New methodologies in trace analysis of volatile organic compounds

Two methods for sampling and concentration of volatile organic compounds are reported. In the first method, traps coated with a very thick film (ca. 100 μm) of cross-linked silicone stationary phase are employed. Such thick films can be prepared with a modified dynamic coating procedure, which is briefly described. The low phase ratio traps can be utilized for enrichment of volatiles from gaseous as well as aqueous matrices. The second technique is based on chromatographic evaporation of a solvent in a capillary tube, where the process is sustained by a repeated sample injection and a cyclic flow reversal. In this way, large solvent volumes can be handled by a small volume system. Under optimal conditions, when using a solvent barrier, quantitative recovery is possible even for compounds of comparatively high volatility. Another important application of the technique is extraction of trace components from gases such as headspace samples, polluted air, etc.     

α-Glucosidase synthesis in batch and continuous culture ofSaccharomyces cerevisiae

Glucose prevents maltose utilization bySaccharomyces cerevisiae in batch culture, whereas in a mixed carbohydrate-limited chemostat, maltose and glucose were consumed simultaneously. The specific activity of α-glucosidase was dependent on the dilution rate as well as the proportion of maltose in the mixture. Maximum specific activities in the batch and chemostat cultures on mixtures of maltose and glucose were lower than corresponding values observed on maltose alone.     

A technique for coating capillary columns with a very thick film of cross-linked stationary phase

A method for preparation of capillary columns and traps with a very thick film (up to 100 μm) of stationary phase is described. The principle of this method is based on an immediate fixation of a film of prepolymer, formed during dynamic coating. Thus, the development of film irregularities, such as are caused by Rayleigh instability is avoided. Fixation of the film is conveniently accomplished by heat-accelerated crosslinking as was demonstrated in this work, where a commercially available silicone prepolymer (Sylgard 184, Dow Corning) was employed. The low phase ratio columns which thus can be prepared are interesting both in chromatography with dense mobile phases and as enrichment devices. Examples of the latter application are shown, where trace organic components from air and water were concentrated.     

A mechanism from quantum chemical studies for methane formation in methanogenesis

The mechanism for methane formation in methyl-coenzyme M reductase (MCR) has been investigated using the B3LYP hybrid density functional method and chemical models consisting of 107 atoms. The experimental X-ray crystal structure of the enzyme in the inactive MCR(ox1)(-)(silent) state was used to set up the initial model structure. The calculations suggest a mechanism not previously proposed, in which the most remarkable feature is the formation of an essentially free methyl radical at the transition state. The reaction cycle suggested starts from a Michaelis complex with CoB and methyl-CoM coenzymes bound and with a squareplanar coordination of the Ni(I) center in the tetrapyrrole F(430) prosthetic group. In the rate-limiting step the methyl radical is released from methyl-CoM, induced by the attack of Ni(I) on the methyl-CoM thioether sulfur. In this step, the metal center is oxidized from Ni(I) to Ni(II). The resulting methyl radical is rapidly quenched by hydrogen-atom transfer from the CoB thiol group, yielding the methane molecule and the CoB radical. The estimated activation energy is around 20 kcal/mol, which includes a significant contribution from entropy due to the formation of the free methyl. The mechanism implies an inversion of configuration at the reactive carbon. The size of the inversion barrier is used to explain the fact that CF(3)-S-CoM is an inactive substrate. Heterodisulfide CoB-S-S-CoM formation is proposed in the final step in which nickel is reduced back to Ni(I). The suggested mechanism agrees well with experimental observations.     

A density functional study on a biomimetic non-heme iron catalyst: insights into alkane hydroxylation by a formally HO-FeV=O oxidant

