Interpretation of the polyelectrolyte and antipolyelectrolyte effects of poly(N‐vinylimidazole‐co‐sodium styrenesulfonate) hydrogels

Hydrogels of N‐vinylimidazole (VI) and sodium styrenesulfonate (SSS) were synthesized in aqueous solution by radical crosslinking copolymerization with N,N′‐methylene‐bis(acrylamide) as crosslinker. Swelling in several saline solutions was measured for hydrogel samples synthesized with different comonomer concentrations (C_T = 10, 25, or 40%) and with SSS mole fractions covering a broad range (f_SSS = 0–0.7), while the crosslinker ratio was 2 wt % in all cases. The degree of swelling in aqueous solution with a specific ionic strength (μ), plotted versus the SSS composition of the feed, shows a minimum for any set of samples synthesized with a fixed C_T. The dependence of swelling on μ shows both polyelectrolyte (f_SSS beyond the minimum) and antipolyelectrolyte behaviors (in the low f_SSS limit). It was found that the nonGaussian factor of the crosslinking density and the polymer‐solvent interaction parameter increase with f_SSS for any C_T. Moreover, in the low f_SSS limit, the osmotic swelling pressure is governed not only by the ionic contribution, but also by the polymer‐solvent mixing and, the concentration of mobile counterions inside the gel is not proportional to the net fixed charge but to the addition of cationic and anionic side groups, what discards the formation of ionic pairs. The antipolyelectrolyte effect is interpreted as due to the increasing protonation of VI as μ goes up. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1683–1693, 2007     

Preparation of antimicrobial poly(vinyl alcohol) nanofibers containing silver nanoparticles

Polyvinyl alcohol (PVA) nanofibers containing Ag nanoparticles were prepared by electrospinning PVA/silver nitrate (AgNO₃) aqueous solutions, followed by short heat treatment, and their antimicrobial activity was investigated for wound dressing applications. Since PVA is a water soluble and biocompatible polymer, it is one of the best materials for the preparation of wound dressing nanofibers. After heat treatment at 155 °C for 3 min, the PVA/AgNO₃ nanofibers became insoluble, while the Ag⁺ ions therein were reduced so as to produce a large number of Ag nanoparticles situated preferentially on their surface. The residual Ag⁺ ions were reduced by subsequent UV irradiation for 3 h. The average diameter of the Ag nanoparticles after the heat treatment was 5.9 nm and this value increased slightly to 6.3 nm after UV irradiation. It was found that most of the Ag⁺ ions were reduced by the simple heat treatment. The PVA nanofibers containing Ag nanoparticles showed very strong antimicrobial activity. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2468–2474, 2006     

Singlewall carbon nanotubes covered with polystyrene nanoparticles by in‐situ miniemulsion polymerization

This work is to make carbon nanotubes dispersible in both water and organic solvents without oxidation and cutting nanotube threads. Polystyrene‐singlewall carbon nanotube (PS‐SWNT) composites were prepared with three different methods: miniemulsion polymerization, conventional emulsion polymerization, and mixing SWNT with PS latex. The two factors, crosslinking and surface coverage of PS are important factors for the mechanical and electrical properties, including dispersion states of SWNT in various solvents. The PS‐SWNT composite prepared via a conventional emulsion polymerization showed SWNT bundles entirely covered with PS, whereas the PS‐SWNT composite prepared via a miniemulsion polymerization showed SWNT partially covered with crosslinked PS nanoparticles. The method of mixing SWNTs with PS latex did not show the well dispersed state of carbon nanotubes because PS was not crosslinked and was dissolved in a solvent, and nanotubes separated from PS precipitated. So the PS nanoparticle‐SWNT composite had lower electrical resistance, and higher mechanical strength than the other composites made by the latter two methods. As the amount of SWNT increases, the bare surface area of SWNT increases and the electrical conductivity increases in the composite made by the miniemulsion polymerization. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 573–584, 2006     

Zirconocene-mediated route to enantiopure 9-oxabicyclononanes functionalized on both carbon bridges

[reaction: see text] A zirconocene-mediated ring contraction of 4-vinylfuranosides generated either from d-arabinose or d-glucose is followed by sequential oxidation to the ketone and alkynyl Grignard addition. The resulting cis-cyclobutanediols are subjected in turn to thermal rearrangement and intramolecular oxymercuration-demercuration. The regiochemistry of the final ring closure is controlled by the nature of R.     

