Application of gamma-ray spectrometry for the assay of uranium in crude UF4—An input material used for producing nuclear grade U-metal at the natural uranium conversion plants

A -spectrometric method has been developed for the assay of uranium in crude UF₄, which is used as a secondary source of input material for producing nuclear grade U-metal at natural uranium conversion plants. The method makes use of a NaI (Tl) detector coupled with a multichannel analyzer. The 1 MeV -ray of²³⁸U is used for calibration. A method for the fabrication of uniform -assay calibration standards is also suggested, based on the results of this investigation. The calibration standards were prepared by soaking the matrix in uranium solution and then drying the whole material. The amount of²³⁸U in the crude UF₄ sample was directly estimated by comparing the areas under the 1 MeV -ray peak of known calibration standards with the corresponding areas of the samples to be measured. 100 g each of the standard and the sample were counted. 5 crude UF₄ samples were analyzed by this method. The uranium contents in these samples were found to be in the range of 12.2–28.7 g. To compare the -ray spectrometry results with a completely independent method, chemical analysis by potentiometry of all the samples was also done. The -spectrometric results were found to agree within ±18% with the chemical analysis results.     

Controlling Lewis basicity in polythioarsenate fluxes: stabilization of KSnAsS(5) and K(2)SnAs(2)S(6). Extended chains and slabs based on pyramidal beta-[AsS(4)](3-) and [AsS(3)](3-) units

Two low-dimensional compounds, KSnAsS(5) and K(2)SnAs(2)S(6), were prepared using liquid polythioarsenate salts, and the results differ from those obtained with the well studied thiophosphate flux. KSnAsS(5) crystallizes in the orthorhombic space group Pbam with cell parameters of a = 8.136(2) A, b = 13.784(4) A, c = 7.428(2) A. KSnAsS(5) features the unusual pyramidal species [AsS(2)(S(2))](3-). K(2)SnAs(2)S(6) crystallizes in the trigonal space group P3 macro with cell parameters a = 6.717(5) A, b = 7.204(8) A, gamma = 120 degrees. The compounds were obtained by controlling the Lewis basicity of the K(2)S/As(2)S(3)/S flux. The optical, thermal, and spectroscopic properties of the compounds are reported.     

Phase transitions in thallous nitrate. A reinvestigation

A detailed reinvestigation of the phase transitions in thallous nitrate using DSC, X-ray, IR and optical microscopy has been undertaken. The DSC measurements on anhydrous samples show that the orthorhombic [OR] → hexagonal [HEX] transition sets in at 349 ± 1 K and peaks around 353 K. However, its intensity depends upon several factors such as particle size, moisture content and thermal history of the sample. The HEX→cubic [C] transition sets in around 405 K and shows two peaks at ～409 K and 413 K. Their relative intensities depend on the moisture content and thermal history of the sample. On cooling, the peaks show hysteresis and, by selective thermal cycling, the pairs of transitions, which correspond to the same process during heating and cooling, have been identified. IR spectra recorded in the OR and HEX phases at room temperature show that the symmetric stretching frequency (～1040 cm^?1) of the nitrate ion gets damped in the HEX phase. X-ray and optical microscopy data are in good agreement with the DSC observations.     

Recovery of plutonium and americium from laboratory acidic waste solutions using tri-n-octylamine and octylphenyl-N-N- diisobutylcarbamoylmethylphosphine oxide

Plutonium from acidic waste solutions has been recovered quantitatively using tri-n-octylamine (TnOA) in xylene and americium using a mixture of octylphenyl-N-N- diisobutylcarbamoylmethylphosphine oxide (CMPO) and TBP in dodecane by extraction and extraction chromatographic methods. The Pu ( IV ) TnOA species extracted into the organic phase from higher nitric acid concentrations has been confirmed as (R(3)NH)(2)Pu(NO(3))(6) (where R(3)N = TnOA by employing slope analysis as well as spectrophotometric studies.     

Spectrophotometric determination of ziram (dithiocarbamate fungicide) by thiocyanate and rhodamine 6G method

A sensitive spectrophotometric method has been developed for the determination of ziram in water, vegetables and grains. The method is based on the dissociation of dithiocarbamate complex of zinc with thiocyanate and rhodamine 6G at pH 4 to form a pink coloured complex that is stabilized by gelatin. The method is simple and Beer's law is obeyed over the concentration range of 0.05-1 ppm of ziram. The method is free from interference of similar dithiocarbamate fungicides containing Mn(2+) and Fe(3+) ions.