The Existence of Periodic Orbits for Higher Dimensional Autonomous Systemswith Small Perturbations

ＴｈｅＥｘｉｓｔｅｎｃｅｏｆＰｅｒｉｏｄｉｃＯｒｂｉｔｓｆｏｒＨｉｇｈｅｒＤｉｍｅｎｓｉｏｎａｌＡｕｔｏｎｏｍｏｕｓＳｙｓｔｅｍｓｗｉｔｈＳｍａｌｌＰｅｒｔｕｒｂａｔｉｏｎｓＪｉａｎｇＬｉｑｉｎｇ（蒋里强）；ＺｈｏｕＹｉ（周毅）；ＦａｎＹｅ（范晔）（...     

Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

半导体激光泵浦预激光锁模调Q固体激光器研究

报道半导体激光侧面泵浦预激光锁模调Ｑ的Ｎｄ：ＹＡＧ固体板条激光器，预激光锁模调Ｑ的激光脉冲宽度为３６ｐｓ，调Ｑ包纤各心的锁模单脉冲能量超过７μＪ，相应的峰值功率达２００ｋＷ。     

二氯甲烷在担载型三氧化铬催化剂上的催化降解

本文研究了二氯甲烷在不同的担载型ＣｒＯ_３催化剂上的催化降解．实验揭示：碳纤维的单丝直径粗细，吸附能力，ＺＳＭ－５沸石中晶格外铝的含量以及Ａｌ_２Ｏ_３的形貌与物相等均明显影响催化剂的催化活性与选择性．文中对不同的载体作了比较，还对活性组分ＣｒＯ_３的铬的价态，用氢气还原与空气灼烧两种预处理对催化行为的影响进行了讨论．     

尿中肌酐的流动注射分析

本文提出了一种简便快速的尿中肌酐的测定方法。采用空气整段间隔试样带的流动注射分析体系,在非化学反应平衡的条件下测定,尿样不经手工稀释可直接用于测定。测样频率每小时为90次,相对标准偏差为1.5%。     

银络合物在催化核上的还原反应

研究了尿嘧啶银络合物在胶态金属及其硫化物核上被对苯二酚还原的反应，并以Ａｇ和Ｐｔ电极代替催化核与对苯二酚显影剂和银络合物组成原电池作为电化学模型，分别测定该络合物阴极反应和对苯二酚阳极反应的电流。结果表明，原电池的电流大小与反应速度成正比关系，从而为物理显影电极理论提供实验依据。     

Picolinamide-Cu(Ac)2-imprinted polymer with high potential for recognition of picolinamide-copper acetate complex

In this report, with semi-empirical quantum method, we have studied the conformation and energy of supermolecule composed of picolinamide and its positional isomers with methacrylic acid. We tried to explore the reason why picolinamide was not likely to show imprinting effect when using methacrylic acid as functional monomer in our previous work. In order to produce imprinting effect, which was not achieved based on hydrogen bonding interaction, we have synthesized a molecular-imprinted polymer (MIP) based on copper ion coordination in prepolymerization. The complex in prepolymerization was composed of copper(II), acetate, picolinamide and 4-vinylpyridine (4-Vpy). Suprisingly, the MIP had high selectivity to picolinamide-copper acetate complex, and changes of either copper ion, picolinamide or acetate would result in decrease in the imprinting effect. This is also the first example where the high selective recognition of the MIP to its template was achieved mainly by inhibiting the binding of non-template rather than enhancing the binding of the template. And this report can be also looked upon as a first step towards the solution to the problem of imprinting of template that contains intramolecular hydrogen bond.     

Experimental study of photocatalytic oxidation of formaldehyde and its by-products

Formaldehyde is one of the most harmful pollutants that endanger occupants' health and the way of its effective removal has become a focus in the field of air quality. This paper studies the static photocatalytic removal of formaldehyde experimentally and finds out that carbon monoxide, which is more harmful to occupants' health than the formaldehyde itself, is one of the by-products in the process of photocatalytic oxidation of formaldehyde. The increase of carbon monoxide concentration should be taken into consideration in the photocatalytic application. The photocatalyst surface at room temperature can weakly adsorb CO and CO₂, which can deactivate the photocatalysts.     

套索冠醚毛细管色谱柱的研制

用套索冠醚N,N′-双(2-甲基吡啶)-二氮杂-18-冠-6作为固定相,涂渍在弹性石英毛细管内,测其柱效、惰性、热稳定性、平均极性及选择性等性质.其结构由元素分析、红外光谱、核磁共振及质谱分析的试验数据所证实.试验表明,它具有良好的色谱性能、中等极性,适用于对醇、卤代烃、芳香烃等各类异构体的分离,并用分子结构观点探讨了保留机理.