A new synthesis of 1,2,3,5‐tetrahydroimidazo[2,3‐b]‐[1,3]benzodiazocines

A new synthesis of 6‐carbomethoxy‐1,2,3,5‐tetrahydroirnidazo[2,3‐b][1,3]benzodiazocines 13 by the intramolecular cycloaddition reaction of methyl 2‐(1‐aziridinylmethyl)‐3‐(2‐ureidophenyl)propenoates 10 under Appel's dehydration conditions is described. The latter were readily obtained from 2‐nitrobenzalde‐hyde with methyl acrylate through the Baylis‐Hillman reaction.     

Synthesis and characterization of thermally crosslinkable hole‐transporting polymers for PLEDs

Two new thermally crosslinkable hole‐transporting polymers, X‐PTPA and X‐PCz, were synthesized via Yamamoto coupling reactions. The number‐averaged molecular weights (M_n) of X‐PTPA and X‐PCz were found to be 45,000 and 48,000, respectively, and therewith, polydispersity indices were of 1.8 and 1.7, respectively. Thermally crosslinked X‐PTPA and X‐PCz exhibit excellent solvent resistance and stable optoelectronic properties. The UV–visible maximum absorption peaks of X‐PTPA and X‐PCz in the thin film state are at 389 and 322 nm, respectively. The HOMO levels of X‐PTPA and X‐PCz are estimated to be ?5.27 and ?5.39 eV, respectively. Multilayered devices (ITO/crosslinked X‐PTPA or X‐PCz/SY‐PPV/LiF/Al) were fabricated with SY (SuperYellow) as the emitting layer. The maximum efficiency of the multilayered device with a crosslinked X‐PTPA layer is approximately three times higher than that of the device without a crosslinked X‐PTPA layer and much higher than that of the crosslinked X‐PCz device. This result can be explained by the observations that crosslinked X‐PTPA produces increased electron accumulation within the emitter, SY, and also efficient exciton formation due to improved charge balance. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2013 , 51, 5111–5117     

Exchange coupled magnetic nanocomposites of Sm(Co1−xFex)5 / Fe3O4 with core/shell structure

Magnetic nanocomposites of Sm(Co_1−xFe_x)₅/Fe₃O₄ (x≈0.1) with the core/shell type structure were successfully fabricated using a two-step polyol process, where as-prepared SmCo_5(1−x) nanoparticles were used as seeds for the ferrite coating. The core/shell composites are quite stable in air and show a typical hysteric behavior of single component, yielding an enhanced coercivity of 2.2 kOe with a saturated magnetization of 130 emu/g at 5 T. The magnetization data clearly reveal the presence of effective exchange coupling between the hard-magnetic Sm(Co_1−xFe_x)₅ core and soft-magnetic Fe₃O₄ shell, suggestive of a single-phase structure rather than a distinctive two-phase one.     

The SN3–SN2 spectrum. Rate constants and product selectivities for solvolyses of benzenesulfonyl chlorides in aqueous alcohols

Rate constants for a wide range of binary aqueous mixtures and product selectivities (S) in ethanol–water (EW) and methanol–water (MW) mixtures, are reported at 25 °C for solvolyses of benzenesulfonyl chloride and the 4‐chloro‐derivative. S is defined as follows using molar concentrations: S = ([ester product]/[acid product]) × ([water solvent]/[alcohol solvent]). Additional selectivity data are reported for solvolyses of 4‐Z‐substituted sulfonyl chlorides (Z = OMe, Me, H, Cl and NO₂) in 2,2,2‐trifluoroethanol–water. To explain these results and previously published data on kinetic solvent isotope effects (KSIEs) and on other solvolyses of 4‐nitro and 4‐methoxybenzenesulfonyl chloride, a mechanistic spectrum involving a change from third order to second order is proposed. The molecularity of these reactions is discussed, along with new term ‘S_N3–S_N2 spectrum’ and its connection with the better established term ‘S_N2–S_N1 spectrum’. Copyright © 2009 John Wiley & Sons, Ltd.     

The use of vibrational spectroscopy to study the pathogenesis multiple sclerosis and other neurological conditions

Spectroscopy techniques are valuable tools in biomedical research and have been used extensively in the study of disease. However, neurological conditions such as multiple sclerosis (MS) have received little attention and the available spectroscopy studies are limited, both in overall numbers of patients studied and the disease samples considered. MS is a complex immune-mediated disease, with variable clinical courses and limited therapeutic options. This review aims to summarize current literature in the area, demonstrating how spectroscopy techniques can provide valuable information to inform and advance research into the most common neurological condition affecting young adults.