Rational Molecular Design towards Vis/NIR Absorption and Fluorescence by using Pyrrolopyrrole aza‐BODIPY and its Highly Conjugated Structures for Organic Photovoltaics

Pyrrolopyrrole aza‐BODIPY (PPAB) developed in our recent study from diketopyrrolopyrrole by titanium tetrachloride‐mediated Schiff‐base formation reaction with heteroaromatic amines is a highly potential chromophore due to its intense absorption and fluorescence in the visible region and high fluorescence quantum yield, which is greater than 0.8. To control the absorption and fluorescence of PPAB, particularly in the near‐infrared (NIR) region, further molecular design was performed using DFT calculations. This results in the postulation that the HOMO–LUMO gap of PPAB is perturbed by the heteroaromatic moieties and the aryl‐substituents. Based on this molecular design, a series of new PPAB molecules was synthesized, in which the largest redshifts of the absorption and fluorescence maxima up to 803 and 850 nm, respectively, were achieved for a PPAB consisting of benzothiazole rings and terthienyl substituents. In contrast to the sharp absorption of PPAB, a PPAB dimer, which was prepared by a cross‐coupling reaction of PPAB monomers, exhibited panchromatic absorption across the UV/Vis/NIR regions. With this series of PPAB chromophores in hand, a potential application of PPAB as an optoelectronic material was investigated. After identifying a suitable PPAB molecule for application in organic photovoltaic cells based on evaluation using time‐resolved microwave conductivity measurements, a maximized power conversion efficiency of 1.27 % was achieved.     

Dominant modes of submerged thin cylindrical shells

The relationship between the dominant mode of the submerged thin cylindrical shell and the flexural wave velocity is investigated. The natural frequency corresponding to the vibration mode is obtained as the solution of characteristic equation of thin cylindrical shell. However, it is difficult to estimate the dominant mode, especially if two or more vibration modes are involved. To estimate the dominant mode of a thin shell in vacuo, the concept of “modified bending stiffness” has been introduced. In this paper, the concept of modified bending stiffness is extended to estimate the dominant mode of a submerged thin cylindrical shell. The dominant mode of a submerged thin cylindrical shell is theoretically discriminated from the other mode based on the smallness of the modified bending stiffness of the submerged shell. The validity of our theory is confirmed by a good agreement between theoretical and experimental results on flexural wave velocity.     

Nonrelativistic limit in the energy space for nonlinear Klein-Gordon equations

We study the nonrelativistic limit of the Cauchy problem for the nonlinear Klein-Gordon equation and prove that any finite energy solution converges to the corresponding solution of the nonlinear Schr?dinger equation in the energy space, after the infinite oscillation in time is removed. We also derive the optimal rate of convergence in . Received: 13 July 2000 / Published online: 1 February 2002     

Results from GRACE/SUSY at one-loop

We report the recent development on the SUSY calculations with the help of GRACE system. GRACE/SUSY/1LOOP is the computer code which can generate Feynman diagrams in the MSSM automatically and compute one-loop amplitudes in the numerical way. We present new results of various two-body decay widths and chargino pair production at ILC (international linear collider) at one-loop level.      

Status of heavy element research using a gas-filled recoil separator at RIKEN

A gas-filled type of recoil separator for heavy element research was installed at an experimental hall of RIKEN Linear Accelerator facility to realize getting higher intensity of primary beam and long beam time. Performance of the separator was studied using target recoils and various nuclear reactions. The results show the high performance of the separator for heave element research. As an application of the GARIS, production and identification of an isotope of the 110th element ²⁷¹[110] have been performed using the ²⁰⁸Pb(⁶⁴Ni,1n)²⁷¹[110] reaction. Three decay chains coincide well both in decay times and energies with the ones reported by the group of SHIP experiment at GSI, Germany. Our results provide a confirmation of the synthesis of an isotope ²⁷¹[110] of element 110.     

DNA-conjugated polymers for self-assembled DNA chip fabrication.

