束流线性耦合效应的初步研究

在储存环的束流传输系统中,斜四极场和纵向螺线管场是引起束流线性耦合的主要原因.由于这种耦合,使得束流的幅度和发射度发生交换,引起束流横向包络的增大,严重的将造成束流损失.从Betatron运动方程出发研究了斜四极场和螺线管场存在时束流的幅度耦合效应,分析了斜四极场存在时束流发射度的变化.     

Nanoparticle composites: FePt with wide-band-gap semiconductor

We present a simple way to synthesize FePt and ZnO (wide-band-gap semiconductor) nanoparticle composites. The FePt nanoparticles were fabricated using the method reported by Sun et al. By controlling the heating rate, 3 nm FePt nanoparticles were synthesized. Well-dispersed FePt and ZnO nanoparticle composites were prepared by further adding zinc acetate and oleyl amine into the 3 nm FePt nanoparticle dispersion. By controlling the molar ratio of the FePt and zinc acetate, FePt and ZnO nanoparticle composites with different FePt particle fractions were obtained. The intensity of photo luminescence spectra of the nanoparticle composites increases very much with decreasing FePt particle fraction, whereas the peak position shifts a little. After annealing at 550 °C for half an hour, the nanoparticle composites become magnetically hard or semi-hard with coercivity much dependent on the FePt particle volume fraction. The coercivity of the composites increases with annealing temperature. The composites hold the promise of applications in new generation recording and/or optical devices.     

Vacuum Fluctuations and Motion of a Charged Test Particle in a Cylindrical Spacetime

The effects of quantum electromagnetic fluctuations upon the motion of a test charged particle are examined in a cylindrical spacetime in which one spatial is compactified. The mean squared fluctuations in the velocity and position of the test particle are calculated. It is found that the random motion of the test particle will be anisotropic. The possible consequences for theories with extra compactified spatial dimensions are discussed.     

ECR-SFC轴向注入系统聚束器效率的研究

为了减少目前SFC轴向注入系统中聚束器杂散电场对束流轴向注入效率的影响, 提高新系统中SFC的束流俘获效率, 参考原始设计, 对目前聚束器的电极结构进行了设计改进. 两种情况下的聚束器杂散场对注入效率影响的计算表明, 改进后0B02的聚束效率较目前有较大提高. 同时计算了束流空间电荷效应对聚束效率的影响, 据此对新SFC轴向注入系统中聚束器的位置进行了重新调整.     

配合物形成的三维超分子体系—[Ni(C_6H_4O_2N)_2(H_2O)_4]的水热法合成、晶体结构及热分析

采用水热法用Ni(NO3)26H2O和异烟酸制备出了一种新的由配合物形成的三维超分子体系—[Ni(C6H4O2N)2(H2O)4],并通过X射线衍射对其晶体结构进行了测定。 该晶体属三斜晶系,空间群为Pī, 所得晶胞参数为: a = 6.9228(4), b = 9.6664(19),c = 6.322(1) , a = 96.86(3), b = 113.33(3), g = 110.35(3)°, V = 347.6(1) 3, Z = 1, Mr = 374.98, Dc = 1.791 g/cm3, F(000) = 194, m = 1.443 mm-1。用1362个可观察的 (I > 2s(I))衍射点,修正123个结构参数, 最终偏离因子R = 0.0444,wR = 0.1271。在组成该化合物的基本结构单元[Ni(C6H4O2N)2(H2O)4]中,Ni处于1个稍微拉长的八面体的中心; 各个结构单元之间通过氢键OH…O相互连接,形成了无限伸展的具有层状结构的三维超分子体系。 另外,从差热及热重曲线可以看出,该化合物加热到154 ℃时开始分解, 首先失去4个H2O,再失去2个异烟酸根,最后残余物为NiO。     

