等各类异构体的分离,并用分子结构观点探讨了保留机理.     

Catalysis on the coastline: theozyme,molecular dynamics,and free energy perturbation analysis of antibody 21D8 catalysis of the decarboxylation of 5-nitro-3-carboxybenzisoxazole

Antibody 21D8 catalyzes the decarboxylation of 5-nitro-3-carboxybenzisoxazole. The hapten used was designed to induce an antibody binding site with anion binders for the carboxylate, plus a nonpolar environment to accelerate decarboxylation. A recent X-ray crystal structure of 21D8 has shown that the binding pocket contains an array of both polar and charged residues. Nevertheless, 21D8 is able to catalyze a reaction that involves a decrease in polarity from reactant to transition state. The origins of this phenomenon were explored using various computational strategies-quantum mechanics, theozyme models, docking, molecular dynamics, free energy perturbation, and linear interaction energy-the combination of which has produced a consistent picture of catalysis. By partially desolvating the charged carboxylate, 21D8 manages to effect "catalysis on the coastline," without burying the carboxylate in a nonpolar region of the binding pocket. The results have implications for that broad class of enzyme and antibody catalyzed reactions that involve the conversion of a substrate with a relatively localized charge into a transition state with a highly dispersed charge.     

Preparation and characterization of sulfated zirconia (SO4/ZrO2)/Nafion composite membranes for PEMFC operation at high temperature/low humidity

Fine particle superacidic sulfated zirconia (SO₄²⁻/ZrO₂, S-ZrO₂) was synthesized by ameliorated method, and composite membranes with different S-ZrO₂ contents were prepared by a recasting procedure from a suspension of S-ZrO₂ powder and Nafion solution. The physico-chemical properties of the membranes were studied by ion exchange capacity (IEC) and liquid water uptake measurements, scanning electron microscopy (SEM) and X-ray diffraction (XRD) analysis, thermogravimetry–mass spectrometry (TG–MS) and Fourier transform infrared (FT-IR) spectroscopy. The results showed that the IEC of composite membrane increased with the content of S-ZrO₂, S-ZrO₂ was compatible with the Nafion matrix, the incorporation of the S-ZrO₂ could increase the crystallinity and also improve the initial degradation temperature of the composite membrane. The performance of single cell was the best when the S-ZrO₂ content was 15 wt.%, and achieved 1.35 W/cm² at 80 °C and 0.99 W/cm² at 120 °C based on H₂/O₂ and at a pressure of 2 atm, the performance of the single cell with optimized S-ZrO₂ was far more than that of the Nafion at the same condition (e.g. 1.28 W/cm² at 80 °C, 0.75 W/cm² at 120 °C). The 15 wt.% S-ZrO₂/Nafion composite membrane showed lower fuel cell internal resistance than Nafion membranes at high temperature and low relative humidity (RH).     

中国散裂中子源直线射频功率源系统的研制

中国散裂中子源加速器质子束流加速能量为1.6 GeV,重复频率为25 Hz,撞击固体金属靶产生散射中子,一期工程的打靶束流功率为100 kW。直线加速器的设计束流流强为15 mA,输出能量为81 MeV。射频加速和聚束系统包括一台射频四极场加速器、中能束流传输线的两个聚束器、四节漂移管直线加速器加速腔和直线-环束流传输线的一个散束器,与之相对应,共有8个单元在线运行的射频功率源为其提供所需的射频功率。目前,直线射频功率源系统预研项目已全部完成,各项性能参数均已达到设计指标,当前正处在批产安装调试阶段。151013     

Indandione-Terminated Quinoidal Compounds for Low-Bandgap Small Molecules with Strong Near-Infrared Absorption: Effect of Conjugation Length on the Properties

Low-bandgap organic semiconductors have attracted much attention for their multiple applications in optoelectronics. However, the realization of narrow bandgap is challenging particularly for small molecules. Herein, we have synthesized four quinoidal compounds, i. e., QSN3 , QSN4 , QSN5 and QSN6 , with electron rich S,N-heteroacene as the quinoidal core and indandione as the end-groups. The optical bandgap of the quinoidal compounds is systematically decreased with the extension of quinoidal skeleton, while maintaining stable closed-shell ground state. QSN6 absorbs an intense absorption in the first and second near-infrared region in the solid state, and has extremely low optical bandgap of 0.74 eV. Cyclic voltammetry analyses reveal that the lowest unoccupied molecular orbital (LUMO) energy levels of the four quinoidal compounds all lie below −4.1 eV, resulting in good electron-transporting characteristics in organic thin-film transistors. These results demonstrated that the combination of π-extended quinoidal core and end-groups in quinoidal compounds is an effective strategy for the synthesis of low-bandgap small molecules with good stability.     

稀土掺杂的(K, Sr)Cl·SiO2复合凝胶的荧光性能

采用sol gel法制备了单掺铕及共掺铕、铈的(K,Sr)Cl·SiO2复合凝胶,研究了复合凝胶的荧光性能。根据荧光测试结果,复合凝胶中,Eu3+在没有还原剂的作用下,可以与基质作用形成还原态的Eu2+,复合凝胶表现出相应的Eu2+荧光性能;研究认为,Ce3+,Eu3+共掺杂时,复合凝胶激发光谱与发射光谱峰位基本不变,但强度有所不同。330nm处的激发光谱明显增强,且发射光谱随Ce3+的掺杂量增加而增强。当Ce3+掺杂浓度为3.0%(原子分数)时,复合凝胶具有最大的荧光发射强度,表明Ce3+具有很好的敏化作用。在Ce3+,Eu3+共掺杂复合凝胶体系中,复合凝胶荧光强度增大的原因既可能是电子转移过程,也可能是Ce3+→Eu2+的能量传递过程所致。     

Magnetic cobalt nanowire thin films

Two-dimensional (2D) and three-dimensional (3D) magnetic cobalt nanowire thin films with tunable 3-10 nm wire diameters have been electrodeposited using mesoporous silica templates containing 2D hexagonal or 3D cubic pore channels. As compared to bulk cobalt films, the cobalt nanowire thin films exhibit enhanced coercivities and controllable magnetic anisotropy through tuning of the mesostructure and dimension of the nanowires. Such novel magnetic nanowire thin films may provide a new platform for high-density information storage applications.     

多振子声子晶体的低频特性研究

本文设计了一种由硅橡胶包覆层包裹4个钨振子的新型声子晶体结构,通过有限元法计算该结构的色散曲线、振动模态和传输损失谱。结果表明,该结构的带隙范围为18.85~225.28 Hz,与传输损失谱频率衰减范围相吻合,能够有效抑制20~200 Hz的弹性波在声子晶体中传播。通过分析色散曲线上点的振动模态,说明带隙产生的原因。本文讨论了声子晶体板的缺口角度和振子之间的纵向和横向间距对带隙的影响,结果表明:当缺口角度减小时,带隙下边界几乎保持不变,带隙上边界升高从而增加了带隙的宽度;振子之间横向或纵向间距增大时,带隙下边界和上边界均上升,带隙变宽,进而优化了声子晶体模型的带隙。同时声子晶体板的缺口设计能够节省材料,从而减轻结构的质量。