We developed two DNA-conjugated polymers, one based on polyallylamine and the other on polyacrylic acid, for use in DNA chips. A 30-mer single-stranded DNA probe and thioctic acid were covalently attached to polyallylamine as sidechains. The same single-stranded DNA and 3-(pyridyldithio)propionyl hydrazide were covalently attached to polyacrylic acid as sidechains. Both DNA-conjugated polymers could be specifically immobilized onto a gold sensor substrate by a self-assembly technique. The interactions between fully matched DNA and each DNA-conjugated polymer were investigated by surface plasmon resonance. A gold surface modified with either DNA-conjugated polymer recognized fully matched DNA much better than unmatched DNA. The hybridization selectivity and efficiency of DNA-conjugated polyallylamine was optimized by adjusting the pH so as to reduce the effects of cationic polymer sidechains. The hybridization selectivity and efficiency of DNA-conjugated polymers were higher than those of a conventional immobilized thiol-based DNA. The coating of DNA-conjugated polymers reduced nonspecific adsorption of DNA by the gold substrate. DNA-conjugated polyacrylic acid was more selective toward fully matched DNA than was DNA-conjugated polyallylamine. Therefore, DNA-conjugated polymers show promise for application in novel DNA chips.     

Design and synthesis of labeling reagents (MS probes) for highly sensitive electrospray ionization mass spectrometry and their application to the detection of carbonyl, alcohol, carboxylic acid and primary amine samples.

Novel labeling reagents, called MS probes, which possess a positively charged quaternary amine moiety and can transform a neutral analyte into a charged compound by simply mixing with the analyte and allowing the mixture to stand from several minutes to 30 min at room temperature or while heating to 50 degrees C, were designed and synthesized for the highly sensitive detection of carbonyl, alcohol, carboxylic acid and primary amine samples by electrospray ionization mass spectrometry (ESI-MS). The positively charged products can be detected with high sensitivity in an ESI-MS system, which is the most popular liquid MS instrument. All of the labeled products showed a remarkably large increase in the molecular-ion peak abundance detection sensitivity of over 500-fold at picomolar concentration levels compared to that of unlabeled analytes in an ESI-MS system. These MS probes, used together with liquid MS detection, are widely applicable as a convenient method for the highly sensitive detection of less than picomolar levels of analytes, and therefore greatly enhance the power of ESI-MS analysis.     

An enrichment method of molybdenum on a cellulose nitrate resin for the determination by electrothermal atomic absorption spectrometry coupled with the resin suspension injection.

Cellulose derivative resin (CDR) suspensions containing resin particles of cellulose nitrate (CDR(CN)), cellulose acetate (CDR(CA)), or cellulose triacetate (CDR(CTA)) were prepared as the sorbent for resin suspension injection (RSI) electrothermal atomic absorption spectrometry (ETAAS), in which fine resin particles holding a desired trace element were directly injected into the graphite tube as the suspension. To compare the sorption ability, the distribution ratios of the Mo(VI)-phenylfluorone complex were measured between the aqueous phase and the sorbents, including the CDRs mentioned above and the finely divided anion exchange resin (AR). The results showed that the sorption ability decreases in the following order: CDR(CN) > or = AR > CDR(CA) > or = CDR(CTA). It was concluded that CDR(CN) was able to extract more than 98% of Mo(VI), and was suitable for RSI-ETAAS as well as AR. CDR(CN) was used for the determination of Mo in NIES certified reference materials, No. 10 Rice flour-unpolished; the results showed fairly good agreements between the analytical values and the certified values.     

Simultaneous determination of serotonin and 5-hydroxyindole-3-acetic acid in human urine by automated precolumn derivatization and semi-microbore column liquid chromatography with fluorescence detection.

An improved high-performance liquid-chromatographic (HPLC) assay for the simultaneous determination of serotonin (5-HT) and 5-hydroxyindole-3-acetic acid (5-HIAA) in human urine is reported. Following the automated precolumn derivatization of urinary 5-HT and 5-HIAA with benzylamine, the derivatives are separated by isocratic elution on a reversed-phase C18 semi-microbore column, and are fluorometrically detected at an excitation wavelength of 345 nm and an emission wavelength of 480 nm. The detection limits of 5-HT and 5-HIAA are 7 and 5 nmol/l in urine (0.7 and 0.5 fmol/20-microl injection). The proposed automatic method permits a highly selective and sensitive determination of 5-HT and 5-HIAA in human urine without any sample purification.