低共熔混合锂盐相图的绘制及应用

采用热分析法对不同组成的混合锂盐二元体系进行研究, 绘制了混合锂盐体系的步冷曲线和T-x相图, 结果表明体系均为具有最低共熔点的二元体系. LiOH-LiNO3、LiOH-LiCl、LiOH-Li2CO3及LiNO3-LiCl体系的最低共熔点分别为175.7、294.5、418.2及221.6 ℃. 利用低共熔混合物LiNO3-LiOH为锂盐与不同前驱体反应, 制备出了层状结构良好的锂离子电池正极材料LiNiO2、LiNi0.8Co0.2O2及LiNi1/3Co1/3Mn1/3O2. X射线衍射分析表明, 合成的材料具有规整的层状NaFeO2结构, 且XRD衍射峰强度之比I(003)/I(104)>2.0, 电性能测试表明, 在2.7-4.3 V(vs Li/Li+)的电压范围内进行0.1C倍率充放电, LiNiO2、LiNi0.8Co0.2O2、LiNi1/3Co1/3Mn1/3O2首次充电比容量分别达168.0、225.4、194.0 mAh·g-1, 放电比容量分别为138.4、165.8、157.7 mAh·g-1.     

Solid state synthesis and structure of two novel polyoxometalates [(n-Bu)4N]4[M6O19][Ag2I4](M?Mo,W)†

The reaction of [NH₄]₂[MO₂S₂], AgI and (n-Bu)₄NBr in solid state produced the polyoxometalates [(n-Bu)₄N]₄[M₆O₁₉][Ag₂I₄] (1, M? Mo; 2, M? W) which were structurally determined. The crystals of 1 and 2 are isomorphous, monoclinic, space group P2₁/c. 1, a = l.6624(2), b=1.6699(3), c=l.7217(2) nm, β=98.29(1)°, V=4.729(1) nm³, Z=2, R=0.040, R_w“0.037; 2, a = 1.6636(3), b = 1.6733(3), c = 1.7190(3) nm, β=98.25(1)°, V=4.736(l) nm³, Z = 2, R = 0.038, R_w = 0.047. The results of the structure determination showed that the two compounds had the same structures whose skeletons are composed of [Ag₂I₄]². and [M₆O₁₉]^2-. The difference of them and heteropolymetalate compounds synthesized in solution is that the title compounds contain cluster. ion, heteropolymetalate and organic cations, while the latter is only composed of heteropolymetalate and organic cations.     

F-T合成Fe/Cu/K/Al2O3催化剂的结构性质、还原及碳化行为

采用连续共沉淀与喷雾干燥成型技术相结合的方法制备了微球状Fe/Cu/K/Al2O3催化剂, 结合TG、N2物理吸附、XRD、H2-TPR、CO-TPR、Mossbauer谱等表征手段, 研究焙烧温度对Fischer-Tropshc (F-T)合成铁基催化剂的结构性质、还原行为和碳化行为的影响. 结果表明, 较高的焙烧温度有利于碳酸盐的分解和结晶水的脱除, 促进了催化剂的还原. 随着焙烧温度的进一步升高, 催化剂的比表面积减小, 平均孔径增大, α-Fe2O3晶粒的粒径增大, 催化剂中金属与载体的相互作用增强, 从而削弱了CuO、K2O助剂的作用, 严重抑制了催化剂的还原和碳化.     

时间分辨激光光散射测量系统

自选设计，装配了一套时间分辨的激光光散射测量系统，该系统摄像机，录像机，计算机和自编的软件实现了一体化的数据采集，显示和分析过程，本文给出了该系统的应用实例，球晶的光散射和环氧树脂的固化反应诱导的相分离过程。     

Synthesis and Crystal Structure of Ag2（admtrz）2（CF3CO2）2（admtrz=4—amino—3,5—dimethyl—1,2,4—triazole）

1 INTRODUCTION Transition metal complexes bridged by 1, 2, 4-triazole group can produce interesting structures and specific properties[1]. Many attempts have been made to synthesize a variety of complexes with paramagnetic centers by using such ligands, and their structures and magnetic properties have been characterized[2]. However, the polynuclear Ag(I) complexes bridged by 1, 2, 4-triazole have been poorly studied[3]. Recently, we have prepared a series of silver(I) triazole complex…