Status of heavy element research using a gas-filled recoil separator at RIKEN

A gas-filled type of recoil separator for heavy element research was installed at an experimental hall of RIKEN Linear Accelerator facility to realize getting higher intensity of primary beam and long beam time. Performance of the separator was studied using target recoils and various nuclear reactions. The results show the high performance of the separator for heave element research. As an application of the GARIS, production and identification of an isotope of the 110th element ²⁷¹[110] have been performed using the ²⁰⁸Pb(⁶⁴Ni,1n)²⁷¹[110] reaction. Three decay chains coincide well both in decay times and energies with the ones reported by the group of SHIP experiment at GSI, Germany. Our results provide a confirmation of the synthesis of an isotope ²⁷¹[110] of element 110.     

Improved detectability with a polymer-based trapping device in rapid HPLC analysis for ultra-low levels of bisphenol A (BPA) in environmental samples.

A new high-performance liquid chromatography (HPLC) method has been developed to detect ultra-low concentrations of bisphenol-A (BPA) (below 1 ng/L (ppt)) using column switching electrochemical detection (ECD). The results were superior to those obtained from manual pretreatment procedure with membrane stationary phase. BPA is inherently ubiquitous in the environment, including tools and solvents used for its analysis; to obtain meaningful results, therefore, the concentration of the overall BPA contamination must be below the detection limit for BPA using the analytical system. Therefore, purified water for preparing the standard BPA solution must be filtered with a hydrophobic membrane to suppress BPA background levels of contamination. In addition, we investigated methods for effectively preserving environmental water containing BPA. The addition of a small amount of ethylenediaminetetraacetic acid (EDTA) provided good recovery even after overnight storage. By employing these precautionary measures and procedures to reduce BPA contamination from the analytical procedure, we could accurately determine l(-10) ppt of BPA in environmental water samples using a column switching HPLC system.     

Formulation for XPS spectral change of oxides by ion bombardment as a function of sputtering time

XPS measurement revealed that the original state of TiO₂ was changed to Ti₂O₃ and TiO by ion bombardment. TiO₂ decreased and Ti₂O₃ increased at the initial stage. TiO increased at a later stage than Ti₂O₃. Each of them saturated after enough sputtering time.A formulation was proposed in order to explain the change of XPS spectra for oxides as a function of ion sputtering time. This formulation was based on reaction equations that contain two reduction processes (from TiO₂ to Ti₂O₃ and from Ti₂O₃ to TiO), and sputtering effects. Using four fitting parameters (two reduction coefficients, sputtering yield and information depth), the present formula was fitted to the experimental results. The fitting results agree satisfactorily with the experimental results. The calculation shows that the reduction coefficient from TiO₂ to Ti₂O₃ is about ten times larger than that from Ti₂O₃ to TiO. This calculation predicts that surface composition of an oxide that is changed by ion bombardment will reach a different value depending on its bulk composition. Moreover, the present formulation can determine the chemical states of compounds changed by ion bombardment.     

Influence of nuclear reactor accident at Chernobyl' on the environmental radioactivity in Toyama

The environmental radioactivity caused by the reactor accident at Chernobyl' was investigated from May 7 to May 31 of 1986 in Toyama. Measurement of radioactivities in airborne particles, rain water, drinking water, milk, and mugwort are carried out by gamma-ray spectrometry (pure Ge detector; ORTEC GMX-23195). Ten different nuclides (103Ru, 106Ru, 131I, 132Te-I, 134Cs, 136Cs, 137Cs, 140Ba-La) are identified from samples of airborne particles. In the air samples, a maximum radioactivity concentration of each nuclide is observed on 13th May 1986. The time of the reactor shut-down and the flux of thermal neutron at the reactor were calculated from 131I/132I and 137Cs/134Cs ratio. The exposure dose in Toyama by this accident is given as follows: internal exposure; [thyroid] adult-59 microSv, child-140 microSv, baby-130 microSv, [total body] adult-0.2 microSv, child, baby-0.4 microSv, external exposure; 7 microSv, effective dose equivalent; adult-9 microSv, child-12 Sv, baby-11 microSv.     

Electron spin resonance studies of plasma-induced polystyrene radicals

Plasma-induced polystyrene radicals were first studied by electron spin resonance (ESR). The room temperature ESR spectrum was compared with those obtained by γ-irradiation, UV-irradiation, and mechanical fracture. It was found that even less than a few seconds of plasma-irradiation gave rise to a large amount of polystyrene radicals and the ESR spectrum consisted of two types of spectra, a triplet and a single broad line. The spectral feature of the triplet was nearly identical with that of γ-irradiated polystyrene. Thus, it was assigned to the structure of a cyclohexadienyl-type radical formed by a nearly random addition of a hydrogen atom to the aromatic ring. The single broad line, thought to be an outline of multicomponent spectrum, was assigned to an immobilized dangling-bond sites at the plasma-induced crosslinked portion of the polystyrene surface.     

Electrical conductance of solutions of lithium nitrate in 1,3-diaminopropane

Electrical conductances and densities of the LiNO₃-1,3-diaminopropane system have been measured as a function of composition and temperature. The results suggest that the solvent molecules may act as bridges between Li⁺ ions at higher concentration of LiNO₃.     

Self-assembled DNA-conjugated polymer for novel DNA chip.

We developed DNA-conjugated polymer for DNA chip fabrication. A 30 mer probe DNA and disulfide bridges were covalently attached to the polymer side chain. The DNA-conjugated polymer can be specifically adsorbed on a gold substrate surface by a self-assembly technique. The interaction between fully matched DNA and DNA-conjugated polymer was investigated by surface plasmon resonance (SPR) technique. The DNA-conjugated polymer-modified gold surface highly recognized fully matched DNA, rather than unmatched DNA. Therefore, DNA-conjugated polymer can be used for novel DNA chip fabrication.     

Synthesis of a mechanically linked oligo[2]rotaxane

A bifunctional [2]rotaxane, bearing two free functional groups each in the ring and axial parts, was synthesized, followed by its polycondensation with methylene diphenyl diisocyanate leading to a mechanically linked oligo[2]rotaxane.