The reactivity of [HO-(tpa)Fe(V)=O] (TPA=tris(2-pyridylmethyl)amine), derived from O-O bond heterolysis of its [H(2)O-(tpa)Fe(III)-OOH] precursor, was explored by means of hybrid density functional theory. The mechanism for alkane hydroxylation by the high-valent iron-oxo species invoked as an intermediate in Fe(tpa)/H(2)O(2) catalysis was investigated. Hydroxylation of methane and propane by HO-Fe(V)=O was studied by following the rebound mechanism associated with the heme center of cytochrome P450, and it is demonstrated that this species is capable of stereospecific alkane hydroxylation. The mechanism proposed for alkane hydroxylation by HO-Fe(V)=O accounts for the experimentally observed incorporation of solvent water into the products. An investigation of the possible hydroxylation of acetonitrile (i.e., the solvent used in the experiments) shows that the activation energy for hydrogen-atom abstraction by HO-Fe(V)=O is rather high and, in fact, rather similar to that of methane, despite the similarity of the H-CH(2)CN bond strength to that of the secondary C-H bond in propane. This result indicates that the kinetics of hydrogen-atom abstraction are strongly affected by the cyano group and rationalizes the lack of experimental evidence for solvent hydroxylation in competition with that of substrates such as cyclohexane.     

Illustration of a simple and versatile scheme for reversing enantiomeric elution order and facilitating enantiomeric impurity determination in capillary electrophoresis

Determination of enantiomeric purity is most often done under overload conditions, which leads to deformed peaks. In general, the best resolutions are obtained when the small peak appears before the large peak in the electropherogram. To be able to determine the R(+)-impurity in the S(-)-form as well as the S(-)-impurity in the R(+)-form the elution orders have to be reversed. The present paper describes reversal of enantiomeric elution order for the basic analyte propranolol and the acidic analyte ibuprofen. For propranolol, a charged heptakis-(6-sulfo)-beta-cyclodextrin (CD) is used in the background electrolyte. For ibuprofen, a mix of the charged heptakis-(6-sulfo)-beta-CD and the uncharged heptakis-(2,3,6-tri-O-methyl)-beta-CD is used in the background electrolyte. The use of a coated capillary and reversal of the polarity shift the elution order, buffer composition is unchanged in both cases. The enantiomers of propranolol and ibuprofen are well separated on both the coated and uncoated capillaries. Detection limits of enantiomer impurities are investigated using spiked samples of both propranolol and ibuprofen.     

Einwirkung von p-Nitroso-dimethylanilin auf Brenztraubensäure und ihre Derivate, 6. Mitt.: Kondensation der Phenylbrenztraubensäure mit primären aromatischen Aminen

Phenylpyruvic acid reacts with p-nitroaniline to yield the 3-hydroxypyrrolinone2a, and with anilines bearing+M substituents in the p-position to yield the 3-enaminopyrrolinones1b-1e.

---

---

Mit 1 Abbildung

---

5. Mitt.:M. Ruse, E. Hamburg undM. Petri, Chem. Ber.103, 3727 (1970).     

Improved quantification limits in chiral capillary electrochromatography by peak compression effects

The peak compression effect has been applied to improve quantification limits in chiral capillary electrochromatography (CEC). A stationary phase based on the chiral selector vancomycin (Chirobiotic V) was used for separations of the enantiomers of mianserin. By adding solvents with a low dielectric constant, e.g. 2-propanol or tetrahydrofuran, to the sample solution, peak compression could be induced. The plate numbers for the minor enantiomer increased from approximately 100,000 to 1.4-1.6 million plates/m, when the composition of the mobile phase was adjusted so that the analyte eluted within either one of two system zones originating from the sample solution. A 10-fold improvement in the quantification limit for the minor enantiomer was obtained compared to elution under non-focused conditions.     

Bonded dimethylacrylamide as a permanent coating for capillary electrophoresis

A method for coating capillaries for capillary electrophoresis with chemically bonded polydimethylacrylamide has been developed, and the properties of the capillaries have been evaluated. The coated capillaries provided high separation efficiency, 12 x 10(5) theoretical plates/m was obtained for cytochrome c. The electroosmotic flow at pH 8.0 was 10 x 10(-10) to 6 x 10(-10) m2 V(-1) s(-1). The coated capillaries were quite stable at high pH. At least 150 runs could be done at pH 10 without appreciable performance deterioration. The excellent performance of the coated capillaries was illustrated by separation of basic proteins, acidic proteins, 9-fluorenylmethyl chloroformate-derivatized neurotransmitter amino acids, peptide reference mixtures and peptides digested from a bacteria protein.