Tetrakis(4-N,N-dimethylaminobenzene)porphyrinato]manganese(III) acetate as a novel carrier for a selective iodide PVC membrane electrode.

[5,10,15,20-Tetrakis(4-N,N-dimethylaminobenzene)porphyrinato]Mn(III) acetate (MnTDPAc) was applied as an ionophore for an iodide-selective PVC membrane electrode. The influences of the membrane composition, pH of the test solution and foreign ions on the electrode performance were investigated. The sensor exhibited not only excellent selectivity to iodide ion compared to Cl- and lipophilic anions such as ClO4- and salicylate, but also a Nernstian response with a slope of -59.4 +/- 1.2 mV per decade for iodide ions over a wide concentration range from 1.0 x 10(-2) to 7.5 x 10(-6) M at 25 degrees C. The potentiometric response was independent of the pH of the solution in the pH range of 2 - 8. The electrode could be used for at least 2 months without any considerable divergence in the potential. Good selectivity for iodide ion, a very short response time, simple preparation and relatively long-term stability were the silent characteristics of this electrode. It was successfully used as an indicator electrode in the potentiometric titration of iodide ions, and also in the determination of iodide from seawater samples and drug formulations.     

Headspace SPME–GC Method for Acetone Analysis and its Biomedical Application

A new method for extraction and analysis of acetone in human urine based on headspace solid phase microextraction using a mixture of activated carbon and zeolite as sorbents in a PVC matrix coated on a silver wire and its application to the determination of ketone bodies is described. Unlike commercial fibers, which are coated on fused silica, the coating adheres strongly to the silver wire and is thermally stable up to 250 °C. After optimization of coating composition and microextraction conditions the fiber was used for the analysis of acetone in human urine.     

Electromagnetic interference shielding and radiation absorption in thin polypyrrole films

Results of permittivity measurements, electromagnetic interference shielding effectiveness, and heat generation due to microwave absorption in conducting polymer coated textiles are reported and discussed. The intrinsically conducting polymer, polypyrrole, doped with anthraquinone-2-sulfonic acid (AQSA) or para-toluene-2-sulfonic acid (pTSA) was applied on textile substrates and the resulting materials were investigated in the frequency range 1-18 GHz. The 0.54 mm thick conducting textile/polypyrrole composites absorbed up to 49.5% of the incident 30-35 W microwave radiation. A thermography station was used to monitor the temperature of these composites during the irradiation process, where absorption was confirmed via visible heat losses. Samples with lower conductivity showed larger temperature increases caused by microwave absorption compared to samples with higher conductivity. A sample with an average sheet resistivity of 150 Ω/sq. showed a maximum temperature increase of 5.27 °C, whilst a sample with a lower resistivity (105 Ω/sq.) rose by 3.85 °C.     

Spectrophotometric Study of the Complexation of Some Lanthanide (III) Ions with a Series of 18-Crowns-6 in DMSO Solution Using Murexide as a Metallochromic Indicator

The complexation of La(III), Ce(III), Pr(III) and Er(III) with 18-crown-6(18C6), dibenzo-18-crown-6 (DB18C6), dicyclohexano-18-crown-6 (DCY18C6) anddibenzopyridino-18-crown-6 (DBPY18C6) has been studied in dimethylsulfoxide(DMSO) by means of a competitive spectrophotometric method using murexide asa metal ion indicator. The formation constants of the 1 : 1 complexeswere found tovary in the order La(III) > Ce(III) > Pr(III) > Er(III). It was foundthat the structure influences the formation and stability of the resultingcomplexes. The effects ofvarious parameters on complexation are discussed. The order of the stabilityconstants of each lanthanide ion with these macrocycles are18C6 > DC18C6 > DB18C6 > DBPY18C6.     

Surface thermodynamic functions of dilute solutions of methylcyclohexanols in ethylene glycol

Surface thermodynamic functions (surface entropy, surface enthalpy, and surface composition) of dilute solutions of 2-, 3-, and 4-methylcyclohexanol in ethylene glycol were obtained using surface tension measurements at various temperatures. Surface excess values and surface mole fractions were obtained from Gibbs equation and extended Langmuir model respectively. The results show that all methylcyclohexanols are surface active in ethylene glycol. The lyophobicity of solutes decreases with increasing temperature. The presence of a maximum point in the surface entropy diagram in all systems is explained by the formation of clathrate-like solvates at the surface of these systems.     

Solid phase extraction of gold by sorption on octadecyl silica membrane disks modified with pentathia-15-crown-5 and determination by AAS

A simple and selective method for rapid and efficient concentration and determination of μg l⁻¹ levels of Au(III) ions in aqueous solution using octadecyl silica membrane disks modified by pentathia-15-crown-5 and flame atomic absorption spectrometry is presented. The influence of flow rates of eluent and sample solution, amount of ligand, types and least amount of eluent for elution of Au from disks were investigated. Break through volume and limit of detection of the membrane disks modified by 5 mg of the thiacrown ether was found to be 2.0 l and 1.0 μg l⁻¹, respectively. The effects of various cationic interferences on percent recovery of gold were studied. The method was successfully applied for the determinations of gold in some pharmaceutical samples and for the recovery of trace Au³⁺ ions from synthetic and water samples.     

Mutual Separation and Determination of Th(IV) and U(VI) Using Arsenazo III as a Dye Collector Reagent by Flotation‐Spectrophotometric Method

This paper reports a simple and highly selective method for the separation, preconcentration, and determination of trace amounts of thorium and uranium in some complex samples via staircase flotation. The method is based on the initial flotation of the Th(IV)‐arsenazo III complex in the presence of U(VI) from a solution of 5 mol dm^?3 HCl, then reduction of U(VI) to U(IV) and repetition of the flotation step. In both steps, the floated complex was dissolved in a 5‐mL portion of methanol and its absorbance was measured at 655 nm, spectrophotometrically. For a 30‐mL portion of the sample, Beer's law was obeyed over the concentration ranges of 3.40 × 10^?7to 3.06 × 10^?6 mol dm^?3 for Th(IV) and3.40 × 10^?7 to 3.40 × 10^?6 mol dm^?3 for U(IV) with the apparent molar absorptivity of 4.20 × 10⁵ dm³ mol^?1 cm^?1 and 3.59 × 10⁵ dm³ mol^?1 cm^?1, respectively. The RSDs (n = 7) corresponding to 1.7 × 10^?6 mol dm^?3 of Th(IV) and U(IV) were obtained as 1.7% and 1.87%. The detection limits (7 blanks) for both the metal ions were found to be 1.7 × 10^?7 mol dm^?3. The important benefit of the method is that the determinations are free from the interference of almost all cations and anions found in the complex matrixes, such as seawater samples. The proposed method was also applied to reference materials, and the determinations were shown to have good agreement with the certified values.     

Zein film as a novel natural biopolymer membrane in electrochemical detections

Permselective modifier films are very important in preparing highly sensitive electrochemical sensors. In this work, for the first time, the behavior of gold and glassy carbon electrodes coated with biocompatible zein film as a permselective membrane for the electrochemical detection of various compounds has been investigated. For this purpose, several electroactive cationic (methylene blue, brilliant green, and thionine) and anionic (potassium ferricyanide, alizarin red S, and riboflavin-5’-phosphate) compounds have been used as model. Atomic force microscopy (AFM) and scanning electron microscopy (SEM) showed that zein membranes prepared from casting solution containing 1% zein in ethanol/water have porous structures with high nanometric roughness. The capacitance values of electrical double layers of electrodes modified with zein film were very high for hydrophilic ions in comparison with hydrophobic ions. Point of zero charge pH (pH_pzc) of zein membrane was 4.8. The results of cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) as well as pH_pzc study indicated that zein permselective membrane acts as ion exchanger film for selected cationic compounds with fast electrochemical kinetics responses in aqueous solution (pH=7). This behavior was confirmed by circulating solutions containing model compounds from homemade continuous cell equipped with polyamide membranes modified with zein film.

Graphical Abstract

     

An approach to estimate the energy and strength of the intramolecular hydrogen bond in different conformers of 4‐methylamino‐3‐penten‐2‐one

The molecular structure and intramolecular hydrogen bond energy of 32 conformers of 4‐methylamino‐3‐penten‐2‐one were investigated at MP2 and B3LYP levels of theory using the standard 6–31G** basis set and AIM analyses. Furthermore, calculations for all the possible conformations of 4‐methylamino‐3‐penten‐2‐one in water solution were also carried out at B3LYP/6–31G** level of theory. The calculated geometrical parameters and conformational analyses in gas phase and water solution show that the ketoamine conformers of this compound are more stable than the other conformers (i.e., enolimine and ketoimine). This stability is mainly due to the formation of a strong N? H···O intramolecular hydrogen bond, which is assisted by π‐electrons resonance. Hydrogen bond energies for all conformers of 4‐methylamino‐3‐penten‐2‐one were obtained from the related rotamers method. The nature of intramolecular hydrogen bond existing within 4‐methylamino‐3‐penten‐2‐one has been investigated by means of the Bader theory of atoms in molecules, which is based on topological properties of the electron density. The results of these calculations support the results which obtained by related rotamers method. © 2007 Wiley Periodicals, Inc. Int J Quantum Chem, 2007     

Ketoconazol‐Triiodide Ion Pair Complex as a Suitable Carrier in an Iodide Selective Membrane Electrode

A novel membrane sensor for selective monitoring of iodide, consisting of a triiodide‐ketoconazole ion pair complex dispersed in a PVC matrix, plasticized with a mixture of 2‐nitrophenyl octyl ether and dioctylphtalate with unique selectivity toward iodide ions, is described. The influence of membrane composition, pH of test solution and foreign ions on the electrode performance were investigated. The optimized membrane demonstrates a near‐Nernstian response for iodide ions over a wide linear range from 1.0 × 10^?2 to 1.0 × 10^?5 M, at 25 ± 1 °C. The electrode could be used over a wide pH range 3–10 and has the advantages of high selectivity, fast response time and good lifetime (over 4 months). It was successfully used as indicator electrode in potentiometric titrations and direct potentiometric assay of iodide ions.